Departmental Compensation Practices and Working Conditions
Departmental Compensation Practices and Working Conditions Sample Clauses
Related to Departmental Compensation Practices and Working Conditions
GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site. Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer. Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations. Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage. Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer. Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized. Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel. Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations. Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job. Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours. Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement. Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
Money Market Fund Compliance Testing and Reporting Services Subject to the authorization and direction of the Trust and, in each case where appropriate, the review and comment by the Trust’s independent accountants and legal counsel, and in accordance with procedures that may be established from time to time between the Trust and the Administrator, the Administrator will:
Safe Working Conditions The Employer undertakes to maintain office furniture, equipment, etc., in a practical and safe condition in order to avoid injury to employees or damage to their attire. Employees, for their part and in their own interest, are expected to advise the Employer of any such potentially injurious equipment.
Proof of Compliance with Disability Benefits Coverage Requirements In order to provide proof of compliance with the requirements of the Workers’ Compensation Law pertaining to disability benefits, a Vendor/Contractor shall: a) Be legally exempt from obtaining disability benefits coverage; or b) Obtain such coverage from an insurance carrier; or c) Be a Board-approved self-insured employer. A Vendor seeking to enter into a Contract with the State of New York shall provide one of the following forms to OGS at the time of Vendor Submission and thereafter, within three (3) days of request: a) Form CE-200, Certificate of Attestation for New York Entities With No Employees and Certain Out of State Entities, That New York State Workers’ Compensation and/or Disability Benefits Insurance Coverage is Not Required, which is available on the Workers’ Compensation Board’s website (xxx.xxx.xx.xxx); (Reference applicable Solicitation and Group #s on the form.); b) Form DB-120.1, Certificate of Disability Benefits Insurance. The Vendor/Contractor must request that its insurance carrier send this form to OGS; or c) Form DB-155, Certificate of Disability Benefits Self-Insurance. The Vendor/Contractor must call the Board’s Self-Insurance Office at 000-000-0000 to obtain this form. Proof of coverage or an exemption shall be submitted to The New York State Office of General Services, New York State Procurement, Corning Tower- 00xx Xxxxx, Xxxxxx Xxxxx Xxxxx, Xxxxxx, XX 00000.
Human and Financial Resources to Implement Safeguards Requirements The Borrower shall make available necessary budgetary and human resources to fully implement the EMP and the RP.
Standard of Care; Performance of Employees Consultant shall perform all Services under this Agreement in a skillful and competent manner, consistent with the standards generally recognized as being employed by professionals in the same discipline in the State of California. Consultant represents and maintains that it is skilled in the professional calling necessary to perform the Services. Consultant agrees that all employees and subconsultants shall have sufficient skill and experience to perform the Services assigned to them. Finally, Consultant represents that it, its employees and subconsultants shall have all licenses, permits, qualifications and approvals of whatever nature that are legally required to perform the Services, including a City Business License, and that such licenses and approvals shall be maintained throughout the Term of this Agreement. As provided for in the indemnification provisions of this Agreement, Consultant shall perform, at its own cost and expense and without reimbursement from the City, any services necessary to correct errors or omissions which are caused by the Consultant’s failure to comply with the standard of care provided for herein. Any employee of the Consultant or its sub-consultants who is determined by the City to be uncooperative, incompetent, a threat to the adequate or timely completion of the Project, a threat to the safety of persons or property, or any employee who fails or refuses to perform the Services in a manner acceptable to the City, shall be promptly removed from the Project by the Consultant and shall not be re-employed to perform any of the Services or to work on the Project.
FAIR EMPLOYMENT PRACTICES In the performance of this agreement, and in accordance with California Government Code §12900 et. seq., Auxiliary shall not deny employment opportunities to any person on the basis of race, religious creed, color, national origin, ancestry, physical disability, mental disability, medical condition, genetic information, marital status, sex, gender, gender identity, gender expression, age, sexual orientation, military and veteran status. Auxiliary shall adopt employment procedures consistent with the policy statement on nondiscrimination and affirmative action in employment adopted by the CSU.
PERFORMANCE MONITORING AND REPORTING Performance indicators
Unsafe Working Conditions Employees shall be recognized by the Employer to have the competence to determine what constitutes unsafe working conditions within their discipline. No employee shall be disciplined for refusal to work in a situation which is deemed unsafe beyond the reasonable requirements of the employee's job.
SAFETY CONDITIONS OF EMPLOYMENT A. The District and its employees shall be safety conscious in their conduct and actions and shall cooperate in the implementation of the District's safety program. B. Employees shall report any unsafe or unhealthy conditions directly to their supervisor. The District shall conduct investigations of employee reports and take appropriate measures as soon as possible. The employee shall be informed by the principal or designee of the results of the investigation and of whatever action is to be taken. Safety violations will be corrected within ten (10) working days whenever possible. C. Teachers shall not be required to work under unsafe conditions or to perform tasks which endanger their health and safety. D. First aid supplies and first aid treatment shall be available to employees at each school site. A first aid kit shall be provided for each District vehicle used to transport pupils and shall be taken on all field trips. E. Personal protection equipment required by an employee's job duties shall be available from the principal or designee at each school site. F. An employee shall immediately report any assaults in connection with his/her employment to the principal or immediate supervisor who shall report the incident to the appropriate law enforcement agency and the District Office. 1. An employee may exercise the same degree of physical control over a pupil that a parent would be legally privileged to exercise, but which in no event shall exceed the amount of physical control reasonably necessary to maintain order, protect property, or protect the health and safety of pupils. 2. An employee shall receive applicable insurance and leave benefits for any injury incurred under the provisions of this Paragraph. 3. Employees shall be reimbursed for damage to personal property resulting from assault under the provisions of this Paragraph. 4. When the continued presence of a pupil in a class represents a physical danger to a teacher, the teacher may request that the principal institute suspension procedures in accordance with District policy. 5. The District's "Student Discipline Policy" shall be made available to employees.
