COMPLIANCE WITH SAFETY AND EMISSION CONTROL REQUIREMENTS Sample Clauses

COMPLIANCE WITH SAFETY AND EMISSION CONTROL REQUIREMENTS. DEALER agrees to comply and operate consistently with all applicable provisions of the National Traffic and Motor Vehicle Safety Act of 1966, and the Federal Clean Air Act, as amended, including applicable rules and regulations issued from time to time thereunder, and all other applicable federal, state, and local motor vehicle safety and emission control statutes, rules, and regulations. In the event that the laws of the state in which DEALER is located require motor vehicle dealers or distributors to install in new or used motor vehicles, prior to their retail sale, any safety devices or other equipment not installed or supplied as standard equipment by PORSCHE AG, then DEALER, prior to the sale of any Porsche vehicle on which such installations are required, shall properly install such devices or equipment on such Porsche vehicles. DEALER shall comply with state and local laws pertaining to the installation and reporting of such equipment. Porsche agrees to pay DEALER for all parts and/or other materials required and used in connection with such work and for labor according to the procedures and rates established from time to time by Porsche, and in accordance with applicable law. In the interest of motor vehicle safety and emission control, Porsche and DEALER agree to provide to each other such information and assistance as may reasonably be requested by the other in connection with the performance of obligations imposed on either party by the National Traffic and Motor Vehicle Safety Act of 1966, and the Federal Clean Air Act, as amended, and their rules and regulations, and all other applicable federal, state and local motor vehicle safety and emissions control statutes, rules and regulations.
Sample 1Sample 2Sample 3See All (11)
AutoNDA by SimpleDocs
COMPLIANCE WITH SAFETY AND EMISSION CONTROL REQUIREMENTS. DEALER agrees to comply and operate consistently with all applicable provisions of the National Traffic and Motor Vehicle Safety Act of 1966 and the Federal Clean Air Act, as amended, including applicable rules and regulations issued from time to time thereunder, and all other applicable federal, state and local motor vehicle safety and emission control statutes, rules and regulations. In the event that the laws of the state in which DEALER is located require motor vehicle dealers or distributors to install in new or used motor vehicles, prior to their retail sale, any safety devices or other equipment not installed or supplied as standard equipment by FACTORY, then DEALER, prior to the sale of any LEXUS Motor Vehicle on which such installations are required, shall properly install such devices or equipment on such LEXUS Motor Vehicles. DEALER shall comply with state and local laws pertaining to the installation and reporting of such equipment. In the interest of motor vehicle safety and emission control, DISTRIBUTOR and DEALER agree to provide to each other such information and assistance as may reasonably be requested by the other in connection with the performance of obligations imposed on either party by the National Traffic and Motor Vehicle Safety Act of 1966 and the Federal Clean Air Act, as amended, and their rules and regulations, and all other applicable federal, state and local motor vehicle safety and emissions control statutes, rules and regulations.
Sample 1Sample 2
COMPLIANCE WITH SAFETY AND EMISSION CONTROL REQUIREMENTS. Dealer agrees to comply and operate consistently with all applicable provisions of the National Traffic and Motor Vehicle Safety Act of 1966, and the Federal Clean Air Act, as amended, including applicable rules and regulations issued from time to time thereunder, and all other applicable federal, state, and local motor vehicle safety and emission control statutes, rules, and regulations. In the event that the laws of the state in which Dealer is located require motor vehicle dealers or distributors to install in new or used motor vehicles, prior to their sale, any safety devices or other equipment not installed or supplied as standard equipment by DCAG, then Dealer, prior to the sale of any Maybach Passenger Car on which such installations are required, shall properly install such devices or equipment on such Maybach Passenger Cars. Dealer shall comply with state and local laws pertaining to the installation and reporting of such equipment. In the interest of motor vehicle safety and emission control, MBUSA and Dealer agree to provide to each other such information and assistance as may reasonably be requested by the other in connection with the performance of obligations imposed on either party by the National Traffic and Motor Vehicle Safety Act of 1966, and the Federal Clean Air Act, as amended, and their rules and regulations, and all other applicable federal, state and local motor vehicle safety and emission control statutes, rules and regulations. Dealer further agrees that should MBUSA place any new Maybach Passenger Cars in Dealer's stock on retail hold pending the resolution of any federal or state regulatory compliance issue, MBUSA may, but shall not be required to, elect to repurchase said retail held Maybach Passenger Cars. Should MBUSA so elect, Dealer agrees that it shall immediately sell the Maybach Passenger Cars back to MBUSA and withhold from retail sale all such Maybach Passenger Cars still in its inventory at the time of said election as MBUSA may reasonably determine. In the event of such a repurchase, the price to be paid by MBUSA to Dealer shall be only the price paid by the Dealer to MBUSA for said Maybach Passenger Car. MBUSA shall not be obligated to reimburse any other costs to Dealer with respect to Dealer's purchase or MBUSA's repurchase of the Maybach Passenger Cars. MBUSA shall make payment to the Dealer immediately upon transfer of title to the Maybach Passenger Car to MBUSA. During the period from MBUSA's repurchase of May...
Sample 1Sample 2

