Trunk Group Architecture and Traffic Routing 5.2.1 The Parties shall jointly establish Access Toll Connecting Trunks between CLEC and CBT by which they will jointly provide Tandem-transported Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic from and to CLEC's Customers. 5.2.2 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access and non-translated Toll Free traffic (e.g., 800/888) to allow CLEC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier that is connected to the CBT access Tandem. 5.2.3 The Access Toll Connecting Trunks shall be one-way or two-way trunks, as mutually agreed, connecting an End Office Switch that CLEC utilizes to provide Telephone Exchange Service and Switched Exchange Access Service in the given LATA to an access Tandem Switch CBT utilizes to provide Exchange Access in the LATA.
Business Continuity Planning Supplier shall prepare and maintain at no additional cost to Buyer a Business Continuity Plan (“BCP”). Upon written request of Buyer, Supplier shall provide a copy of Supplier’s BCP. The BCP shall be designed to ensure that Supplier can continue to provide the goods and/or services in accordance with this Order in the event of a disaster or other BCP-triggering event (as such events are defined in the applicable BCP). Supplier’s BCP shall, at a minimum, provide for: (a) the retention and retrieval of data and files; (b) obtaining resources necessary for recovery, (c) appropriate continuity plans to maintain adequate levels of staffing required to provide the goods and services during a disruptive event; (d) procedures to activate an immediate, orderly response to emergency situations; (e) procedures to address potential disruptions to Supplier’s supply chain; (f) a defined escalation process for notification of Buyer, within two (2) business days, in the event of a BCP-triggering event; and (g) training for key Supplier Personnel who are responsible for monitoring and maintaining Supplier’s continuity plans and records. Supplier shall maintain the BCP and test it at least annually or whenever there are material changes in Supplier’s operations, risks or business practices. Upon Xxxxx’s written and reasonable request, Supplier shall provide Buyer an executive summary of test results and a report of corrective actions (including the timing for implementation) to be taken to remedy any deficiencies identified by such testing. Upon Xxxxx’s request and with reasonable advance notice and conducted in such a manner as not to unduly interfere with Supplier’s operations, Supplier shall give Buyer and its designated agents access to Supplier’s designated representative(s) with detailed functional knowledge of Supplier’s BCP and relevant subject matter.
Secure Information Handling and Transfers 7.1 Physical and electronic handling, processing and transferring of DWP Data, including secure access to systems and the use of encryption where appropriate.
Training and Orientation (a) No employee shall be required to work on any job or operate any piece of equipment until he/she has received proper training and instruction. (b) The Employer shall provide sufficient and adequate training and/or orientation to any employee working in a new or unfamiliar work area or position.
Human and Financial Resources to Implement Safeguards Requirements The Borrower shall make available necessary budgetary and human resources to fully implement the EMP and the RP.
Anti-Money Laundering and Red Flag Identity Theft Prevention Programs The Trust acknowledges that it has had an opportunity to review, consider and comment upon the written procedures provided by USBFS describing various tools used by USBFS which are designed to promote the detection and reporting of potential money laundering activity and identity theft by monitoring certain aspects of shareholder activity as well as written procedures for verifying a customer’s identity (collectively, the “Procedures”). Further, the Trust and USBFS have each determined that the Procedures, as part of the Trust’s overall Anti-Money Laundering Program and Red Flag Identity Theft Prevention Program, are reasonably designed to: (i) prevent each Fund from being used for money laundering or the financing of terrorist activities; (ii) prevent identity theft; and (iii) achieve compliance with the applicable provisions of the Bank Secrecy Act, Fair and Accurate Credit Transactions Act of 2003 and the USA Patriot Act of 2001 and the implementing regulations thereunder. Based on this determination, the Trust hereby instructs and directs USBFS to implement the Procedures on the Trust’s behalf, as such may be amended or revised from time to time. It is contemplated that these Procedures will be amended from time to time by the parties as additional regulations are adopted and/or regulatory guidance is provided relating to the Trust’s anti-money laundering and identity theft responsibilities. USBFS agrees to provide to the Trust: (a) Prompt written notification of any transaction or combination of transactions that USBFS believes, based on the Procedures, evidence money laundering or identity theft activities in connection with the Trust or any Fund shareholder; (b) Prompt written notification of any customer(s) that USBFS reasonably believes, based upon the Procedures, to be engaged in money laundering or identity theft activities, provided that the Trust agrees not to communicate this information to the customer; (c) Any reports received by USBFS from any government agency or applicable industry self-regulatory organization pertaining to USBFS’ Anti-Money Laundering Program or the Red Flag Identity Theft Prevention Program on behalf of the Trust; (d) Prompt written notification of any action taken in response to anti-money laundering violations or identity theft activity as described in (a), (b) or (c) immediately above; and (e) Certified annual and quarterly reports of its monitoring and customer identification activities pursuant to the Procedures on behalf of the Trust. The Trust hereby directs, and USBFS acknowledges, that USBFS shall (i) permit federal regulators access to such information and records maintained by USBFS and relating to USBFS’ implementation of the Procedures, on behalf of the Trust, as they may request, and (ii) permit such federal regulators to inspect USBFS’ implementation of the Procedures on behalf of the Trust.
