Paints and Coatings Sample Clauses

Paints and Coatings. This Warranty does not cover any defects, damage, problems or degradation due to the use of paints, coatings, sealants or other solutions on the treated Product. BEFORE USING ANY PAINT, STAIN OR OTHER COATING ON TREATED PRODUCT, YOU SHOULD CONSULT WITH A COATINGS EXPERT OR MANUFACTURER TO ASSURE YOURSELF THAT ANY RECOMMENDED COATING HAS BEEN SUCCESSFULLY TESTED ON THE TREATED PRODUCT. CHEMCO DOES NOT WARRANT OR ENDORSE ANY COATING PRODUCT OR MANUFACTURER. PLEASE REVIEW CHEMCO’S INFORMATIONAL NOTICE ON PAINTS AND COATINGS. Review at: xxxxx://xxx.xxxxxx.xxx/saferwood/painting-and-staining
AutoNDA by SimpleDocs
Paints and Coatings. A. Provide dollar amounts per construction workbook of paints applied on the interior of the building. Paints shall comply with Green Seal Product Specific Environmental Requirements (xxx.xxxxxxxxx.xxx/xxxxxxxx/xxxxxx.xxx). The Green Seal standard is intended for paints and anti-corrosive paints. Both interior and exterior paints are addressed by the standard, but only SECTION 01352 LEED® REQUIREMENTS 2220 & 0000 XXXXXXX XXXX. ROSEVILLE, CA limits for interior paints apply to a LEED project. Limits on VOCs in grams per liter for paints and anti-corrosive paints are as follows:
Paints and Coatings. Intermittent surface coating operations are conducted throughout the facility for occasional structural and equipment maintenance needs, including architectural coating. Normally only touch-up and equipment labeling or tagging is performed. All architectural coatings used are in compliance with District Rule 323, as verified through the rule-required recordkeeping. These activities are not specifically addressed in this permit however they are addressed in the associated Xxxxx and Xxxxxx/Boyne Lease permits.

Related to Paints and Coatings

  • Plant The expression ‘Plant’ as used in the tender papers shall mean every temporary accessory necessary or considered necessary by the Engineer to execute, construct, complete and maintain the work and all altered, modified, substituted and additional works ordered in the time and the manner herein provided and all temporary materials and special and other articles and appliance of every sort kind and description whatsoever intended or used therefore.

  • ASBESTOS CONTAINING BUILDING MATERIALS Please be advised that an asbestos survey may have been performed at the Property. If provided, please review the information that identifies the locations of known asbestos containing material or presumed asbestos containing material. All personnel and appropriate subcontractors should be notified of the presence of these materials, and informed not to disturb these materials. Any activity that involves the disturbance or removal of these materials must be done by an appropriately trained individual/contractor.

  • Materials (Confirm each bullet point and sign below) ▪ Vendor claims some Vendor Data confidential to the extent permitted by T GC Chapter 552 and other applicable law. Vendor claims some Vendor Data confidential to the xtent permitted by TGC Chapter 552 and other applicable law. ▪ Vendor attached to this PDF all potentially confidential Vendor Data and listed the number of attached pages below. ▪ Vendor’s authorized signatory has signed below and shall upload this document in the proper location in the eBid System. ▪ Vendor agrees that TIPS shall not be liable for any release of confidential information required by law. Number of pages attached deemed confidential: Authorized Signature: (Confir ch bullet point and sig bel ) ( Confirm each bullet point and sign below By signing for Option 2 below, V endor ex pressly waives any confidentiality claim for all Vendor Data submitted in relation to this proposal and resulting contract. Vendor confirms that By signing for Option 2 below, V or e pressly waives any confidentiality claim for all Vendor Da ubmitted in relation TIPS may freely release Vendor Data submitted in relation to this proposal or resulting contract to any requestor. Vendor agrees that TIPS shall not be responsible or liable for any use or distribution of Vendor Data by TIPS or TIPS Members. ▪ Vendor’s authorized signatory has signed below and shall upload this document in the proper location in the eBid System. ▪Vendor agrees that TIPS shall not be liable for any release of confidential information required by law.

  • Materials and Equipment ‌ Material means property that may be consumed or expended during performance, component parts of a higher assembly, or items that lose their individual identity through incorporation into an end item. Equipment means a tangible item that is functionally complete for its intended purpose, durable, nonexpendable, and needed for performance. Materials and Equipment shall be priced in accordance with the terms of the task order award, contract type, and applicable FAR and agency-specific regulatory supplements. Unless otherwise directed by task order terms and conditions, the Contractor may apply indirect costs to materials and equipment consistent with the Contractor’s usual accounting practices.

