Preparation of Progress Payment Request Form. Agreement on the preparation of a progress payment request form: the General Contract Terms shall apply.
Preparation of Progress Payment Request Form Sample Clauses
Related to Preparation of Progress Payment Request Form
Payment Request The Contractor shall ensure a payment request includes documentation appropriate to the type of payment request in accordance with the payment clause, contract financing clause, or Federal Acquisition Regulation 52.216-7, Allowable Cost and Payment, as applicable.
Application for Payment The form acceptable to Owner that is to be used by the Contractor during the course of the Work in requesting payment from the Owner and that is to be accompanied by such supporting documentation as is required by the Contract Documents.
Payment Requests Review applications for payment with Contractor for compliance with the established procedure for their submission and forward with recommendations to Engineer, noting particularly the relationship of the payment requested to the schedule of values, Work completed, and materials and equipment delivered at the Site but not incorporated in the Work.
Request for Payment Payment to the Grantee shall be due 30 calendar days following receipt by the City of the Grantee’s fully and accurately completed payment request, using the City’s contract management system. The payment request must be submitted to the City no later than 11:59 p.m. Central Standard Time 25 calendar days following the end of the month covered by the payment request. If the 25th calendar day falls on a weekend or holiday, as outlined in Section 8.24, the deadline to submit the payment request is extended to no later than 11:59 p.m. Central Standard Time of the 1st weekday immediately following the weekend or holiday.
PROGRESS PAYMENT 9.2.1 City shall retain five percent (5%) of the undisputed amount due on each progress payment, or the percentage stated in the Notice Inviting Bids, whichever is greater, as retention to ensure full and complete performance of the Work. Subject to City’s right of withholding under Paragraph 9.4.2 of these General Conditions, City agrees to pay to Contractor within thirty (30) Days of receipt of a properly submitted Application for Payment an amount equal to ninety-five percent (95%), or a lesser amount if corresponding to a higher retention percentage, if applicable, of the sum of the following, excepting therefrom any amounts which are disputed by City: (i) Construction Manager’s determination of the value, expressed as a percentage of the Contract Sum, of the Work in permanent place that has been tested and accepted as of the end of the preceding month. (ii) Construction Manager’s determination of the value of materials suitably stored but not yet incorporated into the Work, subject to Paragraph 9.3.6 of these General Conditions. (iii) Less amounts previously paid. 9.2.2 At any Time after fifty percent (50%) of the Work has been determined by Construction Manager to be completed, City may in its sole discretion, make any of the remaining progress payments in accordance with the calculation in Paragraph 9.2.1 of these General Conditions based on one hundred percent (100%) of City’s determination of the value of the Work in place and of stored materials not yet incorporated into the Work. 9.2.3 Progress payments shall not be construed as City's Acceptance of any or all of the Work and shall not be a waiver of any or all rights City has under the Contract Documents.
Application Form To apply for a pole attachment or conduit occupancy license under this Agreement, Applicant shall submit to SWBT two signed copies of the appropriate application forms. SWBT represents that the forms specified in subsections (a)-(b) are forms in use prior to the effective date of this Agreement and that SWBT is in the process of revising such forms to conform to the provisions of this Agreement and to streamline the application process. The parties therefore agree that the forms specified in subsections (a) and (b) will be interim forms only. SWBT reserves the right to change the format and content of these forms upon 60 days written notice to Applicant. (a) To apply for a pole attachment license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make- Ready Authorization”) together with completed Form SW-9433 (“Pole Attachments”). An application for a pole attachment license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9433 and SW-9434 are attached to this Agreement as parts of APPENDIX III. (b) To apply for a conduit occupancy license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make-Ready Authorization”) together with completed Form SW-9435 (“Conduit Occupancy”). An application for a conduit occupancy license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9434 and SW-9435 are attached to this Agreement as parts of APPENDIX III. (c) Each application for a license under this Agreement shall include, at a minimum, the following information: (1) the poles, ducts, and conduits (including all manholes) along Applicant’s proposed route to or within which Applicant desires to attach or place its facilities; (2) a description of the facilities to be attached to SWBT’s poles and a description of the facilities to be placed within each component of SWBT’s conduit system (including but not limited to ducts, conduits, manholes, and handholes) along the proposed route; (3) for poles, the proposed points of attachment; (4) for building entrance or building distribution ducts or conduits or other space within a building, a conspicuous statement, as required by Section 5.06 of this Agreement, that the application pertains to a building entrance or building distribution duct or conduit or other space within a building; (5) if applicable, a conspicuous notation that the space requested is not to be assigned (or billed) to Applicant until SWBT has received Applicant’s written instruction to make such assignment or issued a license authorizing Applicant to occupy the space requested; and (6) if applicable, a conspicuous statement that Applicant intends to occupy the space before the issuance of a license, as provided in Section 8.03 of this Agreement. (d) Facilities descriptions which apply to multiple pole attachments or conduit occupancies need only be described once on any form. Facilities descriptions shall include, at a minimum, the following information: (1) the number and