Solid Waste Solid Waste collection shall be pursuant to Town regulations.
Waste Disposal Tenant shall store its waste either inside the Premises or within outside trash enclosures that are fully fenced and screened in compliance with all Private Restrictions, and designed for such purpose. All entrances to such outside trash enclosures shall be kept closed, and waste shall be stored in such manner as not to be visible from the exterior of such outside enclosures. Tenant shall cause all of its waste to be regularly removed from the Premises at Tenant’s sole cost. Tenant shall keep all fire corridors and mechanical equipment rooms in the Premises free and clear of all obstructions at all times.
Fraud, Waste, and Abuse Contractor understands that HHS does not tolerate any type of fraud, waste, or abuse. Violations of law, agency policies, or standards of ethical conduct will be investigated, and appropriate actions will be taken. Pursuant to Texas Government Code, Section 321.022, if the administrative head of a department or entity that is subject to audit by the state auditor has reasonable cause to believe that money received from the state by the department or entity or by a client or contractor of the department or entity may have been lost, misappropriated, or misused, or that other fraudulent or unlawful conduct has occurred in relation to the operation of the department or entity, the administrative head shall report the reason and basis for the belief to the Texas State Auditor’s Office (SAO). All employees or contractors who have reasonable cause to believe that fraud, waste, or abuse has occurred (including misconduct by any HHS employee, Grantee officer, agent, employee, or subcontractor that would constitute fraud, waste, or abuse) are required to immediately report the questioned activity to the Health and Human Services Commission's Office of Inspector General. Contractor agrees to comply with all applicable laws, rules, regulations, and System Agency policies regarding fraud, waste, and abuse including, but not limited to, HHS Circular C-027. A report to the SAO must be made through one of the following avenues: ● SAO Toll Free Hotline: 1-800-TX-AUDIT ● SAO website: xxxx://xxx.xxxxx.xxxxx.xx.xx/ All reports made to the OIG must be made through one of the following avenues: ● OIG Toll Free Hotline 0-000-000-0000 ● OIG Website: XxxxxxXxxxxXxxxx.xxx ● Internal Affairs Email: XxxxxxxxXxxxxxxXxxxxxxx@xxxx.xxxxx.xx.xx ● OIG Hotline Email: XXXXxxxxXxxxxxx@xxxx.xxxxx.xx.xx. ● OIG Mailing Address: Office of Inspector General Attn: Fraud Hotline MC 1300 P.O. Box 85200 Austin, Texas 78708-5200
Musculoskeletal Injury Prevention and Control The hospital in consultation with the Joint Health and Safety Committee (JHSC) shall develop, establish and put into effect, musculoskeletal prevention and control measures, procedures, practices and training for the health and safety of employees.
Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.
Contract Amendments No amendment to or modification or other alteration of the Contract shall be valid or binding upon the State unless made in writing, signed by both parties and, if applicable, approved by the Connecticut Attorney General.
Change Orders and Contract Amendments 33.1 The Procuring Entity may at any time order the Supplier through notice in accordance GCC Clause 8, to make changes within the general scope of the Contract in any one or more of the following:
a) drawings, designs, or specifications, where Goods to be furnished under the Contract are to be specifically manufactured for the Procuring Entity;
b) the method of shipment or packing;
c) the place of delivery; and
d) the Related Services to be provided by the Supplier.
33.2 If any such change causes an increase or decrease in the cost of, or the time required for, the Supplier's performance of any provisions under the Contract, an equitable adjustment shall be made in the Contract Price or in the Delivery/Completion Schedule, or both, and the Contract shall accordingly be amended. Any claims by the Supplier for adjustment under this Clause must be asserted within twenty-eight (28) days from the date of the Supplier's receipt of the Procuring Entity's change order.
33.3 Prices to be charged by the Supplier for any Related Services that might be needed but which were not included in the Contract shall be agreed upon in advance by the parties and shall not exceed the prevailing rates charged to other parties by the Supplier for similar services.
Electrical appliance safety The Hirer shall ensure that any electrical appliances brought by them to the premises and used there shall be safe, in good working order, and used in a safe manner in accordance with the Electricity at Work Regulations 1989. Where a residual circuit breaker is provided the hirer must make use of it in the interests of public safety.
