Design of Vapor Intrusion Mitigation Measures Sample Clauses

Design of Vapor Intrusion Mitigation Measures. It is the responsibility of the developer to design and implement adequate measures to mitigate vapor intrusion into buildings in the NRP and to demonstrate that the system will effectively mitigate the vapor intrusion exposure pathway and meet the cancer risk and HI goals described in Section 4.4. The proper design, installation, operation and maintenance of an active SSD system (Section 5.1.3.2), a continuous PPV ventilation system for the building (Section 5.1.3.3), a ventilated parking garage beneath occupied spaces (Section 5.1.3.4) or an SMD system (Section 5.1.3.5) is considered effective mitigation of the vapor intrusion exposure pathway. Vapor intrusion barriers (Section 5.1.3.6) and sealing of cracks in the floor (Section 5.1.3.7) may also be implemented to further reduce the potential for vapor intrusion to occur. For vapor intrusion measures other than those described above and in Section 5.1.3, the developer shall submit a design report to NASA for review and approval that describes the design of vapor intrusion mitigation measures that will be implemented and demonstrates how they will be effective in mitigating the potential vapor intrusion pathway. In addition, the report shall also describe any system operation, maintenance, and monitoring activities that will be implemented to demonstrate and maintain the long-term effectiveness of the implemented mitigation measures. Effectiveness may be demonstrated by (a) monitoring for VOCs in indoor air, (b) monitoring for VOCs in subslab soil gas if a barrier or sub-slab ventilation system is designed to prevent VOC accumulation below the slab, or (c) some other means that can reliably demonstrate effectiveness.
AutoNDA by SimpleDocs

Related to Design of Vapor Intrusion Mitigation Measures

  • Mitigation Measures Company shall take commercially reasonable measures (except measures causing it to incur out-of-pocket expenses which BNYM does not agree in advance to reimburse) to mitigate losses or potential losses to BNYM, including taking verification, validation and reconciliation measures that are commercially reasonable or standard practice in the Company’s business.

  • Corrective Measures If the Participating Generator fails to meet or maintain the requirements set forth in this Agreement and/or the CAISO Tariff, the CAISO shall be permitted to take any of the measures, contained or referenced in the CAISO Tariff, which the CAISO deems to be necessary to correct the situation.

  • Interim Measures Notwithstanding any requirements for alternative dispute resolution procedures as set forth in Articles 18(B), any party to the Dispute may apply to a court for interim measures (i) prior to the constitution of the arbitral tribunal (and thereafter as necessary to enforce the arbitral tribunal’s rulings); or (ii) in the absence of the jurisdiction of the arbitral tribunal to rule on interim measures in a given jurisdiction. The Parties agree that seeking and obtaining such interim measures shall not waive the right to arbitration. The arbitrators (or in an emergency the presiding arbitrator acting alone in the event one or more of the other arbitrators is unable to be involved in a timely fashion) may grant interim measures including injunctions, attachments and conservation orders in appropriate circumstances, which measures may be immediately enforced by court order. Hearings on requests for interim measures may be held in person, by telephone, by video conference or by other means that permit the parties to the Dispute to present evidence and arguments.

  • Protective Measures We have implemented and will maintain appropriate technical and organisational measures in relation to the Services taking into account the state of the art, the costs of implementation, and the nature, scope, context and purposes of Processing, as well as the likelihood and severity of risk to the rights and freedoms of data subjects. This includes measures relating to the physical security of Our facilities used to deliver them, measures to control access rights to Our assets and relevant networks, and processes for testing these measures. In accordance with Our obligations under applicable law, We may undertake digital forensic investigations in relation to the use of the Services and Subscriptions. You are responsible for using, and ensuring that your Users use, the controls and advice provided by the Services correctly and consistently.

  • Safety Measures Awarded vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Awarded vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage.

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.

  • Intrusion Detection All systems involved in accessing, holding, transporting, and protecting DHCS PHI or PI that are accessible via the Internet must be protected by a comprehensive intrusion detection and prevention solution.