  • MARKETING MATERIALS AND REPRESENTATIONS (a) The Participant represents and warrants that it will not make any representations concerning a Fund, Creation Units or Shares, other than those consistent with the Prospectus or any Marketing Materials (as defined below) furnished to the Participant by the Distributor.

  • Products Products available under this Contract are limited to Software, including Software as a Service, products and related products as specified in Appendix C, Pricing Index. Vendor may incorporate changes to their product offering; however, any changes must be within the scope of products awarded based on the posting described in Section 1.B above. Vendor may not add a manufacturer’s product line which was not included in the Vendor’s response to the solicitation described in Section 1.B above.

  • Heating, Ventilation and Air Conditioning Landlord shall furnish to the Premises heating, ventilation and air-conditioning (“HVAC”) in accordance with the Design Standards set forth in Exhibit D during Ordinary Business Hours. Landlord shall have access to all air-cooling, fan, ventilating and machine rooms and electrical closets and all other mechanical installations of Landlord (collectively, “Mechanical Installations”), and Tenant shall not construct partitions or other obstructions which may interfere with Landlord’s access thereto or the moving of Landlord’s equipment to and from the Mechanical Installations. No Tenant Party shall at any time enter the Mechanical Installations or tamper with, adjust, or otherwise affect such Mechanical Installations. Landlord shall not be responsible if the HVAC System fails to provide cooled or heated air, as the case may be, to the Premises in accordance with the Design Standards by reason of (i) any equipment installed by, for or on behalf of Tenant, which has an electrical load in excess of the average electrical load and human occupancy factors for the HVAC System as designed, or (ii) any rearrangement of partitioning or other Alterations made or performed by, for or on behalf of Tenant. Tenant shall install, if missing, blinds or shades on all windows, which blinds and shades shall be subject to Landlord’s approval, and shall keep operable windows in the Premises closed, and lower the blinds when necessary because of the sun’s position, whenever the HVAC System is in operation or as and when required by any Requirement. Tenant shall cooperate with Landlord and shall abide by the rules and regulations which Landlord may reasonably prescribe for the proper functioning and protection of the HVAC System. Tenant acknowledges that the server room in the Premises currently has three heat pumps installed, being two 4-ton units, and one 2.5-ton unit (the “Existing Heat Pumps”). The 2.5-ton unit is currently connected and operational. Tenant shall determine whether it is satisfied with the condition of the Existing Heat Pumps and Landlord shall not have any responsibility or liability for the condition, operation, maintenance, repair or replacement of the Existing Heat Pumps. Tenant may operate the Existing Heat Pumps. Tenant shall be responsible for, and pay directly for, all necessary maintenance and repairs to the Existing Heat Pumps. Tenant shall reimburse Landlord monthly for the cost of all utility services used to operate the Existing Heat Pumps within 10 Business Days after receipt of Landlord’s invoice for such amount. Landlord may measure Tenant’s usage of such utility services by either a sub-meter or by other reasonable methods such as by temporary check meters or by survey. Tenant, at its cost, may replace the Existing Heat Pumps with one or more new heat pumps, provided, however, that the capacity of such replacement heat pump(s) shall not exceed the 10.5-ton capacity cooling capacity of the Existing Heat Pumps.

  • Waste Borrower shall not commit or suffer any waste of the Property or make any change in the use of the Property which will in any way materially increase the risk of fire or other hazard arising out of the operation of the Property, or take any action that might invalidate or give cause for cancellation of any Policy, or do or permit to be done thereon anything that may in any way impair the value of the Property or the security of this Security Instrument. Borrower will not, without the prior written consent of Lender, permit any drilling or exploration for or extraction, removal, or production of any minerals from the surface or the subsurface of the Land, regardless of the depth thereof or the method of mining or extraction thereof.

  • Components Patheon will purchase and test all Components (with the exception of Client-Supplied Components) at Patheon’s expense and as required by the Specifications.

  • Supplies 1. Supplies are defined as consumable items necessary to carry out the services under this Contract including medical supplies, drugs, janitorial supplies, office supplies, patient educational supplies, software, and any items of tangible personal property other than those defined as equipment above.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!