Model 1: exposure to spray drift Sample Clauses

Model 1: exposure to spray drift boom spraying‌ An example calculation, based on the case study used in the CRD Guidance (Chemicals Regulation Directorate), summarised in Table 11, is shown in Figure 5. Table 11 Input values for example calculation. All other inputs were model defaults as defined in Tables 1,2 and 5. Single application with a test product Dermal absorption = 17% Concentration of a.s. in product = 125 g/l Inhalation absorption =100% Applied dose = 1 L product per ha Oral absorption = 100% Applied water volume = 200 L/ha A distribution of outputs is calculated, and a number of different centiles of the distributions can be selected by the user. The relative importance of each component of exposure is shown in Figure 5 for median values, and it can be seen that dermal exposure for this scenario was the largest for both acute and longer term exposures. Direct dermal exposure is greatest for acute exposure, and indirect dermal exposure is greatest for longer-term, as it is repeated daily. Table 12 shows the median, 75th and 95th percentile of the output distribution for exposures, compared with the CRD case study. (Note that this case study used double the applied dose to determine the indirect exposures, shown in the lower half of the table for a child only, and we have therefore halved the CRD figures for comparison). It can be seen that the BROWSE model acute exposure distribution has a median that is similar to the existing CRD exposure assessment for direct dermal exposure, but the 95th percentile (recommended by EFSA for acute exposure calculations) is significantly higher. Spray inhalation exposure is lower in the BROWSE model, however, because the CRD model uses the limit of detection of experimental data, whereas BROWSE attempts a realistic estimate. The BROWSE indirect exposure calculation shows a greater longer-term exposure than the acute exposure, which is counter-intuitive. For indirect exposure, it is assumed that (a) the exposure occurs daily, and in this case study, the half life of the pesticide on the turf is 30 d so there is little decay over the 7 d exposure period, leading to a similar exposure to that for the acute calculation; and (b) there are two neighbouring fields that have contributed to the exposure, rather than a single field that is used for the acute calculation. Indirect dermal exposure is higher in the BROWSE model than the CRD calculation, largely because a more realistic estimate of ground deposits are used by BROWSE and because there has b...
AutoNDA by SimpleDocs

Related to Model 1: exposure to spray drift

  • Reallocation to a Class with a Lower Salary Range Maximum 1. If the employee meets the skills and abilities requirements of the position and chooses to remain in the reallocated position, the employee retains existing appointment status and has the right to be placed on the Employer’s internal layoff list for the classification occupied prior to the reallocation.

  • CREDIT UNION LIABILITY FOR FAILURE TO MAKE TRANSFERS If we do not complete a transfer to or from your account on time or in the correct amount according to our agreement with you, we may be liable for your losses or damages. However, we will not be liable for direct or consequential damages in the following events: - If, through no fault of ours, there is not enough money in your accounts to complete the transaction, if any funds in your accounts necessary to complete the transaction are held as uncollected funds pursuant to our Funds Availability Policy Disclosure, or if the transaction involves a loan request exceeding your credit limit. - If you used your card or access code in an incorrect manner. - If the ATM where you are making the transfer does not have enough cash. - If the ATM was not working properly and you knew about the problem when you started the transaction. - If circumstances beyond our control (such as fire, flood, or power failure) prevent the transaction. - If the money in your account is subject to legal process or other claim. - If funds in your account are pledged as collateral or frozen because of a delinquent loan. - If the error was caused by a system of any participating ATM network. - If the electronic transfer is not completed as a result of your willful or negligent use of your card, access code, or any EFT facility for making such transfers. - If the telephone or computer equipment you use to conduct audio response, online/PC, or mobile banking transactions is not working properly and you know or should have known about the breakdown when you started the transaction. - If you have xxxx payment services, we can only confirm the amount, the participating merchant, and date of the xxxx payment transfer made by the Credit Union. For any other error or question you have involving the billing statement of the participating merchant, you must contact the merchant directly. We are not responsible for investigating such errors. - Any other exceptions as established by the Credit Union.

  • Therapist Availability Therapist’s office is equipped with a confidential voice mail system that allows Patient to leave a message at any time. Therapist will make every effort to return calls within 24 hours (or by the next business day), but cannot guarantee the calls will be returned immediately. Therapist is unable to provide 24-hour crisis service. In the event that Patient is feeling unsafe or requires immediate medical or psychiatric assistance, he/she should call 911, or go to the nearest emergency room.

  • Reallocation to a Class with a Higher Salary Range Maximum Upon appointment to the higher class, the employee’s base salary will be increased to a step of the range for the new class that is nearest to five percent (5.0%) higher than the amount of the pre-promotional step, or to the entry step of the new range, whichever is higher.

  • Amount of Funds Available to Grantee The maximum amount of funding being made available to Grantee under this Agreement is: $20,000. This amount may be amended, subject to funds availability, by mutual consent of the parties. Grant funds under this Agreement may be considered taxable income.

