Supplier Selection If Customer selects a seat or galley supplier that is not on the Boeing recommended list, such seat or galley will become BFE and the provisions of Exhibit A, Buyer Furnished Equipment Provisions Document, of the AGTA will apply.
Payment for Labor and Materials Borrower will promptly pay when due all bills and costs for labor, materials, and specifically fabricated materials incurred in connection with the Property and never permit to exist beyond the due date thereof in respect of the Property or any part thereof any lien or security interest, even though inferior to the liens and the security interests hereof, and in any event never permit to be created or exist in respect of the Property or any part thereof any other or additional lien or security interest other than the liens or security interests hereof, except for the Permitted Exceptions (defined in Section 5.1).
Third Party Contractors Tenant shall obtain and deliver to Landlord, Third Party Contractor’s certificates of insurance and applicable endorsements at least seven (7) business days prior to the commencement of work in or about the Premises by any vendor or any other third-party contractor (collectively, a “Third Party Contractor”). All such insurance shall (a) name Landlord as an additional insured under such party’s liability policies as required by Section 10.3.1 above and this Section 10.6, (b) provide a waiver of subrogation in favor of Landlord under such Third Party Contractor’s commercial general liability insurance, (c) be primary and any insurance carried by Landlord shall be excess and non-contributing, and (d) comply with Landlord’s minimum insurance requirements.
Sub-contractors Transfer Agent may, without further consent on the part of Customer, subcontract with other subcontractors for telephone and mailing services as may be required from time to time; provided, however, that the Transfer Agent shall be as fully responsible to the Customer for the acts and omissions of any subcontractor as it is for its own acts and omissions.
Xxxxxx Independent Contractor Xxxxxx shall be an independent contractor and neither Xxxxxx nor any of its officers or employees as such is or shall be an employee of the Fund. Xxxxxx is responsible for its own conduct and the employment, control and conduct of its agents and employees and for injury to such agents or employees or to others through its agents or employees. Xxxxxx assumes full responsibility for its agents and employees under applicable statutes and agrees to pay all employer taxes thereunder. Xxxxxx will maintain at its own expense insurance against public liability in such an amount as the Trustees of the Fund may from time to time reasonably request.
Supplier shall exercise reasonable care in carrying out the provisions of this Agreement, but shall be kept indemnified by, and shall be without liability to CMA and/or any Fund for any action taken or omitted by it in good faith without negligence including, without limitation, acting in accordance with any Proper Instruction. Supplier shall be entitled to rely on and may act upon the advice of counsel (who may be counsel for CMA or any Fund) on all matters arising in connection with the Services. At any time, Supplier may apply to any officer of CMA or a Fund for instructions and may consult with outside counsel for CMA or the applicable Fund or the independent auditors for the Fund at the expense of the Fund, or other individuals designated in writing by CMA or the Fund, for advice with respect to any matter arising in connection with the Services. Supplier shall not be liable, and shall be indemnified by each Fund or CMA, as applicable, for any action taken or omitted by it in good faith in reliance upon any such instructions or advice or upon any paper or document believed by it to be genuine and to have been signed by such officers or individuals. Supplier shall not be held to have notice of any change of authority of any officer or individual until receipt of written notice thereof from the Fund or CMA. Nothing in this Section shall be construed as imposing upon Supplier any obligation to seek such instructions or advice. Without in any way limiting the generality of the foregoing, Supplier shall in no event be liable for any loss or damage arising from causes beyond its control including, without limitation, delay or cessation of services hereunder or any damages to CMA or a Fund resulting therefrom as a result of work stoppage, power or other mechanical failure, natural disaster, governmental action, communication disruption or other impossibility of performance.
Designated Equipment; Designated Locations The System and the Data Access Services shall be used and accessed solely on and through the Designated Configuration at the offices of the Fund or the Fund Accountants in Xxxxxxxxx, Xxxxxxxx xx Xxxxxx Xxxxx, Xxxxxxxx (“Designated Locations”).
Clinical Supply Takeda will provide to Licensee[***] the amount of TAK-385 Licensed Compound or TAK-385 Licensed Products needed by Licensee to complete all Clinical Trials contemplated by the TAK-385 Development Plan (estimated by Licensee as of the Effective Date to be [***]), solely to the extent that Takeda can supply such TAK-385 [***] = Portions of this exhibit have been omitted and filed separately with the Securities and Exchange Commission. Confidential treatment requested under 17 C.F.R. Sections 200.80(b)(4) and 230.406. Licensed Compound or TAK-385 Licensed Products (a) from its supply of TAK-385 Licensed Compound or TAK-385 Licensed Products in existence as of the Effective Date and which supply can be used for its intended purposes without further re-processing (the “Initial Clinical Supply”) and (b) after retaining the amount needed by Takeda for Clinical Trials in the Takeda Territory. Takeda will also provide to Licensee, at [***] any additional supplies of TAK-385 Licensed Compound or TAK-385 Licensed Products in excess of the Initial Clinical Supply needed by Licensee to complete all Clinical Trials contemplated by the TAK-385 Development Plan. Within [***] days after the Effective Date, the Parties will enter into a manufacturing and supply agreement (the “Takeda Clinical Manufacturing and Supply Agreement”), which will govern the terms and conditions of the Manufacturing and supply of the TAK-385 Licensed Compound and TAK-385 Licensed Products (including the Initial Clinical Supply) by Takeda to Licensee for Development purposes, including the exact quantities and the timelines for delivery. The Parties will negotiate the terms and conditions of such Takeda Clinical Manufacturing and Supply Agreement in good faith for a period of [***] days (as may be extended upon agreement of the Parties). As part of the negotiation related to the Takeda Clinical Manufacturing and Supply Agreement, the Parties shall discuss in good faith the ability of Takeda to supply to Licensee [***]. If the Parties have not entered into a definitive agreement within such negotiation period, then the final terms and conditions of such agreement will be resolved in accordance with Section 8.2 (Arbitration for Failure to Agree).
Manufacturing Services Jabil will manufacture the Product in accordance with the Specifications and any applicable Build Schedules. Jabil will reply to each proposed Build Schedule that is submitted in accordance with the terms of this Agreement by notifying Company of its acceptance or rejection within three (3) business days of receipt of any proposed Build Schedule. In the event of Jabil’s rejection of a proposed Build Schedule, Jabil’s notice of rejection will specify the basis for such rejection. When requested by Company, and subject to appropriate fee and cost adjustments, Jabil will provide Additional Services for existing or future Product manufactured by Jabil. Company shall be solely responsible for the sufficiency and adequacy of the Specifications [***].
Product Testing Upon request, Customer shall provide Operator a laboratory report for each Product delivery by Customer or Customer’s supplier. Operator will not be obligated to receive Contaminated Product for throughput through the Pipelines, nor will Operator be obligated to accept Product that fails to meet the applicable quality specifications for the Berths under the BAUTA and any Terminal Service Orders issued thereunder.
