EXHIBITS & PUBLIC POLICY Sample Clauses

EXHIBITS & PUBLIC POLICY. Each exhibitor is charged with knowledge of all laws, ordinances and regulations pertaining to health, fire prevention and public safety, while participating in this exposition. Compliance with such laws is mandatory for all exhibitors and the sole responsibility is that of the exhibitor. Show Management and service contractors have no responsibility pertaining to the compliance with laws as to public policy as far as individual exhibitor’s space, materials and operation is concerned. Should an exhibitor have any questions as to the application of such laws, ordinances and regulations to his exhibit or display, Show Management will endeavor to answer them. All booth decorations including carpeting must be flame-proofed and all hangings must clear the floor. Electrical wiring must conform to the National Electrical Code Safety Rules. If inspection indicates any exhibitor has neglected to comply with these regulations, or otherwise incurs fire hazard, the right is reserved to cancel all or such part of his exhibit as may be irregular, and effect the removal of same at exhibitor’s expense. Exhibitors will not be permitted to store behind their booth background any excess material such as cardboard cartons, literature, etc. Excess supplies must be stored in areas which will be made available for such purpose. If unusual equipment or machinery is to be installed or if appliances that might come under fire codes are to be used the exhibitor should communicate with Show Management for information concerning facilities or regulations. Exhibitors must comply with City and State fire regulations. Independent contractors must conform to IAEE, XXXX and ED&PA guidelines. All exhibitor labor must comply with established labor jurisdictions.
AutoNDA by SimpleDocs
EXHIBITS & PUBLIC POLICY. Each exhibitor is charged with knowledge of all State, County, and City laws, ordinances and regulations pertaining to health, fire prevention and public safety, while participating in this exhibition. Compliance with such laws is mandatory for all exhibitors and the sole responsibility is that of the exhibitor. No part of the building shall be defaced in any manner, nor shall signs or other articles be posted, nailed, taped or otherwise affixed to any pillars, doors, walls or other parts of the building. Any and all damages, losses, expenses, and/or costs resulting from failure to observe this notice shall be payable by the exhibitor. The exhibitor must, at his expense, maintain and keep in good order his exhibit and the space for which he has contracted. Show Management and service contractors have no responsibility pertaining to the compliance with laws as to public policy as far as individual exhibitor’s space, materials and operation is concerned. Should an exhibitor have any questions as to the application of such laws, ordinances and regulations to his exhibit or display, Show Management will endeavor to answer them. Exhibitors must comply with City and State fire regulations. All booth decorations including carpeting must be flame-proofed and all hangings must clear the floor. All exits, hallways, aisles and fire control apparatus must remain clear and unobstructed at all times. Use of butane or bottled gas is not permitted. Use of propane and helium balloons is prohibited. Electrical equipment and wiring must conform with National Electrical Code Safety Rules. If inspection indicates any exhibitor has neglected to comply with these regulations, or otherwise incurs fire hazard, the right is reserved to cancel all or such part of his exhibit as may be irregular, and effect the removal of same at exhibitor’s expense. If unusual equipment or machinery is to be installed, or if appliances that might come under fire codes are to be used, the exhibitor should communicate with Show Management for information concerning facilities or regulations. Independent contractors must conform to IAEM, ESCA and ED&PA guidelines and must be signatory to a current local collective bargaining agreement. Exhibitor agrees to abide by all requirements of the ACCME Standards for Commercial Support of Continuing Medical Education and the ANCC Commission on Accreditation Standards for Commercial Support of Continuing Nursing Education as provided by the Massachusetts Associat...
EXHIBITS & PUBLIC POLICY. Each exhibitor is charged with knowledge of all laws, ordinances and regulations pertaining to health, fire prevention and public safety, while participating in this exposition. Compliance with such laws is mandatory for all exhibitors and the sole responsibility is that of the exhibitor. Show Management and service contractors have no responsibility pertaining to the compliance with laws as to public policy as far as individual exhibitor’s space, materials and operation is concerned. Should an exhibitor have any questions as to the application of such laws, ordinances and regulations to his exhibit or display, Show Management will endeavor to answer them. All booth decorations including carpeting must be flame-proofed and all hangings must clear the floor. Electrical wiring must conform to the National Electrical Code Safety Rules. If inspection indicates any exhibitor has neglected to comply with these regulations, or otherwise incurs fire hazard, the right is reserved to cancel all or such part of his exhibit as may be irregular, and effect the removal of same at exhibitor’s expense. Exhibitors will not be permitted to store behind their booth background any excess material such as cardboard cartons, literature, etc. Excess supplies must be stored in

Related to EXHIBITS & PUBLIC POLICY

  • Exhibits Incorporated All Exhibits attached are hereby incorporated into this Agreement.

  • CONFIDENTIALITY AND PUBLICITY 9.1 Supplier will keep the existence, nature and the content of the Agreement, Accenture Data (as defined in Section 14.1), and any other information of Accenture, confidential and not disclose it to any other person. Supplier will ensure that its personnel, contractors and agents (collectively, “Personnel”) are aware of, and have committed to, confidentiality and legal obligations with respect to such information. Supplier will not make any reference to the Agreement, its terms, business information, or use Accenture’s name, logo or trademark in any public announcements, promotions or any other communication without Accenture’s prior written consent.

