Description of test. The protective housing is placed horizontally in a device in such a way that it is possible to lock the attachment support adjusters firmly. In the direction of the largest dimension of the housing, the end closest to the point of attachment on the adjuster for the support shall be immobilized by a 15 mm-wide rigid stop covering the entire width of the housing. At the other end, a stop identical to the one described above is placed on the housing so that the specified test load can be applied to it (Figure 2). The end of the housing opposite to that where the force is exerted may be locked rather than held in position as shown in Figure 2. Figure 2 Example of rear-view mirror bending-test rig
Appears in 4 contracts
Description of test. The protective housing is placed horizontally in a device in such a way that it is possible to lock the attachment support adjusters firmly. In the direction of the largest dimension of the housing, the end closest to the point of attachment on the adjuster for the support shall be immobilized by a 15 mm-wide rigid stop covering the entire width of the housing. At the other end, a stop identical to the one described above is placed on the housing so that the specified test load can be applied to it (Figure 2). The end of the housing opposite to that where the force is exerted may be locked rather than held in position as shown in Figure 2. Figure 2 2: Example of rear-rear view mirror bending-test rig
Appears in 3 contracts
Samples: www.unece.org, digitallibrary.un.org, unece.org
Description of test. The protective housing is placed horizontally in a device in such a way that it is possible to lock the attachment support adjusters firmly. In the direction of the largest dimension of the housing, the end closest to the point of attachment on the adjuster for the support shall be immobilized by a 15 mm-mm- wide rigid stop covering the entire width of the housing. At the other end, a stop identical to the one described above is placed on the housing so that the specified test load can be applied to it (Figure 2). The end of the housing opposite to that where the force is exerted may be locked rather than held in position as shown in Figure 2. Figure 2 Example of rear-rear view mirror bending-test rig
Appears in 2 contracts
Description of test. The protective housing is placed horizontally in a device in such a way that it is possible to lock the attachment support adjusters firmly. In the direction of the largest dimension of the housing, the end closest to the point of attachment on the adjuster for the support shall be immobilized by a 15 mm-wide rigid stop covering the entire width of the housing. At the other end, a stop identical to the one described above is placed on the housing so that the specified test load can be applied to it (Figure 2). The end of the housing opposite to that where the force is exerted may be locked rather than held in position as shown in Figure 2. Figure 2 Example of rear-rear view mirror bending-test rig
Appears in 1 contract
Samples: unece.org