Set up Promise Sample Clauses

Set up Promise. We have designed the Implementation Plan to allow us to set-up the Service for you in parallel with your existing system. This means that your existing system will remain operational throughout the Implementation Plan as well as for a period after the Implementation Plan has been completed. The Service is designed to allow fast switching between the existing system and the Service in such a way that should anything not go according to plan during the Implementation Plan; you can almost instantly switch back to using the existing system. By doing this, we promise that you will be able to receive and make calls throughout the Implementation Plan and the set-up of the Service.
Sample 1
AutoNDA by SimpleDocs

Related to Set up Promise

  • Programming Phase Schematic Design Phase: 2.2.1.3. Design Development Phase:

  • Start-Up and Synchronization Consistent with the mutually acceptable procedures of the Developer and Connecting Transmission Owner, the Developer is responsible for the proper synchronization of the Large Generating Facility to the New York State Transmission System in accordance with NYISO and Connecting Transmission Owner procedures and requirements.

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.

  • Feedback You have no obligation to provide us with ideas, suggestions, or proposals (“Feedback”). However, if you submit Feedback to us, then you grant us a non-exclusive, worldwide, royalty-free license that is sub-licensable and trans- ferable, to make, use, sell, have made, offer to sell, import, reproduce, publicly display, distribute, modify, or publicly perform the Feedback in any manner without any obligation, royalty, or restriction based on intellectual property rights or otherwise.

  • Unbundled Sub-Loop Feeder 2.8.4.1 Unbundled Sub-Loop Feeder (USLF) provides connectivity between BellSouth's central office and cross-box (or other access point) that serves an end user location. 2.8.4.2 USLF utilized for voice traffic can be configured as 2-wire voice (USLF-2W/V) or 4-wire voice (USLF-4W/V). 2.8.4.3 USLF utilized for digital traffic can be configured as 2-wire ISDN (USLF-2W/I); 2-wire Copper (USLF-2W/C); 4-wire Copper (USLF-4W/C); 4-wire DS0 level loop (USLF-4W/D0); or 4-wire DS1 and ISDN (USLF-4W/DI). 2.8.4.4 USLF will provide access to both the equipment and the features in the BellSouth central office and BellSouth cross box necessary to provide a 2W or 4W communications pathway from the BellSouth central office to the BellSouth cross- box. This element will allow for the connection of Lightyear’s loop distribution elements onto BellSouth's feeder system.

  • Unbundled Copper Loop – Designed (UCL-D) 2.4.2.1 The UCL-D will be provisioned as a dry copper twisted pair (2- or 4-wire) Loop that is unencumbered by any intervening equipment (e.g., filters, load coils, range extenders, digital loop carrier, or repeaters). 2.4.2.2 A UCL-D will be 18,000 feet or less in length and is provisioned according to Resistance Design parameters, may have up to 6,000 feet of bridged tap and will have up to 1300 Ohms of resistance. 2.4.2.3 The UCL-D is a designed circuit, is provisioned with a test point, and comes standard with a DLR. OC is a chargeable option for a UCL-D; however, OC is always required on UCLs where a reuse of existing facilities has been requested by Telepak Networks. 2.4.2.4 These Loops are not intended to support any particular services and may be utilized by Telepak Networks to provide a wide-range of telecommunications services as long as those services do not adversely affect BellSouth’s network. This facility will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the Loop to the customer’s inside wire. 2.4.2.5 Upon the Effective Date of this Agreement, Unbundled Copper Loop – Long (UCL-L) elements will no longer be offered by BellSouth and no new orders for UCL-L will be accepted. Any existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement will be grandfathered at the rates set forth in the Parties’ interconnection agreement that was in effect immediately prior to the Effective Date of this Agreement. Existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement may remain connected, maintained and repaired according to BellSouth’s TR73600 and may remain connected until such time as they are disconnected by Telepak Networks or BellSouth provides ninety

  • Interconnection Customer Obligations The Interconnection Customer shall maintain the Large Generating Facility and the Interconnection Customer’s Interconnection Facilities in a safe and reliable manner and in accordance with this LGIA.

  • Technology Upgrades Notwithstanding any other provision of this Agreement, Verizon shall have the right to deploy, upgrade, migrate and maintain its network at its discretion. The Parties acknowledge that Verizon, at its election, may deploy fiber throughout its network and that such fiber deployment may inhibit or facilitate PNG’s ability to provide service using certain technologies. Nothing in this Agreement shall limit Verizon's ability to modify its network through the incorporation of new equipment or software or otherwise. PNG shall be solely responsible for the cost and activities associated with accommodating such changes in its own network.

  • Prior Review (a) With respect to each contract for the employment of consulting firms estimated to cost the equivalent of $100,000 or more, the procedures set forth in paragraphs 1, 2 (other than the third subparagraph of paragraph 2(a)) and 5 of Appendix 1 to the Consultant Guidelines shall apply. (b) With respect to each contract for the employment of individual consultants estimated to cost the equivalent of $50,000 or more, the qualifications, experience, terms of reference and terms of employment of the consultants shall be furnished to the Association for its prior review and approval. The contract shall be awarded only after the said approval shall have been given.

  • Service Provider Obligations Service Provider shall make the Software and the Services required for provisioning the Software (Software and Services hereinafter together and individually may also be referred to as “Service” or “Services”) available to Customer as described in the Services Description and in the Services Specific Terms (together hereinafter referred to as “Services Description”) referenced in the Order Forms and according to the terms and conditions of this Agreement. Service Provider may amend the Services from time to time, provided that such amendments shall not materially diminish the overall Service. Service Provider aims to provide the Software access to Customer within two (2) working days upon the Effective Date, unless otherwise set forth in the Services Description. The Software may consist of a web application provided to Customer in form of a software as a service solution and a mobile application to be installed by Customer on its mobile device. The agreed scope and quality of the Services is exclusively set forth in the Services Description. Public statements concerning the Service made by Service Provider or its agents will only take form when expressively confirmed by Service Provider in writing. Notwithstanding section 7.1, information and specifications contained within the Services Description shall not qualify as warranty or guarantee with regards to the Service’s quality or as any other kind of guarantee, unless they have been confirmed as such by Service Provider in writing. Service Provider may update and improve the Services from time to time; any such Updates, meaning software that remedies "Defects" (as defined in section 7.4) in the Services and/or may include minor improvements of the Services, are included in the Agreement. In addition to Updates, Service Provider may offer Upgrades and/or Add-On Services to the Services, where “Upgrades” mean new capabilities or functionalities of the Services and “Add-On Services” either mean (i) new and/or additional functionality packages in form of separate modules to the Services, or (ii) integrations or connection applications with other Hilti or third party software applications. Upgrades and Add-On Services are only subject to the Agreement, if ordered separately and paid for by Customer, where additional terms and conditions may apply.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!