DEFECTIVE GOODS 20.1 Notwithstanding any certificate and/or receipt that may have been issued by or on behalf of Transnet either in South Africa or overseas, Goods will be accepted at the place of delivery or at the port of shipment, as specified in this Agreement, only as regards outward condition of packages and Transnet retains the right to reject the Goods supplied, on or after arrival at the place to which they are consigned, or after they have been placed in use in South Africa, should they be found defective.
Nonconforming Work 23.1.1 Developer shall promptly remove from Premises all Work identified by District as failing to conform to the Contract Documents whether incorporated or not. Developer shall promptly replace and re-execute its own Work to comply with the Contract Documents without additional expense to the District and shall bear the expense of making good all work of other contractors destroyed or damaged by any removal or replacement pursuant hereto and/or any delays to the District or other contractors caused thereby.
Product Warranty Seller provides general warranties of fitness and general warranties that the goods are free from defects, for 1 year from acceptance of the goods, except as may otherwise be set forth in the Description/Proposal, or other attached warranty.
Product Warranty Claims When we receive a valid warranty claim for an HP hardware or software product, HP will either repair the relevant defect or replace the product. If HP is unable to complete the repair or replace the product within a reasonable time, Customer will be entitled to a full refund upon the prompt return of the product to HP (if hardware) or upon written confirmation by Customer that the relevant software product has been destroyed or permanently disabled. HP will pay for shipment of repaired or replaced products to Customer and Customer will be responsible for return shipment of the product to HP.
Correction of Defective Work 2.10.1 Design-Builder agrees to correct any Work that is found to not be in conformance with the Contract Documents, including that part of the Work subject to Section 2.9 hereof, within a period of one year from the date of Substantial Completion of the Work or any portion of the Work, or within such longer period to the extent required by the Contract Documents.
LOST, STOLEN OR DAMAGED CARDS If the Cardmember loses the Card or if the Card is damaged or stolen or if the PIN became available to any other persons, the Cardmember must immediately inform AEME by telephone. In addition, the Cardmember shall provide AEME with a written notification within 3 days from the date of the occurrence of any of the above listed events, as per applicable laws. All notices pursuant to this article must be sent to the following address: AMEX (Middle East) B.S.C. (c), P.O. Box 5990, Manama, Kingdom of Bahrain. Or facsimile number: (+000) 00 000000. To inform AEME by phone, call the number indicated in the Cardmember Additional Information Leaflet. If AEME is duly informed in the manner described above the Cardmember shall not be liable for any Charges made on his or her Card by any third parties after the Card has been reported lost or stolen. Failure to comply with the provisions of this article will render the Cardmember liable for all Transactions made on his or her lost or stolen Card until the time the Card is reported as lost or stolen to AEME. However, the Cardmember shall at all times be fully liable for all Charges including Cash Withdrawals even if these Charges were made by third parties if these third parties gained possession of the Card or any Supplementary Card or the PIN with the knowledge, permission, approval or other acts of the Cardmember or any Supplementary Cardmember or because of their negligence. If the Card is found after it was reported lost or stolen, the Cardmember may not use or attempt to use the Card at issue and shall immediately inform AEME which will take the appropriate action.
Defective Work Work that, for any reason, is not in compliance with the Contract Documents. Defective Work is usually identified in a Notice of Non-Compliant Work.
REPAIRED OR REPLACED PRODUCTS, PARTS, OR COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including warranties, as set forth in the Warranties clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturers’ installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.