Waste and Nuisance (a) Tenant shall not commit or permit any waste, including waste as it is defined in the Waste Management Act, S.B.C. 1979 c.41, as amended from time to time, to be brought upon, kept, or used in or about the Premises, the Building, or the Project by Tenant, its agents, employees, contractors or invitees, without the prior written consent of Landlord.
(b) Tenant shall not commit or permit any damage to the Premises, the Building, or the Project, including the Leasehold improvements and trade fixtures therein.
(c) Tenant shall not commit or permit any nuisance in or around the Premises, the Building, or the Project or any use or manner of use causing annoyance to other persons.
(d) Except only as may be otherwise permitted under Subsection 1.9(h) below, Tenant shall not use or permit to be used any part of the Premises, the Building, or the Project for any trade or business which is, in the reasonable opinion of Landlord, dangerous, noxious or offensive.
(e) Except only as may be otherwise permitted under Subsection 1.9(h) below, Tenant shall not cause or suffer or permit any waste, oil or grease or any harmful, objectionable, dangerous, poisonous or explosive matter or substance to be discharged into the Premises, the Building, or the Project.
(f) Tenant shall not place any objects on or otherwise howsoever obstruct the heating or air conditioning vents within the Premises or the Building.
(g) Tenant shall keep the Premises free of debris, anything which could create a fire hazard (through undue load on electrical circuits or otherwise) or cause undue vibration, heat or noise.
(h) Except as necessary to the ordinary operation of Tenant’s business conducted in compliance with all applicable laws, rules and regulations, Tenant shall keep the Premises free of rodents, vermin and anything of a dangerous, noxious or offensive nature. Tenant shall at all times keep Landlord informed of the presence in the Premises of any rodents or vermin or anything of a dangerous, noxious or offensive nature necessary to the ordinary operation of Tenant’s business conducted in compliance with all applicable laws, rules and regulations, and Tenant shall ensure that they are at all times confined within the Premises, stored and used in compliance with all applicable laws, rules and regulations, and do not cause any nuisance or annoyance to other persons.
OCCUPATIONAL HEALTH AND SAFETY 34.01 The parties recognize the need for a safe and healthy workplace. The Employer shall be responsible for providing safe and healthy working conditions. The Employer and Employees will take all reasonable steps to eliminate, reduce or minimize all workplace safety hazards. Occupational health and safety education, training and instruction provided by the Employer, shall be paid at the Basic Rate of Pay, to fulfill the requirements for training, instruction or education set out in the Occupational Health and Safety Act, Regulation or Code.
(a) There shall be an Occupational Health and Safety Committee (Committee), which shall be composed of representatives of the Employer and representatives of the Local and may include others representing recognized functional bargaining units. This Committee shall meet once a month, and in addition shall meet within 10 days of receiving a written complaint regarding occupational health or safety. An Employee shall be paid the Employee’s Basic Rate of Pay for attendance at Committee meetings. A request to establish separate committees for each site or grouping of sites shall not be unreasonably denied. The Employer shall provide training at no cost to all Employees on the Committee to assist them in performing their duties on the Committee. Training shall be paid at the Employee’s Basic Rate of Pay.
(b) Minutes of each meeting shall be taken and shall be approved by the Employer, the Local, and other bargaining groups, referred to in (a), prior to circulation.
(c) The purpose of the Committee is to consider such matters as occupational health and safety and the Local may make recommendations to the Employer in that regard.
(d) If an issue arises regarding occupational health or safety, the Employee or the Local shall first seek to resolve the issue through discussion with the applicable immediate supervisor in an excluded management position. If the issue is not resolved satisfactorily, it may then be forwarded in writing to the Committee.
(e) The Committee shall also consider measures necessary to ensure the security of each Employee on the Employer’s premises and the Local may make recommendations to the Employer in that regard.
(f) (i) Should an issue not be resolved by the Committee, the issue shall be referred to the Chief Executive Officer (CEO). A resolution meeting between the Local and the CEO, or designate(s), shall take place within 21 calendar days of the issue being referred to the CEO. The CEO or designate(s) shall reply in writing to the Local within seven (7) calendar days of the resolution meeting.
