Crossing Arm Sample Clauses

Crossing Arm. 19.15.1. School buses shall be equipped with a crossing control arm mounted on the right side of the front bumper. 19.15.2. When opened, this arm shall extend in a line parallel to the body side and aligned with the right front wheel. 19.15.3. The crossing control arm shall be constructed of non-corrodible or nonferrous material or shall be treated in accordance with the body sheet metal specification. 19.15.4. The crossing control arm shall extend a minimum of 70 inches (measured from the bumper at the arm assembly attachment point) when in the extended position. 19.15.5. The crossing control arm shall not extend past the end of the bumper when in the stowed position. 19.15.6. Crossing arms are not required by the Federal Motor Vehicle Safety Standards (FMVSS) for School Buses. Regulations for cross arm equipment and use may vary widely on a state-by- state basis. When ordering a school bus, the Contractor and Purchaser must review and apply the appropriate State standards for crossing arms.
AutoNDA by SimpleDocs
Crossing Arm. 12.1. School buses shall be equipped with a crossing control arm mounted on the right side of the front bumper. 12.2. When opened, this arm shall extend in a line parallel to the body side and aligned with the right front wheel. 12.3. The crossing control arm shall be constructed of non-corrodible or nonferrous material or shall be treated in accordance with the body sheet metal specification. 12.4. The crossing control arm shall extend a minimum of 70 inches (measured from the bumper at the arm assembly attachment point) when in the extended position. 12.5. The crossing control arm shall not extend past the end of the bumper when in the stowed position. 12.6. Crossing arms are not required by the Federal Motor Vehicle Safety Standards (FMVSS) for School Buses. Regulations for cross arm equipment and use may vary widely on a state-by-state basis. When ordering a school bus, the Contractor and Purchaser must review and apply the appropriate State standards for crossing arms. 12.7. Electric Solid-State Upgrade, w/plastic rod: Electric upgrade to solid state electronics. (No heater required) 12.8. Air w/plastic rod: The electric unit shall be replaced with an air-operated unit.

Related to Crossing Arm

  • Loop A transmission path that extends from a Main Distribution Frame or functionally comparable piece of equipment in a Customer's serving End Office, to the Rate Demarcation Point (or NID if installed at the Rate Demarcation Point) in or at the Customer's premises. The actual transmission facilities used to provide a Loop may utilize any of several technologies.

  • Dark Fiber Loop 2.8.4.1 Dark Fiber Loop is an unused optical transmission facility, without attached signal regeneration, multiplexing, aggregation or other electronics, from the demarcation point at an End User’s premises to the End User’s serving wire center. Dark Fiber Loops may be strands of optical fiber existing in aerial or underground structure. BellSouth will not provide line terminating elements, regeneration or other electronics necessary for AFN to utilize Dark Fiber Loops.

  • Data Services In lieu of any other rates or discounts, the Customer will receive a discount equal to 20% for the following Data Services: Access: Standard VBS3Guide local loop charges for DS-0, DS-1 and DS-3 Access Service.

  • STATEWIDE CONTRACT MANAGEMENT SYSTEM If the maximum amount payable to Contractor under this Contract is $100,000 or greater, either on the Effective Date or at any time thereafter, this section shall apply. Contractor agrees to be governed by and comply with the provisions of §§00-000-000, 00-000-000, 00-000-000, and 00- 000-000, C.R.S. regarding the monitoring of vendor performance and the reporting of contract information in the State’s contract management system (“Contract Management System” or “CMS”). Contractor’s performance shall be subject to evaluation and review in accordance with the terms and conditions of this Contract, Colorado statutes governing CMS, and State Fiscal Rules and State Controller policies.

  • Notice to Centrelink Where a decision has been made to terminate the employment of employees, the employer shall notify Centrelink thereof as soon as possible giving relevant information including the number and categories of the employees likely to be affected and the period over which the terminations are intended to be carried out.

  • Agreement with Respect to Leased Data Processing Equipment (a) The Receiver hereby grants to the Assuming Bank an exclusive option for the period of ninety (90) days commencing the day after Bank Closing to accept an assignment from the Receiver of any or all Data Processing Leases to the extent that such Data Processing Leases can be assigned. (b) The Assuming Bank shall (i) give written notice to the Receiver within the option period specified in Section 4.7(a) of its intent to accept or decline an assignment or sublease of any or all Data Processing Leases and promptly accept an assignment or sublease of such Data Processing Leases, and (ii) give written notice to the appropriate lessor(s) that it has accepted an assignment or sublease of any such Data Processing Leases. (c) The Receiver agrees to facilitate the assignment or sublease of Data Processing Leases or the negotiation of new leases or license agreements by the Assuming Bank; provided, that neither the Receiver nor the Corporation shall be obligated to engage in litigation or make payments to the Assuming Bank or to any third party in connection with facilitating any such assumption, assignment, sublease or negotiation. (d) The Assuming Bank agrees, during its period of use of any property subject to a Data Processing Lease, to pay to the Receiver or to appropriate third parties at the direction of the Receiver all operating costs with respect thereto and to comply with all relevant terms of the applicable Data Processing Leases entered into by the Failed Bank, including without limitation the timely payment of all rent, taxes, fees, charges, utilities, insurance and assessments. (e) The Assuming Bank shall, not later than fifty (50) days after giving the notice provided in Section 4.7(b), (i) relinquish and release to the Receiver all property subject to the relevant Data Processing Lease, in the same condition as at Bank Closing, normal wear and tear excepted, or (ii) accept an assignment or a sublease thereof or negotiate a new lease or license agreement under this Section 4.7.

  • Xxxxx, Haldimand, Norfolk An employee shall be granted five working days bereavement leave with pay upon the death of the employee’s spouse, child, stepchild, parent, stepparent, legal guardian, grandchild or step-grandchild.

  • Wire Unbundled DS1 Digital Loop This is a designed 4-wire Loop that is provisioned according to industry standards for DS1 or Primary Rate ISDN services and will come standard with a test point, OC, and a DLR. A DS1 Loop may be provisioned over a variety of loop transmission technologies including copper, HDSL-based technology or fiber optic transport systems. It will include a 4-Wire DS1 Network Interface at the End User’s location.

  • Data Processing Agreement The Data Processing Agreement, including the Approved Data Transfer Mechanisms (as defined in the Data Processing Agreement) that apply to your use of the Services and transfer of Personal Data, is incorporated into this Agreement by this reference. Each party will comply with the terms of the Data Processing Agreement and will train its employees on DP Law.

  • By State Street State Street represents and warrants that: 1. It is a Massachusetts trust company, duly organized and existing under the laws of The Commonwealth of Massachusetts; 2. It has the corporate power and authority to carry on its business in The Commonwealth of Massachusetts; 3. All requisite corporate proceedings have been taken to authorize it to enter into and perform this Agreement; 4. No legal or administrative proceedings have been instituted or threatened which would impair State Street’s ability to perform its duties and obligations under this Agreement; 5. Its entrance into this Agreement shall not cause a material breach or be in material conflict with any other agreement or obligation of State Street or any law or regulation applicable to it; and It has and will continue to have access to the necessary facilities, equipment and personnel to perform its duties and obligations under this Agreement.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!