Adult Apprentices People who are 21 years of age or over at the time of entering into an apprenticeship with the Employer will be paid as per the wage rates set out in the appropriate Appendix to this Agreement. Where special or unusual circumstances occur or apply and where the parties to this Agreement and the adult apprentice agree in writing, the adult apprentice may be paid at a lesser rate, provided that the lesser rate will not be less than the rate for a junior apprentice set out in the appropriate Appendix to this Agreement.
Electrical Equipment Residents must use only CSA, UL-approved or Canadian-certified electrical equipment; the rated wattage of light fixtures must never be exceeded; and only replacement bulbs supplied by Waterloo maintenance staff may be used. Do not leave any unattended electrical equipment turned on (i.e. hair straighteners, lights etc.)
Apprentice An apprentice is an em ployee who is in training to become a Jour xxxxxx Meat Cutter. Apprentices must be at least sixteen (16) years of age. Apprentices may be employed at a ratio of not exceeding three (3) for each seven (7) Journeymen employed by the Employer within the jurisdiction of the Local. A quar terly report covering the number of Appren tices employed in relationship to the number of Journeymen shall be furnished the Union. The Employer agrees to rotate all Appren tices in his markets so as to give them suffi cient, well-rounded experience to qualify them as Journeymen at the end of the three
Electrical Provide drawings for the following systems:
APPRENTICES 6.36.1 The Contractor acknowledges and agrees that, if this Contract involves a dollar amount greater than or a number of working days greater than that specified in Labor Code Section 1777.5, this Contract is governed by the provisions of Labor Code Section 1777.5. It shall be the responsibility of the Contractor to ensure compliance with this Article and with Labor Code Section 1777.5 for all apprenticeable occupations.
Electrical Safety Only UL approved items are permitted in Housing & Residence Life. Extension and multi-use cords must be heavy duty, single plug, and be UL approved. Altering or adapting electrical outlets and equipment and overloading circuits jeopardize safety and thus are not permitted.
Apprentice Wages (a) Apprentices’ rates of pay are set out in Appendix B which includes the description of the calculations.
Electrical Service Electrical service for new construction or a renovated existing building shall be 480/277-volt, 3-phase, 4-wire or approved equal. Service shall be sized for HVAC and other mechanical system(s) loads, lighting, general building services, and dedicated computer based office equipment loads. 5 xxxxx per square foot shall be provided for lighting and general service receptacles. Size of neutral conductor of 3- phase circuits shall be twice that of phase conductor to accommodate potential harmonic currents associated with computer system electronic power supplies and fluorescent lighting fixtures electronic ballasts. An adequately sized 3 phase “wye” wound step down transformer shall be provided to supply 208/120-volt, 3 phase power, for lighting, general service receptacles and dedicated computer based office equipment. Dedicated, isolated ground circuits shall be supplied from separate isolated ground power distribution panel(s). Lighting circuits shall be supplied from separate lighting panel(s). Panels shall have 20% spare capacity and be complete with 10% spare breakers of each size, but no less than 1 spare. No more than 4 duplex receptacles shall be connected to any single 20-amp dedicated isolated ground circuit or general service circuit.
Lighting A system of fixtures providing or controlling the light sources used on or near the airport or within the airport buildings. The field lighting includes all luminous signals, markers, floodlights, and illuminating devices used on or near the airport or to aid in the operation of aircraft landing at, taking off from, or taxiing on the airport surface.
Electrical Power CUSTOMER acknowledges that the Services will not function in the absence of electrical power.
