SUB-CONTRACTING 31.1. The Authority approves the appointment of the sub-contractors specified in Schedule 10 (Approved Sub-contractors) in respect of the obligations specified in that Schedule.
Load Shedding The Distributor may carry out Load Shedding in the following circumstances:
Pruning Nondestructive thinning of lateral branches to enhance views or trimming, shaping, thinning or pruning of a tree necessary to its health and growth is allowed, consistent with the following standards:
Trunk Group Architecture and Traffic Routing The Parties shall jointly engineer and configure Local/IntraLATA Trunks over the physical Interconnection arrangements as follows:
Fuel 28.1 The Vehicle must be returned with the amount of fuel equal to that at the time of the commencement of the rental. If the Vehicle is returned with less fuel, the difference will be charged to You at a rate of $5.00 including GST per litre (which includes a service component).
SHRINKAGE Seller will retain 3% of all volumes delivered to Seller on Xxxxx's behalf for shrinkage and line losses. The volumes retained by Seller will not create or contribute to an imbalance. Seller reserves the right to adjust the shrinkage factor, up or down, to account for actual line losses. Xxxxxx agrees to give Buyer thirty (30) days written notice of any adjustment.
UNIFORMS & EQUIPMENT Uniforms and equipment required by the Department to be worn/used by employees will be furnished by the Department.
Fueling delivering or dispensing fuel, defueling and refueling, or any other transfer of fuel on Airport property.
Direct Contracting Goods and works which the Association agrees meet the requirements for Direct Contracting may be procured in accordance with the provisions of said procurement method.
Unbundled Sub-Loop Concentration System (USLC 2.9.1 Where facilities permit and where necessary to comply with an effective Commission order, BellSouth will provide <<customer_name>> with the ability to concentrate its sub-loops onto multiple DS1s back to the BellSouth Central Office. The DS1s will then be terminated into <<customer_name>>’s collocation space. TR-008 and TR303 interface standards are available.