types of cables, including the physical size (diameter) and weight (weight per foot); (2) the number and types of strands, if any, which will be used to support the cables, including the rated holding capacity expressed in thousand pound increments (e.g., 2.2M) of such strands; and (3) sufficient information to identify and describe the physical characteristics (size, dimensions, and weight) of apparatus enclosures and other facilities to be attached to SWBT’s poles or placed in SWBT’s conduit system. (e) When it appears to Applicant that facilities modification, capacity expansion, or make-ready work may be required to accommodate Applicant’s access requests, Applicant shall describe the facilities modification, capacity expansion, or make-ready work which Applicant proposes. Applicant shall also describe its plans, if any, to use any infrequent construction technique or connectivity solution authorized under Section 6.03 to avoid high or unusual expenditures and state its reasons for the use of such technique or solution. (f) Applicant acknowledges that the poles along a particular pole line or route may include poles owned by firms (such as electric utilities) other than SWBT, that it may be necessary for SWBT to rearrange its facilities or perform other make-ready work on poles other than poles it owns or controls in order to accommodate Applicant’s request for access to SWBT’s poles and that, at the time an application is submitted, it may be difficult for Applicant to determine with certainty whether a particular pole is owned or controlled by SWBT or by another entity. Accordingly, the application shall, to the extent feasible, identify all poles utilized by SWBT (without regard to ownership) along Applicant’s proposed route. (g) Each application for a license under this Agreement shall be accompanied by a construction schedule showing Applicant’s projected dates for beginning and completing construction at the sites specified in the application. Information on this schedule may be used by SWBT’s engineering and outside plant construction personnel in scheduling work required to process Applicant’s applications and scheduling such capacity expansions, make- ready work, and facilities modifications, if any, as may be necessary to accommodate Applicant’s facilities. (h) Applicant may include multiple cables in a single license application and may provide multiple services (e.g., CATV and non-CATV services) under the same cable sheath or jacket. When both CATV and non-CATV services are provided under the same cable sheath or jacket, or CATV and non-CATV services are provided using different cables attached or lashed to the same strand or otherwise occupying the same space on a pole or the same duct or inner duct within a conduit, Applicant will so advise SWBT and SWBT shall, if permitted by law, adjust its charges to enable SWBT to charge Applicant the rate applicable to telecommunications carriers rather than the rate applicable to cable television systems solely to provide cable service.
BACKGROUND STATEMENT The Borrower has requested that the Lenders make available a revolving credit facility in the aggregate principal amount of $400,000,000. The Lenders are willing to make available to the Borrower the revolving credit facility provided for herein subject to and on the terms and conditions set forth in this Agreement.
Progress Report By March 1 of each year, ***** will submit a written annual report to Stanford covering the preceding calendar year. The report will include information sufficient to enable Stanford to satisfy reporting requirements of the U.S. Government and for Stanford to ascertain progress by ***** toward meeting this Agreement’s diligence requirements. Each report will describe, where relevant: *****’s progress toward commercialization of Licensed Product, including work completed, key scientific discoveries, summary of work-in-progress, current schedule of anticipated events or milestones, market plans for introduction of Licensed Product, and significant corporate transactions involving Licensed Product. ***** will specifically describe how each Licensed Product is related to each Licensed Patent.
INSTRUCTIONS FOR COMPLETING REPAYMENT ELECTION FORM AND EXERCISING REPAYMENT OPTION Capitalized terms used and not defined herein have the meanings defined in the accompanying Repayment Election Form.
Applications for Payment 9.3.1 At least ten days before the date for each progress payment established in the State- Contractor Agreement, the Contractor shall submit to the Architect an itemized Application for Payment, notarized if required, supported by such data substantiating the Contractor's right to payment as the State or the Architect may require. The application for payment must, at a minimum, reflect retainage and the required waivers of lien and any other support documentation enumerated elsewhere in the Contract Documents. 9.3.2 Unless otherwise provided in the Contract Documents, payments will be made on account of materials or equipment not incorporated in the Work but delivered and suitably stored at the site and, if approved in advance by the State, payments may similarly be made for materials or equipment suitably stored at some other location agreed upon in writing. Payments for materials or equipment stored on or off the site shall be conditioned upon submission by the Contractor of bills of sale or such other procedures satisfactory to the State to establish the State's title to such materials or equipment or otherwise protect the State's interest, including applicable insurance and transportation to the site for those materials and equipment stored off the site. 9.3.3 The Contractor warrants that title to all Work, materials and equipment covered by an Application for Payment will pass to the State either by incorporation in the construction or upon the receipt of payment by the Contractor, whichever occurs first, free and clear of all liens, claims, security interests or encumbrances, hereinafter referred to in this Article 9 as "liens"; and that no Work, materials or equipment covered by an Application for Payment will have been acquired by the Contractor, or by any other person performing Work at the site or furnishing materials and equipment for the Project, subject to an agreement under which an interest therein or an encumbrance thereon is retained by the seller or otherwise imposed by the Contractor or such other person.
