MEASUREMENT OF EQUIPMENT Sample Clauses

MEASUREMENT OF EQUIPMENT. 7.1 When an item of Equipment works its first shift during any Service Period, the Department will inspect and measure it. The Department’s measurement of the capacity of the item will be the basis for payment under the Agreement and will take precedence over any other type of measurement, including the manufacturer’s rated capacity for the Equipment. 7.2 Based on its inspection, the Department will prepare an Equipment Capacity Certificate for each item of Equipment. Samples of the current versions of the Department’s forms of Equipment Capacity Certificates are attached as Exhibit E to the Agreement. 7.3 The Department will place on each item of Equipment a numbered placard bearing its: (a) capacity in cubic yards as measured by the Department; (b) manufacturer and model; (c) VIN; and (d) license number. The placard must be placed in the front window of the item of Equipment while it is performing services under the Agreement. 7.4 Any changes to the Equipment that are made after the initial measurement must be reported by Contractor to the District Garage. Such changes might include, but are not necessarily limited to, changes to the: A. vehicle identification number; B. capacity of a body of a dump truck; C. size of a bucket of a front end loader, backhoe, or excavator; D. rated draw-bar horsepower of a bulldozer; or E. weight of a miscellaneous towing vehicle. 7.5 The Department may re-examine an item of Equipment and issue a revised Equipment Capacity Certificate if any of the following occur: A. the Department receives notice of a change; B. the item of Equipment is sent to another District Garage; or C. the Department’s representatives observe a change or suspect that the capacity of an item of Equipment has been diminished in any manner without notice to DSNY after it was measured. 7.6 The Contractor will be paid for an entire Service Period at the lowest capacity measured by the Department during that Service Period. 7.7 No dispute may be raised under the procedure set forth in Section 12.03 of Exhibit F based on discrepancies between two or more measurements of Equipment capacity made by the Department unless the matter was raised with a Department representative before the Equipment left the last assigned Work Location. The Department representative at such Work Location shall note any measurement dispute raised by the Contractor in the “Remarks” section of the Equipment Capacity Certificate.
Sample 1Sample 2
AutoNDA by SimpleDocs

Related to MEASUREMENT OF EQUIPMENT

  • Condition of Equipment Each Grantor will maintain or cause to be maintained and preserved in good condition, repair and working order, ordinary wear and tear excepted, the Equipment (necessary or useful to its business) and will forthwith, or in the case of any loss or damage to any Equipment of any Grantor within a commercially reasonable time after the occurrence thereof, make or cause to be made all repairs, replacements and other improvements in connection therewith which are necessary or desirable, consistent with past practice, or which the Collateral Agent may request to such end. Any Grantor will promptly furnish to the Collateral Agent a statement describing in reasonable detail any such loss or damage in excess of $25,000 per occurrence to any Equipment.

  • Installation of Equipment You represent that there are no legal, contractual or similar restrictions on the installation of the Equipment in the location(s) you have authorized. It is your responsibility to ensure compliance with all applicable building codes, zoning ordinances, homeowners’ association rules, covenants, conditions, and restrictions related to the Service, to pay any fees or other charges, and to obtain any permits or authorizations necessary for the installation or use of the Service (collectively "Legal Requirements"). You are solely responsible for any fines or similar charges for violation of any applicable Legal Requirements. You acknowledge and agree that Viasat or its designated service provider will be required to access your premises and computer to install and maintain the Equipment, including, without limitation, the antenna and its components. Standard Equipment installations performed by Viasat-authorized installers include: (i) installation of the antenna to an outside wall or sloped roof; (ii) travel to and from your Service location within 50 miles of the installer’s office; (iii) cable routed through one exterior wall and one interior wall or floor; (iv) connection of the antenna to the modem using up to 150 feet of cable; (v) connection of the modem to one computer using up to 7 feet of cable; and (vi) required mounting and cabling hardware. Any different or additional installation services or hardware are non-standard and may result in additional charges to be agreed upon between you and the installer. All installations include attaching the Equipment to your computer, installing software on your computer and configuring your computer to optimize the performance of the Internet Service. You confirm that you have reviewed the installation plan and agreed to any associated charges. If you approved a roof mount, you acknowledge the potential risks associated with this type of installation (including, without limitation, with respect to any warranty that applies to your roof or roof membrane). By signing this Agreement, scheduling a service or installation visit, and permitting us or our service provider to enter your home, you are authorizing Viasat and its service provider to perform all of the above actions. You are responsible for backing up the data on your computer and we highly recommend that you do so prior to permitting access to us or one of our designated service providers. NEITHER VIASAT NOR ITS SERVICE PROVIDER SHALL HAVE ANY LIABILITY WHATSOEVER FOR ANY LOSSES RESULTING FROM THE EQUIPMENT OR ANY INSTALLATION, REPAIR OR OTHER SERVICES ASSOCIATED WITH THE EQUIPMENT, INCLUDING WITHOUT LIMITATION, DAMAGE TO YOUR PREMISES OR LOSS OF SOFTWARE, DATA OR OTHER INFORMATION FROM YOUR COMPUTER. This limitation does not apply to any damages arising from the gross negligence or willful misconduct of us or one of our designated service providers. Time frames for installation, if any, are not guaranteed and may vary depending on the types of services requested and other factors.

  • Location of Equipment The Customer shall not remove the Equipment from the location shown herein as the place of use of the equipment, without prior written approval of the Company. The Customer shall inform the Company by email upon demand of the exact location of the Equipment while it is in the Customer’s possession.