Information Technology Accessibility Standards Any information technology related products or services purchased, used or maintained through this Grant must be compatible with the principles and goals contained in the Electronic and Information Technology Accessibility Standards adopted by the Architectural and Transportation Barriers Compliance Board under Section 508 of the federal Rehabilitation Act of 1973 (29 U.S.C. §794d), as amended. The federal Electronic and Information Technology Accessibility Standards can be found at: xxxx://xxx.xxxxxx-xxxxx.xxx/508.htm.
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “ (1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “ (1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
Workplace Safety Insurance 27.1 Each member covered by this Agreement who is absent on account of injuries received while on duty and who is receiving a pension, salary or wage award from the Workplace Safety and Insurance shall be entitled to be paid the difference between the pension wage or salary award from the Workplace Safety and Insurance Board and his or her current net salary as long as such member remains in the employ of the Niagara Police Board. This shall be applied such that the combination of any WSIB salary or wage award plus the employer top-up shall, in total, equal the net pay of the member's current salary. The non-economic loss portion of any WSIB pension payments shall not be considered as being a salary or wage award, and hence shall not form part of these calculations. A member who does not comply with the provisions of the Workplace Safety & Insurance Act or Regulations thereto and subsequently receives a salary or wage award of an amount less than the prevailing maximum payable due to such non-compliance, shall not receive from the Niagara Police Board the difference between the wage or salary award paid by the Workplace Safety & Insurance Board and his or her current net salary for the said period of six (6) months. For the purpose of this Clause, net pay shall be the pay for the member as shown in Appendix "A" less those deductions required under Government Statutes, pension plans and as provided for in this Agreement. 27.2 Subject to the terms of this Article, each member covered by this Agreement who is injured as a result of carrying out his/her duties shall not be deprived of his/her vacations or statutory holidays as a result thereof, and shall accumulate such vacation credits and statutory holidays as he/she might otherwise receive. 27.2.1 Each member shall be entitled to accumulate the float time that he/she might otherwise receive for a period of three (3) months following the injury. 27.2.2 In respect of members who have been off work and receiving WSIB benefits for less than two (2) consecutive calendar years, within one week of the member's return, the member and the Chief of Police or designee shall mutually agree upon when the vacation credit, statutory holidays and float time shall be taken within the following twelve (12) months, or in the alternative, the member may elect to be paid for same at the rates of pay applicable in the year of accrual. 27.2.3 In respect of members who have been off work and receiving WSIB benefits for two
Insurance and Fingerprint Requirements Information Insurance If applicable and your staff will be on TIPS member premises for delivery, training or installation etc. and/or with an automobile, you must carry automobile insurance as required by law. You may be asked to provide proof of insurance. Fingerprint It is possible that a vendor may be subject to Chapter 22 of the Texas Education Code. The Texas Education Code, Chapter 22, Section 22.0834. Statutory language may be found at: xxxx://xxx.xxxxxxxx.xxxxx.xxxxx.xx.xx/ If the vendor has staff that meet both of these criterion: (1) will have continuing duties related to the contracted services; and (2) has or will have direct contact with students Then you have ”covered” employees for purposes of completing the attached form. TIPS recommends all vendors consult their legal counsel for guidance in compliance with this law. If you have questions on how to comply, see below. If you have questions on compliance with this code section, contact the Texas Department of Public Safety Non-Criminal Justice Unit, Access and Dissemination Bureau, FAST-FACT at XXXX@xxxxx.xxxxx.xx.xx and you should send an email identifying you as a contractor to a Texas Independent School District or ESC Region 8 and TIPS. Texas DPS phone number is (000) 000-0000. See form in the next attribute to complete entitled: Texas Education Code Chapter 22 Contractor Certification for Contractor Employees