Catering Cafeteria style of serving meals will be acceptable, providing dishes are carried back by the Culinary Staff. The food shall be of good quality and have the approval of the Camp Committee of the Building and Construction Trades Council of Ontario. There shall be sufficient housekeeping staff supplied by the Culinary Workers to keep the bunkhouses clean, and beds shall be made up each day by such staff. Kitchen facilities, equipment and food supplies shall be subject to inspection by the duly authorized Camp Committee at any and all times and further all grievances shall be dealt with by said Committee.
Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.
Green Economy/Carbon Footprint a) The Supplier/Service Provider has in its bid provided Transnet with an understanding of the Supplier’s/Service Provider’s position with regard to issues such as waste disposal, recycling and energy conservation.
Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.
Procurement of Goods and Services (a) If the HSP is subject to the procurement provisions of the BPSAA, the HSP will abide by all directives and guidelines issued by the Management Board of Cabinet that are applicable to the HSP pursuant to the BPSAA.
(b) If the HSP is not subject to the procurement provisions of the BPSAA, the HSP will have a procurement policy in place that requires the acquisition of supplies, equipment or services valued at over $25,000 through a competitive process that ensures the best value for funds expended. If the HSP acquires supplies, equipment or services with the Funding it will do so through a process that is consistent with this policy.
Goods and Services 4.3.1. The Supplier shall ensure that the Goods and/or the Services provided are fit for the purposes that may reasonably be inferred from the technical specifications and in accordance with the timetable for performance defined in the Contract. In any event the Supplier commits himself to achieve performance and results stipulated in the Contract.
4.3.2. The Goods and/or Services shall be delivered in a state of full completion with the complete “Documentation” (any operation and maintenance manuals, drawings, calculations, technical data, logic diagrams, progress reports, quality documentation, conformity certificates, test reports, bill of lading, certificates of origin, export control classification list number as per any applicable export regulation - such as the European Council Regulation 428/2009 (as amended) and/or the U.S. Export Administration Regulations (“EAR”), percentage of U.S. origin content, U.S. Export Control Classification Number (“ECCN”) or U.S. Munitions List category (“USML”) (if applicable) export authorizations and licenses, Harmonized Tariff Code - and any such other documents required under the Contract and/or applicable Laws) associated therewith as well as all instructions, recommendationsandother indicationsnecessaryin orderfor themtobeused correctly and under the appropriate safety conditions. If so required by the Purchaser, the Supplier shall submit any such Documentation to the Purchaserwith sufficient timeforreview andapproval by the Customer, in accordancewith the time-lines agreed between the Purchaser and the Customer. Where the Documentation provided by the Supplier is not compliant with Purchaser’s contractual requirements, the Supplier must make the necessary modifications, and indemnify the Purchaser for any costs, liabilities or penalties incurred by the Purchaser as a result of the non-compliance and/or delay.
4.3.3. Goods or Services that donotmeetall the requirements set in this Article 4.3 shall be considered as having a Non-Conformity as per Article 10 of these General Conditions and may be recorded as a non-conformity event (NCE) as defined in the Supplier Quality Manual.
4.3.4. If the Supplier is not certain that the results of the Services or Goods comply with the requirements defined in this Article 4.3, it shall inform immediately the Purchaser thereof in writing, providing all the needed indications concerning the risks of non- compliance and the measures that the Supplier intends to take in order to remedy the situation. The Purchaser shall notify its acceptance or rejection of the Supplier’s proposals as soon as possible and in writing.
4.3.5. If the Purchaser assesses on its part that the Supplier is not performing the Services and/or supplying the Goods in accordance with the Contract, itmay require the Supplier to indicate to it, in writing, the measures that the Supplier intends to take to remedy the situation. The Purchaser shall notify the Supplier in writing as soon as possible of its acceptance or rejection of the Supplier’s proposals.
Dewatering (a) Where the whole of a site is so affected by surface water following a period of rain that all productive work is suspended by agreement of the Parties, then dewatering shall proceed as above with Employees so engaged being paid at penalty rates as is the case for safety rectification work. This work is typically performed by Employees engaged within CW1, CW2 or CW3 classifications. When other Employees are undertaking productive work in an area or areas not so affected then dewatering will only attract single time rates.
(b) Where a part of a site is affected by surface water following a period of rain, thus rendering some areas unsafe for productive work, consistent with the Employer’s obligations under the OH&S Act, appropriate Employees shall assist in the tidying up of their own work site or area if it is so affected. Where required, appropriate Employees will be provided with the appropriate PPE. Such work to be paid at single time rates. Productive work will continue in areas not so affected.
(c) To avoid any confusion any ‘dewatering’ time which prevents an Employee from being engaged in their normal productive work is not included in any calculation for the purposes of determining whether an Employee is entitled to go home due to wet weather (refer clauses 32.4 and 32.5)
Alcoholic Beverages Costs of alcoholic beverages are unallowable.
Blasting Blasting shall be permitted only for road construction purposes unless advance permission is obtained from Forest Service. Whenever the Industrial Fire Precaution Level is II or greater, a fire security person equipped with a long handled round point No. 0 or larger shovel and a 5 gallon backpack pump can filled with water, will stay at location of blast for 1 hour after blasting is done. Blasting may be suspended by Forest Service, in areas of high rate of spread and resistance to control. Fuses shall not be used for blasting. Explosive cords shall not be used without permission of Forest Service, which may specify conditions under which such explosives may be used and precautions to be taken.
Procurement Standards For projects being managed by the Local Government and on the State highway system or that include state funding, the Local Government must obtain approval from the State for its proposed procurement procedure for the selection of a professional services provider, a contractor for a construction or maintenance project, or a materials provider.
