FABRICATION TOLERANCES. .1 Squareness: 3 mm maximum difference in diagonal measurements.
FABRICATION TOLERANCES. A. Squareness:1/8-inch maximum difference in diagonal measurements.
B. Maximum Offset Between Faces: 1/16 inch.
C. Maximum Misalignment of Adjacent Members: 1/16 inch.
D. Maximum Bow: 1/8 inch in 48 inches.
E. Maximum Deviation From Plane: 1/16 inch in 48 inches.
2.8 CONNECTIONS
A. General: Weld or high-strength bolt all connections.
B. High-Strength Bolted Connections:
1. Tension: Tighten each bolt to provide, when all fasteners in a joint are tight, at least minimum tension listed in Table 8.1 of the “Specifications for Structural Joints Using ASTM A325 or A490 Bolts”.
2.9 WELDING MATERIALS A. Welding Filler Metal: AWS A5.1 or A5.5 E70XX for SMAW welding process, AWS A5.18 or A5.28 ER70S-X for GMAW welding process, and AWS A5.17 or A5.23 F7X-EXXX for SAW welding process. The FCAW welding process with E7XT-X electrodes to not be used without prior approval. Electrodes to be low-hydrogen type or equivalent.
FABRICATION TOLERANCES. Fabricate assemblies’ level, plumb, and true to line to a maximum allowable tolerance variation of one-eighth inch (⅛”) in ten feet (10’) [1:960] and as follows:
