Furniture and Equipment For purposes of this Lease, the terms “furniture and equipment” shall mean collectively all furniture, furnishings, wall coverings, fixtures and hotel equipment and systems located at, or used in connection with, the Hotel, together with all replacements therefor and additions thereto, including, without limitation, (i) all equipment and systems required for the operation of kitchens and bars, laundry and dry cleaning facilities, (ii) office equipment, (iii) material handling equipment, cleaning and engineering equipment, (iv) telephone and computerized accounting systems, and (v) vehicles.
Furniture and Equipment and Certain Other Equipment The Receiver hereby grants to the Assuming Bank an option to purchase all Furniture and Equipment or any telecommunications, data processing equipment (including hardware and software) and check processing and similar operating equipment owned by the Failed Bank at Fair Market Value and located at any leased Bank Premises that the Assuming Bank elects to vacate or which it could have, but did not occupy, pursuant to this Section 4.6; provided, that, the Assuming Bank shall give the Receiver notice of its election to purchase such property at the time it gives notice of its intention to vacate such Bank Premises or within ten (10) days after Bank Closing for Bank Premises it could have, but did not, occupy.
Computers All computers, hardware, software, computer upgrades and maintenance in connection therewith shall be at Owner's expense.
Furniture Misuse of University property, including possession of common area furniture in on-campus housing is prohibited and may result in a replacement charge and/or return of the property.
Communications and Computer Lines Tenant may install, maintain, replace, remove or use any communications or computer wires and cables (collectively, the “Lines”) at the Project in or serving the Premises, provided that (i) Tenant shall obtain Landlord’s prior written consent to the installation of any such Lines (such consent not to be unreasonably withheld), use an experienced and qualified contractor approved in writing by Landlord (such approval not to be unreasonably withheld), and comply with all of the other provisions of Articles 7 and 8 of this Lease, (ii) an acceptable amount of space for additional Lines shall be maintained for future occupants of the Project, as determined in Landlord’s reasonable opinion, (iii) the Lines (including riser cables) shall be appropriately insulated to prevent excessive electromagnetic fields or radiation, and shall be surrounded by a protective conduit reasonably acceptable to Landlord, (iv) any Lines servicing the Premises shall comply with all Applicable Laws, (v) as a condition to permitting the installation of new Lines, Landlord may require that Tenant remove existing Lines located in or serving the Premises that will no longer be used by Tenant and repair any damage in connection with such removal, and (vi) Tenant shall pay all costs in connection therewith. Landlord reserves the right to require that Tenant remove any Lines located in or serving the Premises which are installed in violation of these provisions, or which are at any time in violation of any Applicable Laws or represent a dangerous or potentially dangerous condition. Upon the expiration of the Lease Term, or immediately following any earlier termination of this Lease, Tenant shall, at Tenant’s sole cost and expense, remove all Lines installed by Tenant, and repair any damage caused by such removal.
Computer The Contractor shall maintain at its office for its use a computer with, at a minimum, a 1 GHz processor and an internet connection. The Contractor shall maintain individual email accounts for each of its project managers.
Trunk Group Architecture and Traffic Routing 5.2.1 The Parties shall jointly establish Access Toll Connecting Trunks between CLEC and CBT by which they will jointly provide Tandem-transported Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic from and to CLEC's Customers.
5.2.2 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access and non-translated Toll Free traffic (e.g., 800/888) to allow CLEC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier that is connected to the CBT access Tandem.
5.2.3 The Access Toll Connecting Trunks shall be one-way or two-way trunks, as mutually agreed, connecting an End Office Switch that CLEC utilizes to provide Telephone Exchange Service and Switched Exchange Access Service in the given LATA to an access Tandem Switch CBT utilizes to provide Exchange Access in the LATA.
