Facilities and Equipment Except as set forth herein, Consultant shall, at its sole cost and expense, provide all facilities and equipment that may be necessary to perform the services required by this Agreement. City shall make available to Consultant only the facilities and equipment listed in this section, and only under the terms and conditions set forth herein. City shall furnish physical facilities such as desks, filing cabinets, and conference space, as may be reasonably necessary for Consultant’s use while consulting with City employees and reviewing records and the information in possession of the City. The location, quantity, and time of furnishing those facilities shall be in the sole discretion of City. In no event shall City be obligated to furnish any facility that may involve incurring any direct expense, including but not limited to computer, long-distance telephone or other communication charges, vehicles, and reproduction facilities.
Trunk Group Connections and Ordering 5.2.1 For both One-Way and Two-Way Interconnection Trunks, if Onvoy wishes to use a technically feasible interface other than a DS1 or a DS3 facility at the POI, the Parties shall negotiate reasonable terms and conditions (including, without limitation, rates and implementation timeframes) for such arrangement; and, if the Parties cannot agree to such terms and conditions (including, without limitation, rates and implementation timeframes), either Party may utilize the Agreement’s dispute resolution procedures.
5.2.2 When One-Way or Two-Way Interconnection Trunks are provisioned using a DS3 interface facility, if Onvoy orders the multiplexed DS3 facilities to a Frontier Central Office that is not designated in the NECA 4 Tariff as the appropriate Intermediate Hub location (i.e., the Intermediate Hub location in the appropriate Tandem subtending area based on the LERG), and the provision of such facilities to the subject Central Office is technically feasible, the Parties shall negotiate in good faith reasonable terms and conditions (including, without limitation, rates and implementation timeframes) for such arrangement; and, if the Parties cannot agree to such terms and conditions (including, without limitation, rates and implementation timeframes), either Party may utilize the Agreement’s dispute resolution procedures.
5.2.3 Each Party will identify its Carrier Identification Code, a three or four digit numeric code obtained from Telcordia, to the other Party when ordering a trunk group.
5.2.4 For multi-frequency (MF) signaling each Party will out pulse ten (10) digits to the other Party, unless the Parties mutually agree otherwise.
5.2.5 Each Party will use commercially reasonable efforts to monitor trunk groups under its control and to augment those groups using generally accepted trunk- engineering standards so as to not exceed blocking objectives. Each Party agrees to use modular trunk-engineering techniques for trunks subject to this Attachment.
Self-Evaluation Each regular faculty member shall provide a self-evaluation. It shall address, among other items, the faculty member's fulfillment of professional responsibilities as referenced in Section 18.2.3 and an assessment of his or her own performance. The faculty member will share the self-evaluation with the Faculty Evaluation Committee and the first-level manager or designee. The self-evaluation will become part of the evaluation report.
Trunk Types 2.2.1 In interconnecting their networks pursuant to this Attachment, the Parties will use, as appropriate, the following separate and distinct trunk groups:
2.2.1.1 Interconnection Trunks for the transmission and routing of Reciprocal Compensation Traffic, translated LEC IntraLATA toll free service access code (e.g., 800/888/877) traffic, and IntraLATA Toll Traffic, between their respective Telephone Exchange Service Customers, Tandem Transit Traffic, and, Measured Internet Traffic, all in accordance with Sections 5 through 8 of this Attachment;
2.2.1.2 Access Toll Connecting Trunks for the transmission and routing of Exchange Access traffic, including translated InterLATA toll free service access code (e.g., 800/888/877) traffic, between Ymax Telephone Exchange Service Customers and purchasers of Switched Exchange Access Service via a Verizon access Tandem in accordance with Sections 9 through 11 of this Attachment; and
2.2.1.3 Miscellaneous Trunk Groups as mutually agreed to by the Parties, including, but not limited to: (a) choke trunks for traffic congestion and testing; and, (b) untranslated IntraLATA/InterLATA toll free service access code (e.g. 800/888/877) traffic.