  • ECR Number Environmental Commitment Record Requirements Description of ADOT Responsibilities TMP-3 The following measures will be implemented for the Selected Alternative: • All equipment exhaust systems will be in good working order. Properly designed engine enclosures and intake silencers will be used. • Equipment will be maintained on a regular basis. New equipment will be subject to new product emission standards. • Stationary equipment will be located as far away from sensitive receivers as possible. • Construction-related noise generators will be shielded from noise receivers (e.g., use temporary enclosures to shield generators or crushers, take advantage of site conditions to provide topographic separation). • Construction alerts will be distributed to keep the public informed of construction activities, and a toll-free number for construction-related complaints will be provided. • During the design phase, hours of operation will be evaluated to minimize disruptions during construction. ADOT to oversee for compliance TMP-4 Congestion from construction-related traffic will create temporary impacts in the project vicinity. The magnitude of these impacts will vary depending on the location of the sources of the fill material and of the disposition sites for surplus material, the land uses along the routes, the duration of hauling operations, staging locations, and the construction phasing. To identify acceptable routes and times of operation, ADOT, or its representative, will prepare an agreement with local agencies regarding hauling of construction materials on public streets. ADOT to oversee for compliance TP Attachment 000-0 Xxxxx Xxxxxxxx Xxxxxxx Project Record of Decision (ROD) Developer’s Environmental Commitment Requirements The following table includes the Project-specific environmental commitments as written in the ROD, with minor modifications for clarification purposes. As it relates to these Technical Provisions, references to freeway, project, South Mountain Freeway, proposed action, proposed freeway, and Selected Alternative mean the Project, and references to contractor mean Developer. Developer shall comply with and perform all of the contractor and ADOT requirements, including the ADOT obligations, commitments, and responsibilities, identified in the following table, except to the extent of those requirements that are specifically identified in the third column, entitled “Description of ADOT Responsibilities,” which are not delegated to Developer.

  • Please see the current Washtenaw Community College catalog for up-to-date program requirements Secondary / Post-Secondary Program Alignment Welding HIGH SCHOOL COURSE SEQUENCE 9th Grade 10th Grade 11th Grade 12th Grade English 9 Algebra I World History/Geography Biology World Language Phys Ed/Health English 10 Geometry U.S. History/Geography Physics or Chemistry World Language Visual/Performing/Applied Arts English 11 Algebra II Civics/Economics Welding English 12 Math Credit Science Credit Welding WASHTENAW COMMUNITY COLLEGE Welding Associate in Applied Science Semester 1 Math Elective(s)* 3 WAF 105 Introduction to Welding Processes 2 WAF 111 Oxy-fuel Welding 4 WAF 112 Shielded Metal Arc Welding 4 Semester Total 13 Semester 2 Speech Elective(s) 3 WAF 106 Blueprint Reading for Welders 3 WAF 123 Advanced Oxy-fuel Welding 4 WAF 124 Advanced Shielded Metal Arc Welding 4 Semester Total 14 Semester 3 Arts/Human. Elective(s) 3 Computer Lit. Elective(s) 3 WAF 215 Advanced Gas Tungsten Arc Welding 4 WAF 288 Gas Metal Arc Welding 4 Semester Total 14 Semester 4 WAF 200 Layout Theory Welding 3 WAF 210 Welding Metallurgy 3 Soc. Sci. Elective(s) 3 WAF 226 Specialized Welding Procedures 4 Semester Total 13 Semester 5 Nat. Sci. Elective(s) 4 WAF 227 Basic Fabrication 3 WAF 229 Shape Cutting Operations 3 Writing Elective(s) 3 Semester Total 13 Program Totals 67

  • Small Business Preference Commitment This section is applicable if Contractor received a small business preference in connection with this Agreement. Contractor’s failure to meet the small business commitment set forth in its bid or proposal constitutes a breach of this Agreement. Contractor must within sixty (60) days of receiving final payment under this Agreement report to the JBE the actual percentage of small/micro business participation that was achieved. If Contractor is a nonprofit veteran service agency (“NVSA”), Contractor must employ veterans receiving services from the NVSA for not less than 75 percent of the person-hours of direct labor required for the production of goods and the provision of services performed pursuant to this Agreement.

  • P R E A M B L E 26 27 This Agreement is made and entered into between Peninsula School District Number 401 28 (hereinafter "District") and Public School Employees of Peninsula, Bus Driver Unit, an affiliate of 29 Public School Employees of Washington (hereinafter "Association"). 31 In accordance with the provisions of the Public Employees Collective Bargaining Act and regulations 32 promulgated pursuant thereto, and in consideration of the mutual covenants contained herein, the 33 parties agree as follows: 34 35 37 A R T I C L E I 38 39 RECOGNITION AND COVERAGE OF AGREEMENT 40 41 Section 1.1. 42 The District hereby recognizes the Association as the exclusive representative of all employees in the 43 bargaining unit described in Section 1.3, and the Association recognizes the responsibility of 44 representing the interests of all such employees.

  • OPWC/Local Subdivision Participation Percentages For the sole and express purpose of financing/reimbursing costs of the Project, the estimated costs of which are set forth and described below, the Recipient hereby designates its Local Subdivision Percentage Contribution as amounting to a minimum total value of 50% of the total Project Cost. The OPWC Participation Percentage shall be 50% not to exceed $100,000.

Time is Money Join Law Insider Premium to draft better contracts faster.