Related to COMPLIANCE WITH SAFETY AND EMISSION CONTROL REQUIREMENTS

  • COMPLIANCE WITH HEALTH, SAFETY, AND ENVIRONMENTAL REGULATIONS The Contractor, it’s Subcontractors, and their respective employees, shall comply fully with all applicable federal, state, and local health, safety, and environmental laws, ordinances, rules and regulations in the performance of the services, including but not limited to those promulgated by the City and by the Occupational Safety and Health Administration (OSHA). In case of conflict, the most stringent safety requirement shall govern. The Contractor shall indemnify and hold the City harmless from and against all claims, demands, suits, actions, judgments, fines, penalties and liability of every kind arising from the breach of the Contractor’s obligations under this paragraph.

  • COMPLIANCE WITH SEC RULES If, at any time during which AVIF is serving as an investment medium for variable life insurance Contracts, 1940 Act Rules 6e-3(T) or, if applicable, 6e-2 are amended or Rule 6e-3 is adopted to provide exemptive relief with respect to Mixed and Shared Funding, AVIF agrees that it will comply with the terms and conditions thereof and that the terms of this Section 5 shall be deemed modified if and only to the extent required in order also to comply with the terms and conditions of such exemptive relief that is afforded by any of said rules that are applicable.

  • Compliance with Procurement Laws This Contract is the result of compliance with applicable procurement laws of the State of Texas. DIR issued a solicitation on the Comptroller of Public Accounts’ Electronic State Business Daily, Request for Offer (RFO) DIR-TSO-TMP-225, on February 27, 2015, for Software, including Software as a Service, Products and Related Services. Upon execution of this Contract, a notice of award for RFO DIR-TSO-TMP-225 shall be posted by DIR on the Electronic State Business Daily.

  • Compliance with Texas Privacy Laws and Regulations In performing their respective obligations under the Agreement, the LEA and the Provider shall comply with all Texas laws and regulations pertaining to LEA data privacy and confidentiality, including but not limited to the Texas Education Code Chapter 32, and Texas Government Code Chapter 560.

  • Compliance with Governmental Requirements Comply with all laws, ordinances, and regulations, now or hereafter in effect, of all governmental authorities applicable to the conduct of Borrower’s properties, businesses and operations, and to the use or occupancy of the Collateral, including without limitation, the Americans With Disabilities Act. Borrower may contest in good faith any such law, ordinance, or regulation and withhold compliance during any proceeding, including appropriate appeals, so long as Borrower has notified Lender in writing prior to doing so and so long as, in Lender’s sole opinion, Lender’s interests in the Collateral are not jeopardized. Lender may require Borrower to post adequate security or a surety bond, reasonably satisfactory to Lender, to protect Lender’s interest.

  • Certification of Compliance with the Energy Policy and Conservation Act When appropriate and to the extent consistent with the law, Vendor certifies that it will comply with the Energy Policy and Conservation Act (42 U.S.C. 6321 et seq; 49 C.F.R. Part 18) and any mandatory standards and policies relating to energy efficiency which are contained in applicable state energy conservation plans issued in compliance with the Act. Does Vendor agree? Yes

  • Compliance with Rules To comply with, and to require the Contractors to comply with, all rules, regulations, ordinances and laws bearing on the conduct of the work on the Improvements, including the requirements of any insurer issuing coverage on the Project and the requirements of any applicable supervising boards of fire underwriters.

  • Compliance with Governmental Regulations Landlord and Tenant shall comply with all rules, regulations and requirements promulgated by national, state or local governmental agencies or utility suppliers concerning the use of utility services, including any rationing, limitation or other control. Tenant shall not be entitled to terminate this Lease nor to any abatement in rent by reason of such compliance.

  • Compliance with Regulations The contractor (hereinafter includes consultants) will comply with the Acts and the Regulations relative to Non-discrimination in Federally-assisted programs of the U.S. Department of Transportation, Federal Highway Administration, as they may be amended from time to time, which are herein incorporated by reference and made a part of this contract.

  • Compliance with Environmental Requirements 50.1 The Contractor shall provide the goods and/or Services required under the Contract in accordance with applicable laws and the Authority’s environmental policy, which is to conserve energy, water and other resources, reduce waste and phase out the use of ozone depleting substances and minimise the release of greenhouse gases, volatile organic compounds and other substances damaging to health and the environment. 50.2 The Authority is committed to promoting a low carbon, high growth, global economy. The Contractor shall work with the Authority regarding any environmental or sustainability issues as the Authority considers relevant, comply with contractual obligations and carry out any reasonable request to ensure the protection of the environment, society and the economy and promotion of sustainable development and sustainable procurement throughout the Contract Period. 50.3 All written outputs, including reports, produced in connection with the Contract shall (unless otherwise specified) be produced on recycled paper containing at least 80% post consumer waste and used on both sides where appropriate. 50.4 Nothing in this Condition 50 shall relieve the obligations of the Contractor to comply with its statutory duties and Good Industry Practice.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!