Prohibited Substances Not to use or consume in or about the Property at any time any of the drugs mentioned in the Misuse of Drugs Act 1971 or any other controlled substances the use of which may hereinafter be prohibited or restricted.
Controlled Substance Bodily injury" or "property damage" arising out of the use, sale, manufacture, delivery, transfer or possession by any person of a Controlled Substance as defined by the Federal Food and Drug Law at 21 U.S.C.A. Sections 811 and 812. Controlled Substances include but are not limited to cocaine, LSD, marijuana and all nar- cotic drugs. However, this exclusion does not apply to the legitimate use of prescription drugs by a person following the orders of a licensed physician.
Controlled Substances Has current controlled substances registrations issued by the State of Colorado and the U.S. Drug Enforcement Administration, which registrations have not been surrendered, suspended, revoked or restricted in any manner;
Hazardous Material Such Obligor will not, and will not permit any of its Subsidiaries to, use, generate, manufacture, install, treat, release, store or dispose of any Hazardous Material, except in compliance with all applicable Environmental Laws or where the failure to comply could not reasonably be expected to result in a Material Adverse Change.
PROHIBITED DECKING AREAS Purchaser shall not deck right-of-way timber in the following areas: Within the grubbing limits. Within 50 feet of any stream. In locations that interfere with the construction of the road prism. In locations that impede drainage. On slopes greater than 40%. Against standing trees unless approved by the Contract Administrator.
Hazardous Substance Hazardous Substance" shall mean any chemical, substance, material, or waste, including without limitation asbestos, PCBs and formaldehyde, that is defined, classified, listed, or designated as hazardous, toxic, or radioactive, or by other similar term, by any federal, state, or local environmental statute, regulation, rule, order, or ordinance presently in effect.
PROHIBITED DISPOSAL AREAS Purchaser shall not place organic debris in the following areas: Within 50 feet of a cross drain culvert. Within 100 feet of a live stream, or wetland. On road subgrades, or excavation and embankment slopes. On slopes greater than 45%. Within the operational area for cable landings where debris may shift or roll. On locations where brush can fall into the ditch or onto the road surface. Against standing timber.
342 Hazardous Substances Purchaser shall notify the National Response Center and Contracting Officer of all releases of reportable quantities of hazardous substances on or in the vicinity of Sale Area that are caused by Purchaser’s employees, agents, contractors, Subcontractors, or their employees or agents, directly or indirectly, as a result of Purchaser’s Operations, in accordance with 40 CFR 302.
Prohibition Against Selecting and Installing Products Containing Hazardous Materials The Contractor shall not select, install or otherwise incorporate any products or materials containing Hazardous Materials within the boundaries of the Site. Should the Contractor or any Subcontractors have knowledge that, or believe that, an item, component, material, substance, or accessory within a product or assembly selected by the Contractor or any Subcontractor may contain Hazardous Materials it is the Contractor’s responsibility to secure a written certification from the manufacturer of any suspected material which identifies the specific Hazardous Material(s) contained, together with the Material Safety Data Sheets (MSDS) for such materials which shall be submitted to the Owner and Design Professional.
Chemical Substances Supplier warrants that: (i) each chemical substance contained in Products is on the inventory of chemical substances compiled and published by the Environmental Protection Agency pursuant to the Toxic Substances Control Act and (ii) all Material Safety Data Sheets required to be provided by Supplier for Products shall be provided to DXC prior to shipment of the Products and shall be complete and accurate.