Piece Inspection Sample Clauses

Piece Inspection. When this clause is cited on a Purchase Order, the supplier shall provide first piece dimensional inspection data. The first piece shall be from the initial lot, batch, or run. 100% of the dimensions shall be measured as part of the first piece inspection. Data sheet shall depict dimension, tolerance, and actual measurement, and be traceable to Isimac’s Customer Drawing Part number and revision. First piece inspection data shall be sent to Isimac with initial purchase order unless otherwise stipulated on said purchase order. Any revision changes to a drawing that affect any dimensions shall necessitate additional first piece inspection data for an open purchase order.
AutoNDA by SimpleDocs
Piece Inspection. Supplier first piece inspection is required. Seller shall ensure the first piece conforms to all drawings, specifications and specified requirements of the Purchase Order, and that the first piece is a representative of the production materials, processes, production equipment and inspection equipment that is intended for use to produce the contracted quantity and verified by qualified personnel. Records of the first piece inspection shall be available for review by Strata-G per paragraph 4.1.e.
Piece Inspection. In case of semi-automatic or fully automatic machines some trial pieces are produced and inspected. If defects are found then machine is adjusted and another trial piece is made. When the trial piece fulfills the desired quality then the production time is released for production.

Related to Piece Inspection

  • Safety Inspection During inspection of County facilities conducted by the State Division of Occupational Safety and Health for the purpose of determining compliance with the California OSHA requirements, an OCEA designated employee shall be allowed to accompany the inspector while the inspector is in the employee's agency/department. The employee so designated shall suffer no loss of pay when this function is performed during the employee's regularly scheduled work hours.

  • SITE INSPECTION Where a site inspection is required by the Bid Specifications or Project Definition, Bidder shall be required to inspect the site, including environmental or other conditions for pre-existing deficiencies that may affect the installed Product, equipment, or environment or services to be provided and, which may affect Bidder’s ability to properly deliver, install or otherwise provide the required Product. All inquiries regarding such conditions shall be made in writing. Bidder shall be deemed to have knowledge of any deficiencies or conditions which such inspection or inquiry might have disclosed. Bidder must provide a detailed explanation with its Bid if additional work is required under this clause in order to properly complete the delivery and installation of the required Product or provide the requested service.

  • Property Inspection The Servicer is required to inspect each Delinquent Mortgaged Property at such time and in such manner as is in accordance with Prudent Servicing Practices. The Servicer must prepare a Property Inspection Report following each inspection. All Property Inspection Reports must be retained by the Servicer and copies thereof must be forwarded to the Master Servicer promptly upon request. All expenses related to the foregoing shall be recoverable by the Servicer from the Principal or from Liquidation Proceeds, Insurance Proceeds, payments on the related Mortgage Loan or any other source relating to the related Mortgage Loan or the related Mortgaged Property. The foregoing shall not preclude the Servicer from recovering such expenses from the Borrower to the extent permitted by applicable law and the related Mortgage Loan Documents.

  • Final Inspection The Contractor shall complete the list of items identified on the Pre-Final Punchlist prior to requesting a Final Inspection. Unless otherwise specified, or otherwise agreed in writing by the parties as documented on the Certificate of Substantial Completion, the Contractor shall complete and/or correct all Work within thirty (30) days of the Substantial Completion date. Upon completion of the Pre-Final Punchlist work, the Contractor shall give written notice to the ODR and A/E that the Work will be ready for Final Inspection on a specific date. The Contractor shall accompany this notice with a copy of the updated Pre-Final Punchlist indicating resolution of all items. On the date specified or as soon thereafter as is practicable, the ODR, A/E and the Contractor will inspect the Work. The A/E will submit to the Contractor a Final Punchlist of open items that the inspection team requires corrected or completed before final acceptance of the Work.

Time is Money Join Law Insider Premium to draft better contracts faster.