  • Return of Equipment (a) At the expiration or termination of this Agreement or any Schedule, Lessee shall perform any testing and repairs required to place the units of Equipment in the same condition and appearance as when received by Lessee (reasonable wear and tear excepted) and in good working order for the original intended purpose of the Equipment. If required the units of Equipment shall be deinstalled, disassembled and crated by an authorized manufacturer's representative or such other service person as is reasonably satisfactory to Lessor. Lessee shall remove installed markings that are not necessary for the operation, maintenance or repair of the Equipment. All Equipment will be cleaned, cosmetically acceptable, and in such condition as to be immediately installed into use in a similar environment for which the Equipment was originally intended to be used. All waste material and fluid must be removed from the Equipment and disposed of in accordance with then current waste disposal laws. Lessee shall return the units of Equipment to a location within the continental United States as Lessor shall direct. Lessee shall obtain and pay for a policy of transit insurance for the redelivery period in an amount equal to the replacement value of the Equipment. The transit insurance must name Lessor as the loss payee. The Lessee shall pay for all costs to comply with this section (a). (b) Until Lessee has fully complied with the requirements of Section 9(a) above, Lessee's rent payment obligation and all other obligations under this Agreement shall continue from month to month notwithstanding any expiration or termination of the lease term. Lessor may not terminate the Lessee's right to use Equipment, unless Lessee is in default. (c) Lessee shall provide to Lessor a detailed inventory of all components of the Equipment including model and serial numbers. Lessee shall also provide an up-to-date copy of all other documentation pertaining to the Equipment. All service manuals, blueprints, process flow diagrams, operating manuals, inventory and maintenance records shall be given to Lessor at least ninety (90) days and not more than one hundred twenty (120) days prior to lease termination. (d) Lessee shall make the Equipment available for on-site operational inspections by potential purchasers at least one hundred twenty (120) days prior to and continuing up to lease termination. Lessor shall provide Lessee with reasonable notice prior to any inspection. Lessee shall provide personnel, power and other requirements necessary to demonstrate electrical, hydraulic and mechanical systems for each item of Equipment.

  • Metering Equipment 13.01. Utility will furnish, install, own and maintain metering equipment capable of measuring the flow of kilowatt-hours (kWh) of energy. The Customer's service associated with the CRG will be metered at a single metering point. The metering equipment will measure energy delivered by Utility to Customer and also measure energy delivered by Customer to Utility. Customer agrees to provide safe and reasonable access to the premises for installation of this equipment and its future maintenance or removal.

  • Closeout of Equipment 1. At the end of the term of a Contract that has no additional renewals or that will not be renewed (Closeout), or when a Contract is otherwise terminated, Grantee will submit to the SUD email box, XxxxxxxxxXxxxx.Xxxxxxxxx@xxxx.xxxxx.xx.xx an inventory of equipment purchased with System Agency funds and request disposition instructions for such equipment. 2. All equipment purchased with System Agency funds must be secured by Grantee at the time of Closeout, or termination of this Contract, and must be disposed of according to the System Agency’s disposition instructions, which may include return of the equipment to System Agency or transfer of possession to another System Agency Grantee, at Xxxxxxx’s expense.

  • Contractor’s Equipment The Contractor shall be responsible for all Contractor’s Equipment. The Contractor’s Equipment shall be deemed to be exclusively intended for the execution of the Works.

  • Customer Equipment “Customer Equipment” means any Customer-owned or provided software, hardware or services that you elect to use in connection with the Service(s). You agree to allow us and our agents the rights to insert CableCARDs and other hardware in the Customer Equipment, send software and/or downloads to the Customer Equipment and install, configure, maintain, inspect and upgrade the Customer Equipment. You warrant you are either the owner of the Customer Equipment or that you have the authority to give us access to the Customer Equipment. You should call Customer Service at 0-000-XXX-XXXX to find out if it meets our technical, security and other requirements. We reserve the right to disallow the use of Customer Equipment that we determine is not compatible with our network. We shall have no obligation to provide, maintain, or service Customer Equipment, including, but not limited to, Customer Equipment to which the Company or a third party has sent software or downloads. If you use Customer Equipment, you agree that the following limitation of liability shall apply: THE COMPANY DOES NOT WARRANT THAT CUSTOMER EQUIPMENT WILL ENABLE YOU TO SUCCESSFULLY INSTALL, ACCESS, OPERATE, OR USE THE SERVICE(S). YOU ACKNOWLEDGE THAT ANY SUCH INSTALLATION, ACCESS, OPERATION, OR USE COULD CAUSE CUSTOMER EQUIPMENT TO FAIL TO OPERATE OR COULD CAUSE DAMAGE TO CUSTOMER EQUIPMENT, YOU, YOUR PREMISES OR COMPANY EQUIPMENT. NEITHER THE COMPANY NOR ANY OF ITS AFFILIATES, SUPPLIERS OR AGENTS SHALL HAVE ANY LIABILITY WHATSOEVER FOR ANY SUCH FAILURE OR DAMAGE, INCLUDING LACK OF 911/E911 CAPABILITY OR DIALING ASSOCIATED WITH A SECURITY SYSTEM. YOUR USE OF CUSTOMER EQUIPMENT MAY PREVENT PROVISION OF SERVICE. The foregoing limitation of liability is in addition to and shall not limit any other limitation of liability set forth in this Agreement.

  • Lease of Equipment Lessor leases to Lessee, and Lessee leases from Lessor, all the property described in the Lease Schedules which are signed from time to time by Lessor and Lessee.

  • Substitution of Equipment In the event the Computer is inoperable, ASL has a limited number of spare laptops for use while the Computer is being repaired or replaced. This agreement remains in effect for such a substitute. The Student may NOT opt to keep a broken Computer or to avoid using the Computer due to loss or damage.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!