Prices and Services Billing 8.1 SCHEDULE OF PRICES AND TERMS Competitive Supplier agrees to provide Firm Full-Requirements Power Supply and other related services as expressly set forth herein in accordance with the prices and terms included in EXHIBIT A to this ESA, which exhibit is hereby incorporated by reference into this ESA.
000 GRIEVANCE PROCEDURE 7. 100 It is agreed that it is the spirit and intent of this Agreement to adjust grievances promptly. All grievances, including discharge for just cause, but not those pertaining to jurisdictional disputes that may arise on any work covered by this Agreement, must be initiated within fifteen (15) working days of the incident by either the employee in Step I or the Local Union in Step II and shall be handled in the following manner:
Mechanisms for Cooperation Pursuant to Article 149 (Objectives), the Parties hereby establish a Committee on Cooperation comprising representatives of each Party.
ORDERING PROCEDURE Orders placed against this contract may be in the form of an agency issued purchase order on an as-required basis. Or an agency may also use the Arkansas State Purchasing Card (P- Card) to purchase furniture.
Quality of Work Consultant agrees that all Services performed under this Agreement will conform to the specifications of the College, be free from errors and be of professional quality according to applicable industry standards. Upon notice by the College, Consultant will promptly correct any defects without charge to the College.
Requirements for Protection In compliance with NPCC requirements and Good Utility Practice, Developer shall provide, install, own, and maintain relays, circuit breakers and all other devices necessary to remove any fault contribution of the Large Generating Facility to any short circuit occurring on the New York State Transmission System not otherwise isolated by Connecting Transmission Owner’s equipment, such that the removal of the fault contribution shall be coordinated with the protective requirements of the New York State Transmission System. Such protective equipment shall include, without limitation, a disconnecting device or switch with load- interrupting capability located between the Large Generating Facility and the New York State Transmission System at a site selected upon mutual agreement (not to be unreasonably withheld, conditioned or delayed) of the Developer and Connecting Transmission Owner. Developer shall be responsible for protection of the Large Generating Facility and Developer’s other equipment from such conditions as negative sequence currents, over- or under-frequency, sudden load rejection, over- or under-voltage, and generator loss-of-field. Developer shall be solely responsible to disconnect the Large Generating Facility and Developer’s other equipment if conditions on the New York State Transmission System could adversely affect the Large Generating Facility.
Procedures for Providing NP Through Full NXX Code Migration Where a Party has activated an entire NXX for a single Customer, or activated at least eighty percent (80%) of an NXX for a single Customer, with the remaining numbers in that NXX either reserved for future use by that Customer or otherwise unused, if such Customer chooses to receive Telephone Exchange Service from the other Party, the first Party shall cooperate with the second Party to have the entire NXX reassigned in the LERG (and associated industry databases, routing tables, etc.) to an End Office operated by the second Party. Such transfer will be accomplished with appropriate coordination between the Parties and subject to appropriate industry lead times for movements of NXXs from one switch to another. Neither Party shall charge the other in connection with this coordinated transfer.
Benchmarks for Measuring Accessibility For the purposes of this Agreement, the accessibility of online content and functionality will be measured according to the W3C’s Web Content Accessibility Guidelines (WCAG) 2.0 Level AA and the Web Accessibility Initiative Accessible Rich Internet Applications Suite (WAI-ARIA) 1.0 for web content, which are incorporated by reference.
Use of Subservicers and Subcontractors (a) The Master Servicer shall cause any Subservicer used by the Master Servicer (or by any Subservicer) for the benefit of the Depositor to comply with the provisions of Section 3.16 and this Article XI to the same extent as if such Subservicer were the Master Servicer (except with respect to the Master Servicer's duties with respect to preparing and filing any Exchange Act Reports or as the Certifying Person). The Master Servicer shall be responsible for obtaining from each Subservicer and delivering to the Depositor any servicer compliance statement required to be delivered by such Subservicer under Section 3.16, any assessment of compliance and attestation required to be delivered by such Subservicer under Section 11.07 and any certification required to be delivered to the Certifying Person under Section 11.05 as and when required to be delivered. As a condition to the succession to any Subservicer as subservicer under this Agreement by any Person (i) into which such Subservicer may be merged or consolidated, or (ii) which may be appointed as a successor to any Subservicer, the Master Servicer shall provide to the Depositor, at least 15 calendar days prior to the effective date of such succession or appointment, (x) written notice to the Depositor of such succession or appointment and (y) in writing and in form and substance reasonably satisfactory to the Depositor, all information reasonably requested by the Depositor in order to comply with its reporting obligation under Item 6.02 of Form 8-K.
(b) It shall not be necessary for the Master Servicer, any Subservicer or the Trustee to seek the consent of the Depositor or any other party hereto to the utilization of any Subcontractor. The Master Servicer or the Trustee, as applicable, shall promptly upon request provide to the Depositor (or any designee of the Depositor, such as the Master Servicer or administrator) a written description (in form and substance satisfactory to the Depositor) of the role and function of each Subcontractor utilized by such Person (or in the case of the Master Servicer or any Subservicer), specifying (i) the identity of each such Subcontractor, (ii) which (if any) of such Subcontractors are "participating in the servicing function" within the meaning of Item 1122 of Regulation AB, and (iii) which elements of the Servicing Criteria will be addressed in assessments of compliance provided by each Subcontractor identified pursuant to clause (ii) of this paragraph. As a condition to the utilization of any Subcontractor determined to be a Reporting Subcontractor, the Master Servicer or the Trustee, as applicable, shall cause any such Subcontractor used by such Person (or in the case of the Master Servicer or any Subservicer) for the benefit of the Depositor to comply with the provisions of Sections 11.07 and 11.09 of this Agreement to the same extent as if such Subcontractor were the Master Servicer (except with respect to the Master Servicer's duties with respect to preparing and filing any Exchange Act Reports or as the Certifying Person) or the Trustee, as applicable. The Master Servicer or the Trustee, as applicable, shall be responsible for obtaining from each Subcontractor and delivering to the Depositor and the Master Servicer, any assessment of compliance and attestation required to be delivered by such Subcontractor under Section 11.05 and Section 11.07, in each case as and when required to be delivered.
ORDERING PROCEDURES All task orders under OASIS SB must:
1. Be awarded by an OCO with a Delegation of Procurement Authority (DPA) or by a Contractor authorized to use the OASIS SB Contracts as a Government Source of Supply
2. Be within the scope of Section C and all other terms and conditions of the OASIS SBcontract
3. Be solicited and awarded under the proper NAICS Code and corresponding OASIS SB MA-IDIQ Contract Number (See Section H.4.)
4. Identify the proper Product Service Code (See Section H.5.) and,
5. Comply with the OASIS SB Contract, OASIS SB DPA Training, OASIS SB Ordering Guide, the Ordering Procedures in FAR Subpart 16.505, Ordering, and other applicable agency specific regulatorysupplements
