GPA 2261 and 2145 Sample Clauses

GPA 2261 and 2145. The heating value of the Gas delivered by SABINE at the Delivery Point shall be determined by gas chromatograph. The composition of the Gas shall be continuously measured by on-line chromatographs. The Gross Heating Value of the Gas shall be calculated using results from the on-line chromatograph. The chromatographs will analyze all hydrocarbon components, up to and including at least the Nonanes+ group, and inerts having a concentration of greater than zero point zero zero two mole percent (0.002%). The determination of Gas composition shall be in accordance with the GPA Standard 2261 – Analysis for Natural Gas and Similar Gaseous Mixtures by Gas Chromatography. All physical properties used in quality and quantity calculations shall be based on these compositional analyses and the component values published in GPA 2145, or the latest revision thereof. Water vapor content shall be included in the component analyses. The sample analysis cycle time shall be less than six (6) minutes. The maximum response time from sample probe to analyzer shall be four (4) minutes. In the event of failure of the on-line Gas chromatograph, chromatograph analysis of samples collected proportional to the flow through the meters shall be used. Auto-calibration of the Gas chromatograph shall be conducted on a weekly basis or as otherwise mutually agreed by the Parties.
AutoNDA by SimpleDocs
GPA 2261 and 2145. The heating value of the Gas delivered by SABINE at the Delivery Point shall be determined by gas chromatograph. The composition of the Gas shall be continuously measured by on-line chromatographs. The Gross Heating Value of the Gas shall be calculated using results from the on-line chromatograph. The chromatographs will analyze all hydrocarbon components, up to and including at least the Nonanes+ group, and inerts having a concentration of greater than 0.002 mol percent. The determination of Gas composition shall be in accordance with the GPA Standard 2261 — Analysis for Natural Gas and Similar Gaseous Mixtures by Gas Chromatography. All physical properties used in quality and quantity calculations shall be based on these compositional analyses and the component values published in GPA 2145, or the latest revision thereof. Water vapor content shall be included in the component analyses. The sample analysis cycle time shall be less than six (6) minutes. The maximum response time from sample probe to analyzer shall be four (4) minutes. In the event of failure of the on-line Gas chromatograph, chromatograph analysis of samples collected proportional to the flow through the meters shall be used. Auto-calibration of the Gas chromatograph shall be conducted on a weekly basis or as otherwise mutually agreed by the Parties.

Related to GPA 2261 and 2145

  • Quality Specifications SANMINA-SCI shall comply with the quality specifications set forth in its Quality Manual, incorporated by reference herein, a copy of which is available from SANMINA-SCI upon request.

  • Development Plans 4.3.1 For each Licensed Indication and corresponding Licensed Product in the Field, Licensee will prepare and deliver to Licensor a development plan and budget (each a “Development Plan”). The initial Development Plans for each Licensed Indication will be delivered within […***…] after the Grant Date for such Licensed Indication.

  • Technical Specifications Each Bloom System is an integrated system comprised of a fuel cell stack assembly and associated balance of plant components that converts a fuel into electricity using electrochemical means that (i) has a Nameplate Capacity of at least 0.5 kilowatts of electricity using an electrochemical process and (ii) has an electricity-only generation efficiency greater than thirty percent (30%).

  • Changes to Specifications All Specifications and any changes thereto agreed to by the parties from time to time shall be in writing, dated and signed by the parties. Any change to the Process shall be deemed a Specification change. No change in the Specifications shall be implemented by Catalent, whether requested by Client or requested or required by any Regulatory Authority, until the parties have agreed in writing to such change, the implementation date of such change, and any increase or decrease in costs, expenses or fees associated with such change (including any change to Unit Pricing). Catalent shall respond promptly to any request made by Client for a change in the Specifications, and both parties shall use commercially reasonable, good faith efforts to agree to the terms of such change in a timely manner. As soon as possible after a request is made for any change in Specifications, Catalent shall notify Client of the costs associated with such change and shall provide such supporting documentation as Client may reasonably require. Client shall pay all costs associated with such agreed upon changes. If there is a conflict between the terms of this Agreement and the terms of the Specifications, this Agreement shall control. Catalent reserves the right to postpone effecting changes to the Specifications until such time as the parties agree to and execute the required written amendment.

