Containers The commercial Collection Container shall be of a type that can be serviced by the Contractor's Collection equipment. The customer may either purchase the commercial Collection Container from a source or rent such Container from the Contractor at the rental rate included in the Exhibit II. Containers must be delivered within two (2) business days of receiving a signed service agreement. The storage capacity and frequency of Collection of the Container shall be suitable for the amount of Solid Waste generated by the customer and shall provide that no Solid Waste other than Bulk Waste be placed outside of the Container. The Contractor shall insure that container lids are closed after servicing containers. Customers may change Container size and/or frequency of service as needed or by season. If the customer utilizes a Commercial Can, the Commercial Can(s) must have a maximum capacity of 95 gallons, nominal. The customer may choose to use a Compactor, from any source, provided that the Compactor can be serviced by the Contractor's Collection equipment. Commercial Collection Containers and Compactors shall be maintained in a serviceable and safe condition by the owner of the Container or Compactor. The Contractor shall be responsible for sanitizing the containers or compactors. Damage caused by the Contractor to a customer owned Container or Compactor (other than normal wear) shall be repaired at the expense of the Contractor. In the event a customer owned or contractor owned compactor is damaged or in need of repair, Contractor shall provide suitable, temporary containers within 24 hours of notification, sufficient to provide uninterrupted service to customer until compactor is repaired or replaced. Gates for dumpster enclosures shall be opened and closed by Contractor personnel at no additional charge. All Containers and Compactors provided by the Contractor shall be in good condition, painted and neatly labeled with the Contractor’s name, phone number, size of Container, and the Customer’s name (where multiple customers containers are in the same proximity). The Contractor shall have a written procedure, approved by the contract administrator, for dealing with blocked containers. The Contractor shall not charge the customer any additional fees for placing an empty, Compactor or open type roll-off Container in the same spot from which a full Container is to be collected. The Contractor shall not charge a customer an additional fee for “round trip” service whereby a roll-off Compactor is removed from the customer’s property, emptied at the disposal facility, and returned to the customer’s property.
Container An intermodal cargo carrying device capable of road transport when mounted on a chassis or other suitable device. [Revised 11/18/09]
Preservative-treated Wood Containing Arsenic Grantee may not purchase preservative-treated wood products containing arsenic in the performance of this Agreement unless an exemption from the requirements of Chapter 13 of the San Francisco Environment Code is obtained from the Department of the Environment under Section 1304 of the Code. The term “preservative-treated wood containing arsenic” shall mean wood treated with a preservative that contains arsenic, elemental arsenic, or an arsenic copper combination, including, but not limited to, chromated copper arsenate preservative, ammoniacal copper zinc arsenate preservative, or ammoniacal copper arsenate preservative. Grantee may purchase preservative-treated wood products on the list of environmentally preferable alternatives prepared and adopted by the Department of the Environment. This provision does not preclude Grantee from purchasing preservative-treated wood containing arsenic for saltwater immersion. The term “saltwater immersion” shall mean a pressure-treated wood that is used for construction purposes or facilities that are partially or totally immersed in saltwater.
Carpet Cleaning Shampooing carpets with the deep dirt extraction (steam cleaning) method per manufactures recommendations.
Tooling Unless otherwise specified in this Agreement, all tooling and/or all other articles required for the performance hereof shall be furnished by Seller, maintained in good condition and replaced when necessary at Seller's expense. If NETAPP agrees to pay Seller for special tooling or other items either separately or as a stated part of the unit price of Goods purchased herein, title to same shall be and remain in NETAPP upon payment therefore.
