Infrequent regeneration Sample Clauses

Infrequent regeneration. Yes/No If yes, complete section 3.11.6.
Sample 1Sample 2Sample 3See All (17)
AutoNDA by SimpleDocs
Infrequent regeneration. 3.11.6.1. Number of cycles with regeneration
Sample 1Sample 2Sample 3See All (9)
Infrequent regeneration. This provision only applies to engines equipped with an exhaust after-treatment system that is regenerated on an infrequent basis, typically occurring in less than 100 hours of normal engine operation. For those engines, either additive or multiplicative factors shall be determined for upward and downward adjustment as referred to in point 6.6.2.4. ("adjustment factor"). Testing and development of adjustment factors is only required for one applicable transient (NRTC or LSI-NRTC) or RMC NRSC test cycle. The factors that have been developed may be applied to results from the other applicable test cycles including discrete-mode NRSC. In case that no suitable adjustment factors are available from testing using transient or RMC NRSC test cycles then adjustment factors shall be established using an applicable discrete-mode test. Factors developed using a discrete- mode test cycle shall only be applied to discrete-mode test cycles. It shall not be required to conduct testing and develop adjustment factors on both RMC and discrete-mode NRSCs.
Sample 1

Related to Infrequent regeneration

  • Downtime Due to the nature of server provision, downtime and lost transmissions may occur as part of routine maintenance. You are advised to maintain a copy of your account status and details of Content purchased.

  • For Product Development Projects and Project Demonstrations  Published documents, including date, title, and periodical name.  Estimated or actual energy and cost savings, and estimated statewide energy savings once market potential has been realized. Identify all assumptions used in the estimates.  Greenhouse gas and criteria emissions reductions.  Other non-energy benefits such as reliability, public safety, lower operational cost, environmental improvement, indoor environmental quality, and societal benefits.  Data on potential job creation, market potential, economic development, and increased state revenue as a result of the project.  A discussion of project product downloads from websites, and publications in technical journals.  A comparison of project expectations and performance. Discuss whether the goals and objectives of the Agreement have been met and what improvements are needed, if any.

  • Outages 9.7.1.1 Outage Authority and Coordination. Interconnection Customer and Transmission Owner may each in accordance with Good Utility Practice in coordination with the other Party and Transmission Provider remove from service any of its respective Interconnection Facilities, System Protection Facilities, Network Upgrades, System Protection Facilities or Distribution Upgrades that may impact the other Party’s facilities as necessary to perform maintenance or testing or to install or replace equipment. Absent an Emergency Condition, the Party scheduling a removal of such facility(ies) from service will use Reasonable Efforts to notify one another and schedule such removal on a date and time mutually acceptable to the Parties. In all circumstances, any Party planning to remove such facility(ies) from service shall use Reasonable Efforts to minimize the effect on the other Parties of such removal.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!