Furniture, Fixtures and Equipment Sublessee shall have the right to use during the Term the office furnishings and equipment within the Subleased Premises that are identified on Exhibit C attached hereto, as such exhibit may be adjusted by mutual agreement of the parties prior to the Third Floor Premises Delivery Date (the “Furniture”), provided Sublessee may only use the Furniture located in the Second Floor Premises after the Second Floor Commencement Date. The Furniture is provided in its “AS IS, WHERE IS” condition, without representation or warranty whatsoever. Sublessee shall insure the Furniture under the property insurance policy required under the Master Lease, as incorporated herein, and pay all taxes with respect to the Furniture. Sublessee shall maintain the Furniture in good condition and repair, reasonable wear and tear excepted, and shall be responsible for any loss or damage to the same occurring during the Term. Sublessee shall surrender the Furniture to Sublessor upon the termination of this Sublease in the same condition as exists as of the applicable Delivery Date, reasonable wear and tear excepted. Sublessee shall not remove any of the Furniture from the Subleased Premises. Notwithstanding anything to the contrary herein, Sublessee may provide Sublessor with written notice one (1) time not less than forty-five (45) days prior to the Third Floor Premises Delivery Date that lists any items of Furniture that Sublessee does not want to use and Sublessor shall, at no cost to Sublessee, remove such items from the Subleased Premises prior to the Third Floor Premises Delivery Date and such items shall no longer be considered Furniture hereunder. Notwithstanding the foregoing, provided Sublessee is not in default beyond the expiration of any applicable cure or grace period as of the date of the expiration or earlier termination of this Sublease, which condition may be waived by Sublessor in its sole discretion, then upon the expiration or earlier termination of this Sublease, the Furniture shall become the property of Sublessee, and Sublessee shall accept the same in its “AS IS, WHERE IS” condition, without representation or warranty whatsoever except as provided in the Bill of Sale referred to in the following sentence. In the event the Furniture is to become the property of Sublessee upon the expiration or earlier termination of this Sublease pursuant to the terms of the immediately preceding sentence, then Sublessor agrees to execute and deliver to Sublessee a Bill of Sale in the form of Exhibit D attached hereto conveying and transferring to Sublessee the Furniture.
Workstation/Laptop encryption All workstations and laptops that process and/or store DHCS PHI or PI must be encrypted using a FIPS 140-2 certified algorithm which is 128bit or higher, such as Advanced Encryption Standard (AES). The encryption solution must be full disk unless approved by the DHCS Information Security Office.
Manufacture and Supply As between the Parties, Otsuka shall be responsible for, shall bear all costs associated with, and shall have all decision-making authority over, all Manufacturing Activities (subject to discussion of CMC matters with Acucela through the JDC or applicable Operating Team as discussed below); provided, that Otsuka shall supply Licensed Product to Acucela or its permitted subcontractors for use in clinical trials conducted in accordance with each Development Plan and, if applicable, Commercialization Plan (i.e., Phase 3b Clinical Trials or Post-Approval Studies, if any), free of charge and in such quantities as are agreed by the JDC or the JCC (as applicable) or are otherwise required to seek or obtain Regulatory Approval. In addition, if and after Acucela exercises an Opt-In Right under Section 3.1, Otsuka shall supply promotional samples of Licensed Product to Acucela for use in its performance of Co-Promotion, in such quantities and on such terms as are determined by the JCC. The cost of promotional samples of Licensed Product, which shall be included in Commercialization Costs, shall be established by the JCC based on Otsuka’s per-unit cost to manufacture such promotional samples (but, for the avoidance of doubt, Otsuka shall have no obligation to disclose any information relating to its manufacturing costs), but in no event shall such promotional sample cost exceed * per promotional sample unless mutually agreed otherwise by the Parties. Acucela’s and its permitted subcontractors’ obligations to conduct Development activities, and upon Acucela’s exercise of its Opt-in Right pursuant to Section 3.1, to conduct Development and Commercialization activities, shall be expressly conditioned upon Otsuka fulfilling its Licensed Product supply obligations as set forth in the Development Plan or the Commercialization Plan, as applicable. To the extent that Otsuka reasonably believes is necessary for performance of Development or Commercialization, Otsuka agrees to keep Acucela reasonably informed from time to time, through the JDC, JCC or applicable Operating Team, regarding the general status of Manufacturing Activities related to the Licensed Product (including Other Indication Product(s), as applicable) and from time to time shall update Acucela on any foreseeable delays and/or other material issues relating to Manufacturing the Licensed Product (including Other Indication Product(s), as applicable). Through the JDC or applicable Operating Team, Otsuka and Acucela shall confer and discuss CMC matters, and Otsuka agrees to consider suggestions of Acucela regarding CMC matters.