Fittings 3.2.1 Landing gear support structure and attachment fitting
Furniture During the Sublease Term, at no charge to Subtenant, Subtenant shall be permitted to use the existing furniture and kitchen/pantry equipment located in the Subleased Premises and described in more particular detail in Exhibit F attached hereto, as well as all equipment and data cabling associated therewith (the “Furniture”), however, with respect to the Furniture depicted in Exhibit F attached hereto which is located on the seventh (7th) floor of the Building (i.e., the Expansion Space), the parties acknowledge that the depicted Furniture consists of the items located therein as of the Effective Date, and that a third party subtenant will be occupying the Expansion Space prior to Sublandlord’s occupancy of the Expansion Space (assuming Sublandlord exercises the Expansion Option), and that Sublandlord’s obligation to deliver such Furniture to Subtenant, and Subtenant’s obligation to accept such Furniture in its current condition, are both dependent upon Sublandlord’s 7th floor subtenant returning all Furniture located on the seventh (7th) floor in good condition and repair; to the extent that if such subtenant fails to do so, Sublandlord will use reasonable efforts to enforce any rights it may have to require such subtenant to replace any missing or damaged items of Furniture with an appropriate item in acceptable condition. Subtenant shall accept the Furniture in its current condition without any warranty of fitness from Sublandlord (Subtenant expressly acknowledges that no warranty is made by Sublandlord with respect to the condition of any cabling currently located in or serving the Subleased Premises). Sublandlord represents and warrants that it has clean title to the Furniture without any encumbrances or liens by any other party. For purposes of documenting the current condition of the Furniture, Subtenant and Sublandlord shall, prior to the Commencement Date and Expansion Date, as applicable, conduct a joint walk-through of the Subleased Premises and Expansion Space, as applicable, in order to inventory items of damage or disrepair. Subtenant shall use the Furniture only for the purposes for which such Furniture is intended and shall be responsible for the proper maintenance, insurance, care and repair of the Furniture, at Subtenant’s sole cost and expense, using maintenance contractors specified by Sublandlord. Subtenant shall not modify, reconfigure or relocate any of the Furniture except with the advance written permission of Sublandlord (which shall not be unreasonably withheld, conditioned or delayed), and any work of modifying any Furniture (including, without limitation, changing the configuration of, “breaking down” or reassembly of cubicles or other modular furniture) shall be performed at Subtenant’s sole cost using Sublandlord’s specified vendors or an alternate vendor approved in writing by Sublandlord (such approval to be granted or withheld on Sublandlord’s good faith discretion, based upon Sublandlord’s assessment of factors which include, without limitation, whether the performance by such vendor will void applicable warranties for such Furniture and whether such vendor is sufficiently experienced in the design of such Furniture). No item of Furniture shall be removed from the Subleased Premises without Sublandlord’s prior written consent; which consent may be conditioned upon Subtenant using Sublandlord’s preferred contractor for the purposes of any such removal, and storing any removed Furniture in a storage facility specified by Sublandlord, and returning and re-installing such Furniture in the Subleased Premises (using a contractor specified by Sublandlord) upon the expiration or termination of this Sublease, all at Subtenant’s sole cost and expense, to be paid as additional Rent hereunder; provided, however, that if such preferred contractors and storage facilities offer their services at rates that materially exceed commercially reasonable prices for similar San Francisco vendors of equivalent skill, experience, insurance coverage, union affiliation and, in the case of storage facilities, security features, and, further, provided that in Sublandlord’s good faith determination the use of an alternate contractor/facility will not void any warranties with respect to the Furniture in question, Subtenant may use other contractors and storage facilities reasonably approved in writing by Sublandlord. Prior to or promptly following the expiration or earlier termination of this Sublease, Sublandlord shall conduct a walk-through of the Subleased Premises to catalog any items of damage, disrepair, misuse or loss among the Furniture (reasonable wear and tear and damage due to casualty excepted), and Subtenant shall be responsible, at Subtenant’s sole cost and expense, for curing any such items (including, with respect to loss, replacing any lost item with a substantially similar new item reasonably acceptable to Sublandlord).
