Specific WTA issues Sample Clauses

Specific WTA issues. The chief task of an SNC is to draw up the WTA. A WTA must specify the amount of time to be allocated to each of the contractual tasks identified in SNCT Part 2: appendix 2.7 (noted above). Specific advice relating to the timings is given below. It is strongly recommended that the WTA is accompanied by an agreed calendar of events. This allows precise calculation of the hours involved in each item contained within the WTA and is therefore most useful in preventing disputes as to how many hours teachers have worked. 3.1 Additional preparation and correction time: This is perhaps the most difficult issue to quantify. Variations do exist both within schools and between schools as to the amount of such time required by teachers. There can be no doubt, however, that current trends in the curriculum place significant demands on teacher time. This should be a minimum of 40 hours.
AutoNDA by SimpleDocs

Related to Specific WTA issues

  • Open Issues (a) Notwithstanding any provision of the Registry Agreement to the contrary (including Sections 7.6 and 7.7 thereof), Registry Operator agrees that the following requirements, procedures and provisions of the Registry Agreement (including the documents incorporated by reference therein) may be modified and amended by ICANN after the date hereof, without the consent of Registry Operator: i. Specification 6 – Registry Interoperability and Continuity Specifications; ii. Trademark Clearinghouse Requirements (§ 1 of Specification 7 of the Registry Agreement); iii. Trademark Post-­‐Delegation Dispute Resolution Procedure (§ 2.a of Specification 7 of the Registry Agreement);

  • Preference Issues If any Senior Secured Party is required in any Insolvency or Liquidation Proceeding or otherwise to disgorge, turn over or otherwise pay any amount to the estate of the Company or any other Grantor (or any trustee, receiver or similar Person therefor), because the payment of such amount was declared to be fraudulent or preferential in any respect or for any other reason, any amount (a “Recovery”), whether received as proceeds of security, enforcement of any right of setoff or otherwise, then the Senior Obligations shall be reinstated to the extent of such Recovery and deemed to be outstanding as if such payment had not occurred and the Senior Secured Parties shall be entitled to the benefits of this Agreement until a Discharge of Senior Obligations with respect to all such recovered amounts. If this Agreement shall have been terminated prior to such Recovery, this Agreement shall be reinstated in full force and effect, and such prior termination shall not diminish, release, discharge, impair or otherwise affect the obligations of the parties hereto. Each Second Priority Representative, for itself and on behalf of each Second Priority Debt Party under its Second Priority Debt Facility, hereby agrees that none of them shall be entitled to benefit from any avoidance action affecting or otherwise relating to any distribution or allocation made in accordance with this Agreement, whether by preference or otherwise, it being understood and agreed that the benefit of such avoidance action otherwise allocable to them shall instead be allocated and turned over for application in accordance with the priorities set forth in this Agreement.

  • Types of Grievances (A) An Individual Grievance is a grievance initiated by the Union on behalf of an individual employee. (B) A Group Grievance is a grievance initiated by the Union on behalf of a group of employees similarly affected by the Employer’s actions. (C) A Policy Grievance is a grievance by the Union which may involve a matter of general policy or general application of the Collective Agreement. (D) A Union Grievance is a grievance which directly affects the Union. (E) An Employer Grievance is a grievance initiated by the Employer.

  • CFR PART 200 Procurement of Recovered Materials A non-Federal entity that is a state agency or agency of a political subdivision of a state and its contractors must comply with section 6002 of the Solid Waste Disposal Act, as amended by the Resource Conservation and Recovery Act. The requirements of Section 6002 include procuring only items designated in guidelines of the Environmental Protection Agency (EPA) at 40 CFR part 247 that contain the highest percentage of recovered materials practicable, consistent with maintaining a satisfactory level of competition, where the purchase price of the item exceeds $10,000 or the value of the quantity acquired during the preceding fiscal year exceeded $10,000; procuring solid waste management services in a manner that maximizes energy and resource recovery; and establishing an affirmative procurement program for procurement of recovered materials identified in the EPA guidelines. Does vendor certify that it is in compliance with the Solid Waste Disposal Act as described above? Yes

  • DOMESTIC PREFERENCES FOR PROCUREMENTS To the extent applicable, Supplier certifies that during the term of this Contract will comply with applicable requirements of 2 C.F.R. § 200.322.

  • Year 2000 Issues Each of the Borrower and its Subsidiaries has made a full and complete assessment of the Year 2000 Issues and has a realistic and achievable program for remediating the Year 2000 Issues on a timely basis. Based on such assessment and program, the Borrower does not reasonably anticipate that Year 2000 Issues will have a Material Adverse Effect.

  • CFR PART 200 Domestic Preferences for Procurements As appropriate and to the extent consistent with law, the non-Federal entity should, to the greatest extent practicable under a Federal award, provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). The requirements of this section must be included in all subawards including all contracts and purchase orders for work or products under this award. For purposes of 2 CFR Part 200.322, “Produced in the United States” means, for iron and steel products, that all manufacturing processes, from the initial melting stag through the application of coatings, occurred in the United States. Moreover, for purposes of 2 CFR Part 200.322, “Manufactured products” means items and construction materials composed in whole or in part of non-ferrous metals such as aluminum, plastics and polymer-based products such as polyvinyl chloride pipe, aggregates such as concrete, class, including optical fiber, and lumber. Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, Vendor certifies that to the greatest extent practicable Vendor will provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). Does vendor agree? Yes

  • TECHNICAL EVALUATION (a) Detailed technical evaluation shall be carried out by Purchase Committee pursuant to conditions in the tender document to determine the substantial responsiveness of each tender. For this clause, the substantially responsive bid is one that conforms to all the eligibility and terms and condition of the tender without any material deviation. The Institute’s determination of bid’s responsiveness is to be based on the contents of the bid itself without recourse to extrinsic evidence. The Institute shall evaluate the technical bids also to determine whether they are complete, whether required sureties have been furnished, whether the documents have been properly signed and whether the bids are in order. (b) The technical evaluation committee may call the responsive bidders for discussion or presentation to facilitate and assess their understanding of the scope of work and its execution. However, the committee shall have sole discretion to call for discussion / presentation. (c) Financial bids of only those bidders who qualify the technical criteria will be opened provided all other requirements are fulfilled. (d) AIIMS Jodhpur shall have right to accept or reject any or all tenders without assigning any reasons thereof.

  • Regulatory Issues 3.3.1 The Licensee shall be solely responsible for determining which jurisdictions they choose to market to and receive xxxxxx from. 3.3.2 The Licensee shall be responsible for determining the legality of accepting xxxxxx in whichever jurisdictions they choose to market to and receive xxxxxx from. 3.3.3 The Licensee shall indemnify UNITED for any reasonable legal costs, and fines that arise as a result of the Licensee choosing to accept xxxxxx from any jurisdiction that determines or has determined that Internet wagering is illegal.

  • Other Methods of Procurement of Goods and Works. The following table specifies the methods of procurement, other than International Competitive Bidding, which may be used for goods and works. The Procurement Plan shall specify the circumstances under which such methods may be used: (a) National Competitive Bidding (b) Shopping (c) Direct Contracting

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!