Clean and Polish Interior Glass, Mirrors, and Glass/Mirrored Surfaces Sample Clauses

Clean and Polish Interior Glass, Mirrors, and Glass/Mirrored Surfaces. The cleaning of glass and mirrors includes all glass partitions, walls, doors, mirrors and adjacent trim with a lower edge below seven feet. Glass that extends higher than seven feet shall not be included. After glass cleaning, there shall be no traces of film, dirt, smudges, water or other foreign matter. Both sides of glass partitions, walls and doors are to be cleaned.
AutoNDA by SimpleDocs

Related to Clean and Polish Interior Glass, Mirrors, and Glass/Mirrored Surfaces

  • Carpet Cleaning Shampooing carpets with the deep dirt extraction (steam cleaning) method per manufactures recommendations.

  • Insurance, Subcontractor's Public Liability and Property Damage The Contractor shall require each of its subcontractors to secure and maintain during the life of the subcontract, insurance of the type specified in this Contract, or, the Contractor may insure the activities of its subcontractors in the Contractor’s policy, as specified in this Contract.

  • Cleaning 8.1 CONTRACTOR shall, at his own expenses, at all times keep the premises free from accumulation of debris, waste materials, and rubbish, and at the completion of the work, he shall remove his tools and equipment and all surplus materials, debris, waste material, and rubbish and shall leave the premises in a neat and clean condition. If CONTRACTOR does not attend to such cleaning immediately upon request, OWNER shall have the right to have this work done by others and deduct the cost therefore from the payment due CONTRACTOR hereunder.

  • Illumination The Engineer shall refer to TxDOT’s Highway Illumination Manual and other deemed necessary State approved manuals for design of continuous lighting and safety lighting for all conventional, high-mast, and underpass lighting. The Engineer shall include safety lighting as part of each design on each flashing beacon and traffic signal. The Engineer shall provide a preliminary layout for initial review and approval by the State. The Engineer shall prepare circuit wiring diagrams showing the number of luminaries on each circuit, electrical conductors, length of runs, service pole assemblies. Underpass lighting must be used on all structures within each project. The Engineer shall integrate existing illumination within the project limits into the proposed design. The Engineer shall coordinate with the State to determine the location of proposed high-mast, conventional, and underpass lighting.

Time is Money Join Law Insider Premium to draft better contracts faster.