  • Exhibits and Attachments The following exhibits and attachments are included hereto and incorporated by reference herein: Exhibit A—Services Exhibit B—Payments and rates Attachment I—§504 Compliance

  • Exhibits and Addenda The exhibits and addenda listed below (unless lined out) are incorporated by reference in this Lease:

  • Laws, Rules and Regulations You agree to comply with all existing and future operating procedures used by the Bank for processing of transactions. You further agree to comply with, and be bound by, all applicable state or federal laws, rules, regulations, orders, guidelines, operating circulars and pronouncements, affecting checks and drafts, including, but not limited to, all rules and procedural guidelines established by the Board of Governors of the Federal Reserve and the Electronic Check Clearing House Organization ("ECCHO") and any other clearinghouse or other organization in which Bank is a member or to which rules Bank has agreed to be bound. These procedures, rules, and regulations (collectively the "Rules") and laws are incorporated herein by reference. In the event of conflict between the terms of this Agreement and the Rules, the Rules will control.

  • Applicable Rules and Regulations The Account and each transaction therein shall be subject to the terms of this Agreement and to (a) all applicable laws and the regulations, rules and orders (collectively "regulations") of all regulatory and self-regulatory organizations having jurisdiction and (b) the constitution, by-laws, rules, regulations, orders, resolutions, interpretations and customs and usages (collectively "rules") of the market and any associated clearing organization (each an "exchange") on or subject to the rules of which such transaction is executed and/or cleared. The reference in the preceding sentence to exchange rules is solely for DWR's protection and DWR's failure to comply therewith shall not constitute a breach of this Agreement or relieve Customer of any obligation or responsibility under this Agreement. DWR shall not be liable to Customer as a result of any action by DWR, its officers, directors, employees or agents to comply with any rule or regulation.

  • Conditions and Exclusions ‌ Notwithstanding anything to the contrary set forth in this SLA, this SLA and Customer’s entitlement to the remedies set out in this SLA are subject to the following conditions and exclusions:

  • Confidentiality and Publication Subject to the remaining provisions of this clause 8, each Party will treat all Confidential Information of any other Party as confidential and will not, without the consent of the other relevant Party, disclose or permit the same either to be disclosed to third parties or to be used, except solely as contemplated by this Agreement. Each Party must use all reasonable endeavours to ensure that its representatives comply with the obligations of confidentiality imposed upon it under this clause 8 as if those representatives were bound in the same way. Each Party must advise each other Party as soon as practicably possible of any breach of any confidentiality obligations under this Agreement of which it becomes aware. A Party may disclose Confidential Information if required to do so by law or to its professional advisers, subject to the relevant adviser being bound by similar obligations of confidentiality, or if necessary, entering into an appropriate confidentiality undertaking. A Party may publish the Project IP, subject to it complying with the following: prior to any publication, the Party must provide the other Party with full details of the Project IP it proposes to publish and the nature of the publication; and the other Party must notify the first Party whether permission to publish has been granted or refused within 30 days of the request (or such other period as may be set out at Item 7 of the Schedule) (Period); and if the other Party fails to notify the first Party of its decision under clause 8.5(b) within the Period shall be deemed to have consented to the proposed publication by the first Party; and any other Party may only refuse a request to publish if, in that other Party’s reasonable opinion, the publication is likely to jeopardise: the protection of Project IP (as applicable) under any statute of monopoly; or the successful commercialisation of the Project IP by the Party with such rights, or

  • Confidential Terms and Conditions; Publicity Licensee shall not disclose the terms and conditions of this Agreement or the pricing contained herein to any third party. Neither party shall use the name of the other party in publicity, advertising, or similar activity, without the prior written consent of the other, except that Licensee agrees that SAP and its affiliated companies may use Licensee's name in customer listings or, at times mutually agreeable to the parties, as part of SAP's marketing efforts (including without limitation reference calls and stories, press testimonials, site visits, SAPPHIRE participation). SAP will make reasonable efforts to avoid having the reference activities unreasonably interfere with Licensee's business. Licensee agrees that SAP may share information on Licensee with its affiliated companies for marketing and other business purposes and that Licensee has secured permission from its employees to allow SAP to share business contact information with its affiliates.

  • Exhibits A and B The Services described in Exhibit A and the Schedule of Data in Exhibit B to the DPA satisfy the requirements in SOPPA to include a statement of the product or service being provided to the school by the Provider and a listing of the categories or types of covered information to be provided to the Provider, respectively. EXHIBIT “H” Additional Terms or Modifications Version LEA and Provider agree to the following additional terms and modifications: This is a free text field that the parties can use to add or modify terms in or to the DPA. If there are no additional or modified terms, this field should read “None.”

Time is Money Join Law Insider Premium to draft better contracts faster.