Reactive Power and Primary Frequency Response 9.6.1 Power Factor Design Criteria
Primary Frequency Response Developer shall ensure the primary frequency response capability of its Large Generating Facility by installing, maintaining, and operating a functioning governor or equivalent controls. The term “functioning governor or equivalent controls” as used herein shall mean the required hardware and/or software that provides frequency responsive real power control with the ability to sense changes in system frequency and autonomously adjust the Large Generating Facility’s real power output in accordance with the droop and deadband parameters and in the direction needed to correct frequency deviations. Developer is required to install a governor or equivalent controls with the capability of operating: (1) with a maximum 5 percent droop ± 0.036 Hz deadband; or (2) in accordance with the relevant droop, deadband, and timely and sustained response settings from an approved Applicable Reliability Standard providing for equivalent or more stringent parameters. The droop characteristic shall be: (1) based on the nameplate capacity of the Large Generating Facility, and shall be linear in the range of frequencies between 59 and 61 Hz that are outside of the deadband parameter; or (2) based on an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. The deadband parameter shall be: the range of frequencies above and below nominal (60 Hz) in which the governor or equivalent controls is not expected to adjust the Large Generating Facility’s real power output in response to frequency deviations. The deadband shall be implemented: (1) without a step to the droop curve, that is, once the frequency deviation exceeds the deadband parameter, the expected change in the Large Generating Facility’s real power output in response to frequency deviations shall start from zero and then increase (for under-frequency deviations) or decrease (for over-frequency deviations) linearly in proportion to the magnitude of the frequency deviation; or (2) in accordance with an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. Developer shall notify NYISO that the primary frequency response capability of the Large Generating Facility has been tested and confirmed during commissioning. Once Developer has synchronized the Large Generating Facility with the New York State Transmission System, Developer shall operate the Large Generating Facility consistent with the provisions specified in Articles 9.5.5.1 and 9.5.5.2 of this Agreement. The primary frequency response requirements contained herein shall apply to both synchronous and non-synchronous Large Generating Facilities.
Prescription Safety Glasses Prescription safety glasses will be furnished by the employer. The employer retains the authority to establish reasonable rules and procedures regarding frequency of issue, replacement of damaged glasses, limits on reimbursement costs and coordination with the employer's vision plan.
Quality Assurance Program An employee shall be entitled to leave of absence without loss of earnings from her or his regularly scheduled working hours for the purpose of writing examinations required by the College of Nurses of Ontario arising out of the Quality Assurance Program.
Local Safety Committee There shall be established in each department and/or principal place of employment (for example: institutions, hospitals, colleges, transportation department areas, Department of Natural Resources regions, etc.) a joint Safety Committee composed of Appointing Authority representatives selected by the Appointing Authority and employee representatives selected by the Union, one from each bargaining unit represented by the Union but at a minimum, a total of two (2) representatives. If more than one (1) exclusive representative exists in the department or principal place of employment, the Union will attempt to work out an arrangement with the other exclusive bargaining representative(s) to insure their input to the Committee. The chair of the Committee shall be appointed by the Appointing Authority. The Appointing Authority may consider having co-chairs, one management and one labor. The Safety Committee shall meet at least quarterly or as may be legally required and meetings shall be scheduled by the Safety Officer. Additional meetings may be called by the Safety Officer or by the Local Union or Appointing Authority as the need may arise. All Safety Committee meetings shall be held during normal day shift working hours on the Appointing Authority's premises and without loss of pay. The function of the Safety Committee will be to review reports of property damage and personal injury accidents and alleged hazardous working conditions, to provide support for a strong safety program, to review building security issues, and to review and recommend safety policies to the Appointing Authority. Normally, the Committee shall acknowledge in writing receipt of reports of alleged hazardous working conditions within thirty (30) calendar days of their submission. A copy of the Committee's recommendations, if any, to the Appointing Authority regarding the disposition of such reports shall also be provided to the individual who filed the report with the Committee. In addition, the Safety Committee will provide the filing party with a copy of the Appointing Authority's response and/or proposed actions, if any. At the request of the Local Union or Safety Committee, hazard assessments will be made available for review. Each Local Safety Committee in a facility with a laundry and/or a kitchen shall perform a routine heat survey to check temperature, humidity, and exhaust and fan systems in the laundries and kitchens. The Employer agrees to coordinate technical assistance to the Local Safety Committee upon request.
Drug and Alcohol Testing – Safety-Sensitive Functions A. Employees required to have a Commercial Driver’s License (CDL) are subject to pre-employment, post-accident, random and reasonable suspicion testing in accordance with the U.S. Department of Transportation rules, Coast Guard Regulations (46 CFR Part 16) or the Federal Omnibus Transportation Employee Testing Act of 1991. The testing will be conducted in accordance with current Employer policy.
Client Responsibility For clarity, the parties agree that in reviewing the documents referred to in clause (b) above, Patheon’s role will be limited to verifying the accuracy of the description of the work undertaken or to be undertaken by Patheon. Subject to the foregoing, Patheon will not assume any responsibility for the accuracy of any application for receipt of an approval by a Regulatory Authority. The Client is solely responsible for the preparation and filing of the application for approval by the Regulatory Authority and any relevant costs will be borne by the Client.
Designated Prescription Drug Prescribers and Pharmacies We may limit your selection of a pharmacy to a single pharmacy location and/or a single prescribing provider or practice. Those members subject to this designation include, but are not limited to, members that have a history of: • being prescribed prescription drugs by multiple providers; • having prescriptions drugs filled at multiple pharmacies; • being prescribed certain long acting opioids and other controlled substances, either in combination or separately, that suggests a need for monitoring due to: o quantities dispensed; o daily dosage range; or o the duration of therapy exceeds reasonable and established thresholds. The Amount You Pay for Prescription Drugs Our formulary includes a tiered copayment structure, which means the amount you pay for a prescription drug will vary by tier. See the Summary of Pharmacy Benefits for your copayment structure, benefit limits and the amount you pay. When you buy covered prescription drugs and diabetic equipment and supplies from a retail network pharmacy, you will be responsible for the copayment and deductible (if any) at the time of purchase. You will be responsible for paying the lower of your copayment, the retail cost of the drug, or the pharmacy allowance. Specialty prescription drugs are generally obtained from a specialty pharmacy. If you buy a specialty prescription drug from a retail network pharmacy, you will be responsible for a significantly higher out of pocket expense than if you bought the specialty drug from a specialty pharmacy. The amount you pay for the following prescription drugs is not subject to the tiered copayment structure: • Contraceptive methods; • Over-the-counter (OTC) preventive drugs; • Nicotine replacement therapy (NRT) and smoking cessation prescription drugs; • Infertility specialty prescription drugs; and • Covered diabetic equipment or supplies bought at a network pharmacy. See the Summary of Pharmacy Benefits for benefit limits and the amount you pay. This plan allows for medication synchronization in accordance with R.I. General Law
Health and Safety Representative Meetings 13.1 A health and safety representative will be allowed reasonable paid time during working hours to attend occupational health and safety matters, including meetings affecting employees they represent, providing that the Representative informs their manager.
Contractor Responsibility (a) The Contractor shall be responsible for the entire Performance under the Contract regardless of whether the Contractor itself performs. The Contractor shall be the sole point of contact concerning the management of the Contract, including Performance and payment issues. The Contractor is solely and completely responsible for adherence by the Contractor Parties to all applicable provisions of the Contract.