Scratches (Q) appliance malfunctions and any resultant leak there from; (R) any stain, soiling or damage resulting from everyday use or which has built up over time, e.g. hair, body or suntan oils and/or lotions; (S) signs of soiling include darkened areas where the body comes into contact with the furniture (these darkened areas are signs of soil build-up, which is not covered); (T) general maintenance and overall cleaning of the furniture is the consumer’s responsibility; (U) damage due to harsh or corrosive chemicals; (V) acids, including without limitation, dyes and inks (except ballpoint), plant food and fertilizer and bleach, gum; (W) any non-operating part or decorative parts such as hinges, knobs, handles, or shelves; (X) coverage under another insurance program; (Y) delivery and/or redelivery and/or loss or damage to the Covered Product while in the course of transit; (Z) design deficiency; (AA) fabrics with “X” cleaning codes and non-colorfast fabrics and leathers; (AB) odors; (AC) variation of the color, or graining of wood or wood products, marble or leather; (AD) split leathers used in seat cushions, back cushions or top or inside arm areas; (AE) natural markings on leather, such as, healed scars, insect bites, brand marks or wrinkles, or suede, and leathers with embossed patterns other than those stimulating natural cowhide; (AF) non- bovine leathers, and other buffed leathers; (AG) stains, color loss or damage resulting from cleaning methods or products (detergents, abrasives or other harsh cleaning agents) other than those recommended by the furniture manufacturer; (AH) stone or sand abrasion; (AI) loss or damage resulting from: pre-existing conditions known to You; (AJ) wear related issues, such as but not limited to, fading, wear, seam separation, stress tears, loss of foam resiliency, pilling or fraying of any fabric on all types of furniture; (AK) color loss or cracking and peeling on any leather or vinyl; (AL) splits or bi-cast leather; (AM) furniture that is used for commercial, institutional, outdoor or rental purposes; (AN) Customer’s Own Material furniture; (AO) wicker, rattan, and teakwood furniture; (AP) massage chairs; (AQ) stains or damage to suede, split-grain leather hide or exotic leathers; (AR) manufacturer quality issues such as stress tears, fabric flaws, fading, color loss or change, loss of foam or resiliency, cracking and peeling of leather or vinyl, natural leather markings, and defects in design and workmanship; (AS) Stains or damage that occur during assembly, delivery, installation, before furniture is delivered to your residence, while the furniture is located outside of your residence, while the furniture is in storage or being moved to or from storage or between residences; (AT) Wear & Tear caused by repeated use such as scuffing, soiling, hair/body oil, perspiration, surface abrasions, pilling or fraying of fabric, loose joints; (AU) Stains or damage covered under any manufacturer warranty, recall, homeowner, renter or other insurance policy; (AV) Stains or damage caused by structural problems, appliance malfunctions, Acts of God or natural disasters, theft, vandalism or illegal activity (AW) Stains or damage caused by independent contractors Specific to Home Automation: In additional to the exclusions listed above, this Agreement does not cover any loss, repairs or damage caused by or resulting from: (A) pre-existing conditions incurred or known to you (pre-existing means a condition prior to Plan issuance); (B) any repair covered by a manufacturer’s warranty or any insurance; (C) installation, or improper installation; or improper installation of customer replaceable components, modules, parts or peripherals; (D) damage or failure due to causes beyond our control such as environmental conditions, exposure to weather conditions or acts of nature including, but not limited to: fire, floods, smoke, sand, dirt, lightning, moisture, water damage, freezes, storms, wind, windstorm, hail, earthquake, animal or insect infestation, etc.; (E) damage or failure caused by riot, nuclear radiation, war, hostile action, or radioactive contamination, etc.; (F) battery failure or leakage; (G) collision, collapse, or explosion; (H) liquid spillage of any kind; (I) signal reception, transmission problems resulting from external causes, interruption of electrical service, loss of power, improper use of electrical/power, power “brown-out”, power overload or power surge (unless covered in the Special Features section of this document); (J) neglect, misuse, abuse, intentional damage, malicious mischief, theft, mysterious disappearance, vandalism or accidental damage; damage cause by dropping (K) rust, corrosion, warping, bending, etc.; (L) damage, warping, bending or rusting of any kind to the housing, cabinetry, outside casing or frame of the product; (M) any non-operating part, including but not limited to plastic, or decorative parts such as hinges, knobs, door liners, glass, handles, masks, rack rollers, shelves, etc.; (N) loss of or repair to components within the product not originally covered by the manufacturer’s warranty; (O) failure to product attachments not provided by the manufacturer or included in the original sale;
Toileting the ability to use the lavatory or otherwise manage bowel and bladder functions so as to maintain a satisfactory level of personal hygiene;
Cleaning 8.1 CONTRACTOR shall, at his own expenses, at all times keep the premises free from accumulation of debris, waste materials, and rubbish, and at the completion of the work, he shall remove his tools and equipment and all surplus materials, debris, waste material, and rubbish and shall leave the premises in a neat and clean condition. If CONTRACTOR does not attend to such cleaning immediately upon request, OWNER shall have the right to have this work done by others and deduct the cost therefore from the payment due CONTRACTOR hereunder.
