Determination of Measured Power Curve Sample Clauses

Determination of Measured Power Curve. During the first Contract Year, the Seller shall collect data to create a Measured Power Curve for each WTG that will be used for the remainder of the Initial Term to calculate the Expected Generation. The Measured Power Curve for each WTG will not be updated. To develop the Measured Power Curve for each WTG, Seller shall use data for such WTG during periods when such WTG is in the operational state categorized as CTH excluding periods where the WTG’s operational state is categorized as ERSDTH, EFDTH, EMPTH, EPDTH, oEFDTH, oMPTH, oEPDTH, or Environmental Derate. See Exhibit Q.3 Following the end of the first Contract Year, the Measured Power Curve for each WTG shall be calculated by Seller using the following data from the first Contract Year: (aa) the Density-Adjusted Wind Speed (for avoidance of doubt, the only referenced air density shall be the ISO standard atmosphere for sea level air density of 1.225 kg/ as set forth in Section 3 (Calculation of Density-Adjusted Wind Speed) of this Attachment Q) (Calculation of Certain Metrics), (bb) the 10-minute averaged Measured Wind Speed and (cc) the 10-minute averaged power output of such WTG. The data set used for calculating the Measured Power Curve shall include only Measured Wind Speed and power output measurements during the periods specified in the second bullet point above. The Measured Power Curve shall be calculated using (i) 0.5 m/s wind bins ranging from 1 below the manufacturer's specified cut-in-wind speed to, at least, 1.5 times the wind speed specified by the manufacturer as associated with 85% of the rated power of the WTG and (ii) the 10-minute averaged power output for each wind speed bin. The data set used to calculate the Measured Power Curve should include a minimum of 180 hours of sampled data from periods during the preceding Contract Year, where each wind bin includes the minimum of 30 minutes of sampled data, i.e. a minimum of 3 data points. If the aforementioned required minimums of sampled data are not available, Seller and Company may agree in writing upon a smaller data set to calculate the Measured Power Curve. Except as necessary to satisfy the foregoing requirements of this Section 4 (Determination of Measured Power Curve) of this Attachment Q (Calculation of Certain Metrics), the Measured Power Curve shall be calculated in a manner consistent with Clause 8.1 and Clause 8.2 of IEC 00000-00-0. Upon Seller's calculation of the Measured Power Curve for each WTG as provided in this S...
AutoNDA by SimpleDocs

Related to Determination of Measured Power Curve

  • Determination of Fair Market Value For purposes of this Section 10.2, “fair market value” of a share of Common Stock as of a particular date (the “Determination Date”) shall mean:

  • Determination of One-Month LIBOR Pursuant to the terms of the Global Agency Agreement, the Global Agent shall calculate the Class Coupons for the applicable Classes of Notes (including MAC Notes on which the Exchange Administrator has directed the Global Agent to make payments) for each Accrual Period (after the first Accrual Period) on the applicable LIBOR Adjustment Date. “One-Month LIBOR” will be determined by using the “Interest Settlement Rate” for U.S. dollar deposits with a maturity of one month set by ICE Benchmark Administration Limited (“ICE”) as of 11:00 a.m. (London time) on the LIBOR Adjustment Date (the “ICE Method”). ICE’s Interest Settlement Rates are currently displayed on Bloomberg L.P.’s page “BBAM.” That page, or any other page that may replace page BBAM on that service or any other service that ICE nominates as the information vendor to display the ICE’s Interest Settlement Rates for deposits in U.S. dollars, is a “Designated Page.” ICE’s Interest Settlement Rates currently are rounded to five decimal places. If ICE’s Interest Settlement Rate does not appear on the Designated Page as of 11:00 a.m. (London time) on a LIBOR Adjustment Date, or if the Designated Page is not then available, One-Month LIBOR for that date will be the most recently published Interest Settlement Rate. If ICE no longer sets an Interest Settlement Rate, Freddie Mac will designate an alternative index that has performed, or that Freddie Mac (or its agent) expects to perform, in a manner substantially similar to ICE’s Interest Settlement Rate.

  • Sector Sub-Sector Industry Classification Level of Government Type of Obligation Description of Measure Source of Measure All sectors : : - : Central : National Treatment Senior Management and Board of Directors : National Treatment and the Senior Management and Board of Directors obligations shall not apply to any measure relating to small and medium sized domestic market enterprise2. Foreign equity is restricted to a maximum of 40% for domestic market enterprises with paid-in equity capital of less than the equivalent of USD 200,000 Note: Members of the Board of Directors or governing body of corporation or associations shall be allowed in proportion to their allowable participation or share in the capital of such enterprises. : -1987 Constitution of the Republic of the Philippines. - Foreign Investments Act of 1991 (R.A. No. 7042, as amended by R.A. No. 8179). -Presidential and Administrative Issuances. ∞ 2 The concept of a small and medium sized domestic market enterprise is an enterprise with paid in equity capital of less than the equivalent of USD 200,000.00.

  • Termination of Agreement for Unavailability of Authority or Federal Funds It is the intent and understanding of the Parties that this Agreement is contingent upon the availability of Authority or Federal funds or the receipt by the Authority of Federal funds. If Authority funds or Federal funds approved or obligated by the Authority in connection with this Agreement are at any time rendered unavailable, the Authority shall then have the right to terminate this Agreement by the giving of a written notice, the basis, and the effective date of the termination to the Contractor. Should this Agreement be terminated by reason of the unavailability of Authority or Federal funds for the purposes of this Agreement, all finished or unfinished documents, data, studies, reports, and other materials prepared by the Contractor under this Agreement prior to the effective date of the termination shall be delivered in a format specified by the Authority. In the event of termination under this section for lack of Authority or Federal funds, the Contractor shall be entitled to receive payment for Products and Services incurred under this Agreement prior to the effective date of termination.

  • Determination of Clearing Price The Selling Shareholder and the Placement Agents shall have determined, in writing, the clearing price for the Securities in the Auction.

  • Determination of Position(s) The Appointing Authority shall determine the position(s) in the class or class option, if one exists, and employment condition and work location which is to be eliminated.

  • Financial Exigency 25.1 The parties agree that the process of long-range planning should obviate the possibility of a financial exigency occurring. However, the parties further agree that in the unlikely event of a financial exigency, in view of the ramifications to the careers of academic staff members, an orderly and equitable way of dealing with the situation is essential.

  • Determination of Agreement 29. (1) In any of the following events namely if —

  • CERTIFICATION OF INDEPENDENT PRICE DETERMINATION By submission of this bid, the Bidder certifies, and in the case of a joint bid each party thereto certifies as to its own organization, that in connection with this procurement:

  • Calculation of Service 25.7 For purposes of calculating continuous service and active service, a year shall be deemed to consist of two hundred and sixty-one (261) working days.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!