  • Contractor Approach The Contractor shall develop, document, and implement BIDM Data Exchanges to obtain BIDM Imports from and to send BIDM Exports to CDPHE's CEDRS. 17.47.2.1. This exchange shall occur on a period as determined by the Department

  • Bilateral Safeguard Measures 1. Where, as a result of the reduction or elimination of a customs duty under this Agreement, any product originating in a Party is being imported into the territory of another Party in such increased quantities, in absolute terms or relative to domestic production, and under such conditions as to constitute a substantial cause of serious injury or threat thereof to the domestic industry of like or directly competitive products in the territory of the importing Party, the importing Party may take bilateral safeguard measures to the minimum extent necessary to remedy or prevent the injury, subject to the provisions of paragraphs 2 to 10. 2. Bilateral safeguard measures shall only be taken upon clear evidence that increased imports have caused or are threatening to cause serious injury pursuant to an investigation in accordance with the procedures laid down in the WTO Agreement on Safeguards. 3. The Party intending to take a bilateral safeguard measure under this Article shall immediately, and in any case before taking a measure, make notification to the other Parties and the Joint Committee. The notification shall contain all pertinent information, which shall include evidence of serious injury or threat thereof caused by increased imports, a precise description of the product involved and the proposed measure, as well as the proposed date of introduction, expected duration and timetable for the progressive removal of the measure. A Party that may be affected by the measure shall be offered compensation in the form of substantially equivalent trade liberalisation in relation to the imports from any such Party. 4. If the conditions set out in paragraph 1 are met, the importing Party may take measures consisting in increasing the rate of customs duty for the product to a level not to exceed the lesser of: (a) the MFN rate of duty applied at the time the action is taken; or (b) the MFN rate of duty applied on the day immediately preceding the date of the entry into force of this Agreement. 5. Bilateral safeguard measures shall be taken for a period not exceeding one year. In very exceptional circumstances, after review by the Joint Committee, measures may be taken up to a total maximum period of three years. No measure shall be applied to the import of a product which has previously been subject to such a measure. 6. The Joint Committee shall within 30 days from the date of notification examine the information provided under paragraph 3 in order to facilitate a mutually acceptable resolution of the matter. In the absence of such resolution, the importing Party may adopt a measure pursuant to paragraph 4 to remedy the problem, and, in the absence of mutually agreed compensation, the Party against whose product the measure is taken may take compensatory action. The bilateral safeguard measure and the compensatory action shall be immediately notified to the other Parties and the Joint Committee. In the selection of the bilateral safeguard measure and the compensatory action, priority must be given to the measure which least disturbs the functioning of this Agreement. The compensatory action shall normally consist of suspension of concessions having substantially equivalent trade effects or concessions substantially equivalent to the value of the additional duties expected to result from the bilateral safeguard measure. The Party taking compensatory action shall apply the action only for the minimum period necessary to achieve the substantially equivalent trade effects and in any event, only while the measure under paragraph 4 is being applied. 7. Upon the termination of the measure, the rate of customs duty shall be the rate which would have been in effect but for the measure. 8. In critical circumstances, where delay would cause damage which would be difficult to repair, a Party may take a provisional emergency measure pursuant to a preliminary determination that there is clear evidence that increased imports constitute a substantial cause of serious injury, or threat thereof, to the domestic industry. The Party intending to take such a measure shall immediately notify the other Parties and the Joint Committee thereof. Within 30 days of the date of the notification, the procedures set out in paragraphs 2 to 6, including for compensatory action, shall be initiated. Any compensation shall be based on the total period of application of the provisional emergency measure and of the emergency measure. 9. Any provisional measure shall be terminated within 200 days at the latest. The period of application of any such provisional measure shall be counted as part of the duration of the measure set out in paragraph 5 and any extension thereof. Any tariff increases shall be promptly refunded if the investigation described in paragraph 2 does not result in a finding that the conditions of paragraph 1 are met. 10. Five years after the date of entry into force of this Agreement, the Parties shall review in the Joint Committee whether there is need to maintain the possibility to take safeguard measures between them. If the Parties decide, after the first review, to maintain such possibility, they shall thereafter conduct biennial reviews of this matter in the Joint Committee.

  • Start-Up and Synchronization Consistent with the mutually acceptable procedures of the Developer and Connecting Transmission Owner, the Developer is responsible for the proper synchronization of the Large Generating Facility to the New York State Transmission System in accordance with NYISO and Connecting Transmission Owner procedures and requirements.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!