MOLD/MILDEW CLAUSE Sample Clauses

MOLD/MILDEW CLAUSE. You acknowledge and understand that (a) the assigned space is located in a climate with temperature, humidity, and other naturally occurring conditions that normally allow the growth of mold and mildew in locations where dampness or moisture are present; and (b) upon moving into the assigned space, you will have control over and knowledge concerning conditions in the interior of the assigned space. Therefore, you agree to: a. Maintain a consistent temperature for climate control and air quality. Specific instructions are provided for proper thermostat operation. It is imperative that at all times thermostats are set to “auto” and not “fan” to control moisture. b. Maintain the assigned space in a clean condition by mopping, vacuuming, and/or wiping hard surfaces with a household cleaner. c. Take all necessary steps to prevent microbial growth from accumulating in your assigned space by promptly removing visible moisture or condensation on floors, walls, windows, ceilings, and other surfaces. If moisture is present due to a leak or another issue, report the problem immediately to Residential Life for proper assessment and repair. d. Follow the additional guidelines that can be found on our website at xxx.xxx.xxx/xxxxxxx.
AutoNDA by SimpleDocs
MOLD/MILDEW CLAUSE. You acknowledge and understand that (a) the assigned space is located in a climate with temperature, humidity, and other naturally occurring conditions that normally allow the growth of mold and mildew in locations where a. Set thermostats to provide appropriate climate control. If directions are provided, please follow instructions. b. Maintain the assigned space in a clean condition by mopping, vacuuming, or wiping hard surfaces with a household cleaner. c. Remove visible moisture or condensation on floors, walls, windows, ceilings, and other surfaces promptly. d. Take other measures as may be necessary to prevent mold or mildew from accumulating in the assigned space (including without limitation to reporting immediately to the university any evidence of water leaks or mold or mildew-like growth). e. Follow the additional guidelines that can be found on our website at xxx.xxx.xxx/xxxxxxx.
MOLD/MILDEW CLAUSE. You acknowledge and understand that (a) the assigned space is located in a climate with temperature, humidity, and other naturally occurring conditions that normally allow the growth of mold and mildew in locations where dampness or moisture are present; and (b) upon moving into the assigned space, you will have control over and knowledge concerning conditions in the interior of the assigned space. Therefore, you agree to: a. Set thermostats (if applicable) to provide appropriate climate control. If directions are provided, please follow instructions. b. Maintain the assigned space in a clean condition by mopping, vacuuming, or wiping hard surfaces with a household cleaner.
MOLD/MILDEW CLAUSE. You acknowledge and understand that (a) the assigned space is located in a climate with temperature, humidity, and other naturally occurring conditions that normally allow the growth of mold and mildew in locations where dampness or moisture are present; and (b) upon moving into the assigned space, you will have control over and knowledge concerning conditions in the interior of the assigned space. Therefore, you agree to: a. Set thermostats to provide appropriate climate control. If directions are provided, please follow instructions. b. Maintain the assigned space in a clean condition by mopping, vacuuming, or wiping hard surfaces with a household cleaner. c. Remove visible moisture or condensation on floors, walls, windows, ceilings, and other surfaces promptly. d. Take other measures as may be necessary to prevent mold or mildew from accumulating in the assigned space (including without limitation reporting immediately to the university any evidence of water leaks or mold or mildew-like growth). e. Follow the additional guidelines that can be found on our website at xxxxx://xxx.xxx.xxx/reslife/current/resources/airquality.php.

Related to MOLD/MILDEW CLAUSE

  • Limitation of Vendor Indemnification and Similar Clauses This is a requirement of the TIPS Contract and is non-negotiable TIPS, a department of Region 8 Education Service Center, a political subdivision, and local government entity of the State of Texas, is prohibited from indemnifying third-parties (pursuant to the Article 3, Section 52 of the Texas Constitution) except as otherwise specifically provided for by law or as ordered by a court of competent jurisdiction. Article 3, Section 52 of the Texas Constitution states that "no debt shall be created by or on behalf of the State … " and the Texas Attorney General has opined that a contractually imposed obligation of indemnity creates a "debt" in the constitutional sense. Tex. Att'y Gen. Op. No. MW-475 (1982). Thus, contract clauses which require TIPS to indemnify Vendor, pay liquidated damages, pay attorney's fees, waive Vendor's liability, or waive any applicable statute of limitations must be deleted or qualified with ''to the extent permitted by the Constitution and Laws of the State of Texas." Does Vendor agree? Yes, I Agree TIPS, a department of Region 8 Education Service Center, a political subdivision, and local government entity of the State of Texas, does not agree to binding arbitration as a remedy to dispute and no such provision shall be permitted in this Agreement with TIPS. Vendor agrees that any claim arising out of or related to this Agreement, except those specifically and expressly waived or negotiated within this Agreement, may be subject to non-binding mediation at the request of either party to be conducted by a mutually agreed upon mediator as prerequisite to the filing of any lawsuit arising out of or related to this Agreement. Mediation shall be held in either Camp or Titus County, Texas. Agreements reached in mediation will be subject to the approval by the Region 8 ESC's Board of Directors, authorized signature of the Parties if approved by the Board of Directors, and, once approved by the Board of Directors and properly signed, shall thereafter be enforceable as provided by the laws of the State of Texas. Does Vendor agree? Yes, Vendor agrees Does Vendor agree? Yes, Vendor agrees Vendor agrees that nothing in this Agreement shall be construed as a waiver of sovereign or government immunity; nor constitute or be construed as a waiver of any of the privileges, rights, defenses, remedies, or immunities available to Region 8 Education Service Center or its TIPS Department. The failure to enforce, or any delay in the enforcement, of any privileges, rights, defenses, remedies, or immunities available to Region 8 Education Service Center or its TIPS Department under this Agreement or under applicable law shall not constitute a waiver of such privileges, rights, defenses, remedies, or immunities or be considered as a basis for estoppel. Does Vendor agree? Yes, Vendor agrees Vendor agrees that TIPS and TIPS Members shall not be liable for interest or late-payment fees on past-due balances at a rate higher than permitted by the laws or regulations of the jurisdiction of the TIPS Member. Funding-Out Clause: Vendor agrees to abide by the applicable laws and regulations, including but not limited to Texas Local Government Code § 271.903, or any other statutory or regulatory limitation of the jurisdiction of any TIPS Member, which requires that contracts approved by TIPS or a TIPS Member are subject to the budgeting and appropriation of currently available funds by the entity or its governing body.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!