  • Space Plans Within a commercially reasonable time period after the Execution Date, Tenant shall, at its sole expense (but subject to the Premises Construction Allowance), deliver to Landlord space plans prepared by an architect (“Architect”) chosen by Tenant and reasonably approved by Landlord in electronic Autocad format together with a full-size hard copy depicting all improvements and alterations desired by Tenant to be installed in or made to the Premises. Landlord shall notify Tenant whether it approves of such space plans within five (5) business days after receipt thereof. If Landlord disapproves of the space plans, Landlord shall notify Tenant thereof specifying in reasonable detail the reasons for such disapproval, in which case Tenant shall revise the space plans in accordance with Landlord’s objections and submit revised space plans in accordance with subparagraph (a) above to Landlord for its review and approval. Landlord shall notify Tenant in writing whether or not it approves of the resubmitted space plans within three (3) business days after its receipt thereof and, if Landlord disapproves, Landlord shall notify Tenant thereof specifying in reasonable detail the reasons for such disapproval. This process shall be repeated until the space plans have been finally approved by Landlord and Tenant. If Landlord fails to approve or disapprove of the space plans or the resubmitted space plans, as the case may be, within the applicable time period set forth above in this Section 2.(a), and any such failure is not cured by Landlord within three (3) business days after written notice from Tenant to Landlord of such failure, then the space plans as submitted, or as resubmitted, as the case may be, shall be deemed approved by Landlord. As used herein, “Space Plans” means the Preliminary Spaces Plans finally approved or deemed approved by Landlord as provided above. Material changes to the Space Plans shall require Landlord’s prior consent, which consent shall not be unreasonably withheld, conditioned or delayed. To the extent not attached hereto on the Execution Date, this Work Letter will be automatically amended to include as Annex 1 hereto the finally approved Space Plan.

  • Development Reports Beginning six months after Effective Date and ending on the date of first commercial sale of a Licensed Product in the United States, LICENSEE shall report to Cornell progress covering LICENSEE's (and Affiliate's and Sublicensee's) activities and efforts in the development of rights granted to LICENSEE under this Agreement for the preceding six months. The report shall include, but not be limited to, activities and efforts to develop and test all Licensed Products and obtain governmental approvals necessary for marketing the same. Such semi-annual reports shall be due within sixty days (60) of the reporting period and shall use the form as provided herein as Appendix C.

  • Project Scope This section should contain SOW summary information including: o Project definition and expected duration o Project goals, objectives, o Priorities & expectations o Project approach & responsibilities o Overall coordination and assumptions

  • Development Budget Attached hereto as Exhibit "B" and incorporated herein by this reference is the Development Budget in an amount equal to $_____________. Owner acknowledges and represents that the attached Development Budget includes the total costs and expenses to acquire, develop, renovate and construct the Real Property and the Apartment Housing.

  • Computational Materials and Structural Term Sheets (a) Not later than 10:30 a.m., New York time, on the business day before the date on which the Current Report relating to the Offered Certificates of a Series is required to be filed by the Company with the Commission pursuant to Section 5(b) hereof, the Underwriter shall deliver to the Company five complete copies of all materials provided by the Underwriter to prospective investors in such Offered Certificates that constitute (i) "Computational Materials" within the meaning of the no-action letter dated May 20, 1994 issued by the Division of Corporation Finance of the Commission to Xxxxxx, Xxxxxxx Acceptance Corporation I, Xxxxxx, Peabody & Co. Incorporated, and Xxxxxx Structured Asset Corporation and the no-action letter dated May 27, 1994 issued by the Division of Corporation Finance of the Commission to the Public Securities Association (together, the "Xxxxxx Letters"), the filing of which material is a condition of the relief granted in such letter (such materials being the "Computational Materials"), and (ii) "Structural Term Sheets" within the meaning of the no-action letter dated February 17, 1995 issued by the Division of Corporation Finance of the Commission to the Public Securities Association (the "PSA Letter"), the filing of which material is a condition of the relief granted in such letter (such materials being the "Structural Term Sheets"). Each delivery of Computational Materials and Structural Term Sheets to the Company pursuant to this paragraph (a) shall be effected by delivering four copies of such materials to counsel for the Company on behalf of the Company at the address specified in Section 3 hereof and one copy of such materials to the Company.

  • Specifications Shipper will ensure that all of its Products tendered at the Origin Point for transportation on the Pipeline System meet the applicable specifications for the Product as set forth in the Tariff (as defined below) (the “Specifications”).

Time is Money Join Law Insider Premium to draft better contracts faster.