Common use of RESS retention Clause in Contracts

RESS retention. Compliance shall be determined by visual inspection Figure 1 Material: metal, except where otherwise specified Linear dimensions in millimetres Tolerances on dimensions without specific tolerance: (a) On angles: 0/-10° (b) On linear dimensions: up to 25 mm: 0/-0.05 mm over 25 mm:

Appears in 1 contract

Samples: Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles

AutoNDA by SimpleDocs

RESS retention. Compliance shall be determined by visual inspection inspection. Figure 1 Material: metal, except where otherwise specified Linear dimensions in millimetres millimeters Tolerances on dimensions without specific tolerance: (a) On angles: 0/-10° (b) On linear dimensions: up to 25 mm: 0/-0.05 mm over 25 mm:: ±0.2 mm

Appears in 1 contract

Samples: Agreement Concerning the Adoption of Uniform Conditions of Approval and Reciprocal Recognition of Approval for Motor Vehicle Equipment and Parts

RESS retention. Compliance shall be determined by visual inspection Figure 1 Material: metal, except where otherwise specified Linear dimensions in millimetres Tolerances on dimensions without specific tolerance: (a) On angles: 0/-10° (b) On linear dimensions: : (i) up to 25 mm: 0/-0.05 mm over 25 mm:

Appears in 1 contract

Samples: Proposal for Amendments to Existing Vehicle Regulations

RESS retention. Compliance shall be determined by visual inspection Figure 1 Jointed test finger (IPXXB) Material: metal, except where otherwise specified Linear dimensions in millimetres Tolerances on dimensions without specific tolerance: (a) On angles: 0/-10° (b) On linear dimensions: up to 25 mm: 0/-0.05 mm over 25 mm:: ±0.2 mm

Appears in 1 contract

Samples: Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles

AutoNDA by SimpleDocs

RESS retention. Compliance shall be determined by visual inspection Figure 1 Material: metal, except where otherwise specified Linear dimensions in millimetres Tolerances on dimensions without specific tolerance: (a) On on angles: 0/-10° (b) On on linear dimensions: up to 25 mm: 0/-0.05 mm over 25 mm:

Appears in 1 contract

Samples: Proposal for Amendments to Existing Vehicle Regulations

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!