Start - Up Readiness Requirements Sample Clauses

Start - Up Readiness Requirements. No more than thirty (30) days prior to the commencement date of the Contract and annually, no more than thirty (30) days prior to each school year thereafter, Vendor shall demonstrate its operational readiness to conduct smooth startup operations and satisfactorily run all runs assigned to Vendor. The Vendor shall demonstrate operational readiness and the ability to conduct satisfactory service to schools by submitting the following to STS in accordance with the schedule and timelines established by the STS:
AutoNDA by SimpleDocs

Related to Start - Up Readiness Requirements

  • Access Requirements You will be responsible for providing the System to enable you to use an Electronic Service.

  • Service Order Process Requirements 53.5.1 CenturyLink will accept orders for As-Is Transfer of services from CenturyLink to CLEC where CenturyLink is the End User’s current local exchange carrier.

  • Match Requirements There is no match required on the part of the Grantee under this Agreement.

  • Minimum System Requirements The following summarizes the minimum office system requirements for all Contractors and Architect/Engineer to possess in order to participate. It is the responsibility of all Contractors and Architect/Engineer to possess these minimum requirements at no additional cost to Princeton University.

  • Project Requirements Failure to comply with the following requirements will result in a suspension of all other operations:

  • Subcontract Requirements As required by Section 6.22(e)(5) of the Administrative Code, Contractor shall insert in every subcontract or other arrangement, which it may make for the performance of Covered Services under this Agreement, a provision that said subcontractor shall pay to all persons performing labor in connection with Covered Services under said subcontract or other arrangement not less than the highest general prevailing rate of wages as fixed and determined by the Board of Supervisors for such labor or services.

  • Test requirements 3.1. The limits apply throughout the frequency range 30 to 1,000 MHz for measurements performed in a semi anechoic chamber or an outdoor test site.

  • Customer Requirements ▪ Seller shall comply with the applicable terms and conditions of any agreements between Buyer and Xxxxx’s Customer (the “Customer Purchase Orders”) pursuant to which Buyer agreed to sell to Buyer’s Customer products or assemblies which incorporate the goods provided by Seller hereunder. This provision specifically includes costs and obligations imposed by warranty programs instituted by the original equipment manufacturer that ultimately purchases Buyer’s products that incorporate the goods sold by Seller if applicable to Buyer under the terms of the Customer Purchase Order. ▪ If Buyer is not acting as a Tier One supplier, the defined term “Customer Purchase Order” shall also include the terms and conditions of the original equipment manufacturer that ultimately purchases Buyer’s product that incorporates the goods or services sold by Seller. ▪ Seller will be responsible to ascertain how the disclosed terms affect Seller’s performance under the Purchase Order. ▪ By written notice to Seller, Buyer may elect to disclose and have the provisions of the Customer’s Purchase Orders prevail over any term of the Purchase Order at any time.

  • CONTRACT REQUIREMENTS a. NSF will exercise its responsibility for oversight and monitoring of procurements, contracts or other contractual arrangements for the purchase of materials and supplies, equipment or general support services under the award. The procedures set forth below must be followed to ensure that performance, materials and services are obtained in an effective manner and in compliance with the provisions of applicable Federal statutes and executive orders. The awardee must obtain written approval from the cognizant NSF Grants and Agreements Officer prior to entering into a contract if the amount exceeds $250,000 or other amount specifically identified in the agreement. Contracts clearly identified in the NSF award budget are considered approved at the time of award unless approval is withheld by the Grants and Agreements Officer. Contracts must be clearly identified in the NSF award budget on Line G6. Other. The threshold noted above also applies to cumulative increases in the value of the contractual arrangement after initial NSF approval. The awardee must not artificially segregate its procurements to lesser dollar amounts for the purpose of circumventing this requirement. A request to enter into a contract must include, at a minimum:

  • Purchase Order Requirements Customers shall use a Request for Quote per section 287.056(2), Florida Statutes, when making purchases off of this State Term Contract. Customers shall issue Request for Quotes to at least 25 vendors approved to provide IT Staff Augmentation services in accordance with section 287.0591(5), Florida Statutes. Customers shall order services from the Request for Quote via a Purchase Order with the Customers’ selected Contractor. The terms of the Purchase Order shall not conflict with the terms and conditions established by this Contract. In accepting a Purchase Order, the Contractor recognizes its responsibility for all tasks and deliverables contained therein, warrants that it has fully informed itself of all relevant factors affecting accomplishment of the tasks and deliverables and agrees to be fully accountable for the performance thereof.

Time is Money Join Law Insider Premium to draft better contracts faster.