2.2.2 Other types of trunk groups may be used by the Parties as provided in other Attachments to this Agreement (e.g., 911/E911 Trunks) or in other separate agreements between the Parties (e.g., directory assistance trunks, operator services trunks, BLV/BLVI trunks or trunks for 500/555 traffic).
2.2.3 In accordance with the terms of this Agreement, the Parties will deploy One-Way Interconnection Trunks (trunks with traffic going in one direction, including one-way trunks and uni-directional two-way trunks) and/or Two-Way Interconnection Trunks (trunks with traffic going in both directions).
2.2.4 Ymax shall establish, at the technically feasible Point(s) of Interconnection on Verizon’s network in a LATA, separate Interconnection Trunk group(s) between such POI(s) and each Verizon Tandem in a LATA with a subtending End Office(s) to which Ymax originates calls for Verizon to terminate.
2.2.5 In the event the volume of traffic between a Verizon End Office and a technically feasible Point of Interconnection on Verizon’s network in a LATA, which is carried by a Final Tandem Interconnection Trunk group, exceeds (a) the Centium Call Seconds (Hundred Call Seconds) busy hour equivalent of one (1) DS1 at any time; (b) 200,000 minutes of use for a single month; and/or; (c) 600 busy hour Centium Call Seconds (BHCCS) of use for a single month: (i) if One-Way Interconnection Trunks are used, the originating Party shall promptly establish new or augment existing End Office One-Way Interconnection Trunk groups between the Verizon End Office and the technically feasible Point of Interconnection on Verizon’s network; or,
Use of Facilities and Equipment The Association shall have the right to use school facilities and equipment not otherwise in use. Such equipment shall not be removed from the building without permission of the building principal. The individual using the equipment shall be responsible for repair or replacement costs beyond normal wear and tear if the equipment is damaged, stolen, or lost. The Association shall pay for the reasonable cost of all materials and supplies incident to such use. The Association may use school buildings for meetings by arranging such use with the building principals.
Historically Underutilized Businesses (“HUBs”). In accordance with state law, it is TFC’s policy to assist HUBs whenever possible to participate in providing goods and services to the agency. TFC encourages those parties with whom it contracts for the provision of goods and services to adhere to this same philosophy in selecting subcontractors to assist in fulfilling PSP’s obligations with TFC. If PSP subcontracts with others for some or all of the services to be performed under an Assignment to this Agreement, PSP shall comply with all HUB requirements pursuant to Chapter 2161 of the Texas Government Code. At or prior to the execution of an Assignment with a value that is anticipated to meet or exceed One Hundred Thousand and No/100 Dollars ($100,000.00), PSP must provide a completed HUB Subcontracting Plan, which shall be approved by TFC prior to execution of the Assignment. A copy of the HUB Subcontracting Form is attached hereto and incorporated herein for all purposes as Exhibit G. PSP shall provide the HUB Program of TFC with pertinent details of any participation by a HUB in fulfilling the duties and obligations arising under an Assignment, on the HUB Subcontracting Plan Progress Assessment Report (“PAR”). A copy of the PAR Form is attached hereto and incorporated herein for all purposes as Exhibit H.
Categories of Data Subjects Any individual accessing and/or using the Services through the Customer's account ("Users"); and any individual: (i) whose email address is included in the Customer's Distribution List; (ii) whose information is stored on or collected via the Services, or (iii) to whom Users send emails or otherwise engage or communicate with via the Services (collectively, "Subscribers").
Country Risk Country Risk shall mean, with respect to the acquisition, ownership, settlement or custody of Investments in a jurisdiction, all risks relating to, or arising in consequence of, systemic and markets factors affecting the acquisition, payment for or ownership of Investments including (a) the prevalence of crime and corruption, (b) the inaccuracy or unreliability of business and financial information, (c) the instability or volatility of banking and financial systems, or the absence or inadequacy of an infrastructure to support such systems, (d) custody and settlement infrastructure of the market in which such Investments are transacted and held, (e) the acts, omissions and operation of any Securities Depository, (f) the risk of the bankruptcy or insolvency of banking agents, counterparties to cash and securities transactions, registrars or transfer agents, and (g) the existence of market conditions which prevent the orderly execution or settlement of transactions or which affect the value of assets.
DISADVANTAGED BUSINESS ENTERPRISE OR HISTORICALLY UNDERUTILIZED BUSINESS REQUIREMENTS The Engineer agrees to comply with the requirements set forth in Attachment H, Disadvantaged Business Enterprise or Historically Underutilized Business Subcontracting Plan Requirements with an assigned goal or a zero goal, as determined by the State.
Forecasts and Orders 2.2.1 On the Effective Date of this Agreement, PURCHASER shall give SELLER written notice of the quantity of Martek Product which PURCHASER estimates in good faith that it will order or direct the Designee(s) to order from SELLER during the remainder of the current calendar year (the “Initial Annual Forecast”). Not later than November 30 of each calendar year during the Term of this Agreement, PURCHASER shall give SELLER written notice of the quantity of Martek Product which PURCHASER estimates in good faith that it will order or direct the Designee(s) to order from SELLER during the next subsequent calendar year (each, an “Annual Forecast”). The Annual Forecast shall be used to establish the per unit and per kilogram pricing for the Martek Products purchased during the relevant calendar year in accordance with Section 2.3.1 and Exhibit A attached hereto; provided that, for the remainder of calendar year 2006, the per kilogram pricing to be used, subject to the year-end adjustment pursuant to Section 2.3.1, shall be * per kilogram, notwithstanding the Initial Annual Forecast. In addition to the foregoing, one (1) month before the commencement of each calendar quarter during the Term of this Agreement, PURCHASER shall provide SELLER with a forecast (a “Rolling Forecast”) of PURCHASER’s requirements for the Martek Product for each of the succeeding four (4) quarters, specifying quantities and requested delivery dates. These forecasts will be PURCHASER’s good-faith, best estimate of requirements and should not be considered a firm commitment.
2.2.2 PURCHASER expressly acknowledges that available supplies of the Martek Product have been in the past, and, may from time to time in the future, be insufficient to meet current demand. Nevertheless, SELLER shall use commercially reasonable efforts to have available for shipment to PURCHASER or to a Designee for PURCHASER’s account such quantities of the Martek Product as PURCHASER forecasts in good faith pursuant to Section 2.2.1 above and any additional quantities which PURCHASER may reasonably request. In case for any reason SELLER cannot or does not supply such quantities of the Martek Products as are forecasted in good faith by PURCHASER pursuant to Section 2.2.1 to PURCHASER, PURCHASER shall be allowed to use an alternative supplier for quantities of Omega-3 and Omega-6 long-chain polyunsaturated fatty acids equal to those quantities of Martek Products that were ordered by PURCHASER pursuant to a Purchase Order and not delivered by SELLER.
2.2.3 PURCHASER shall issue and/or shall direct the Designee(s) to issue formal purchase orders (“Purchase Orders”) at least sixty (60) but no more than ninety (90) days in advance of the date on which PURCHASER or the Designee requests that SELLER ship the Martek Product. SELLER shall accept or reject any such Purchase Order within five (5) business days of receipt, provided that SELLER shall not reject any Purchase Order for any quantities within the most recent forecast.
2.2.4 Purchase Orders which have been accepted by SELLER shall be considered as firm and binding orders (subject to the provisions of Section 2.2.2 above) and shall only be canceled or amended by mutual written agreement of the parties. * CONFIDENTIAL TREATMENT REQUESTED. CONFIDENTIAL PORTION HAS BEEN FILED SEPARATELY WITH THE SECURITIES AND EXCHANGE COMMISSION.
