Surface Work and Operations
Surface Work and Operations Sample Clauses
Related to Surface Work and Operations
Maintenance and Operation Member-Generator agrees to maintain their system and facilities in accordance with applicable manufacturer's recommended maintenance schedule and standard prudent engineering practices. Member-Generator covenants and agrees to operate their system, facilities and equipment so as to minimize the likelihood for a malfunction or other disturbance, damaging or otherwise affecting or impairing Cooperative’s electrical system. Member-Generator shall comply with all applicable laws, regulations, zoning, building codes, safety rules and other environmental regulations or restrictions applicable to the design, installation, operation and maintenance of the Member-Generator's System.
Use and Operation 3.1 Permitted Use ......................................................................................................
Management and Operations Promotes the learning and growth of all students and the success of all staff by ensuring a safe, efficient, and effective learning environment, using resources to implement appropriate curriculum, staffing, and scheduling
Business and Operations Borrower will continue to engage in the businesses presently conducted by it as and to the extent the same are necessary for the ownership, maintenance, management and operation of the Property. Borrower will qualify to do business and will remain in good standing under the laws of each jurisdiction as and to the extent the same are required for the ownership, maintenance, management and operation of the Property.
Safe Operations Notwithstanding any other provision of this Agreement, an NTO may take, or cause to be taken, such action with respect to the operation of its facilities as it deems necessary to maintain Safe Operations. To ensure Safe Operations, the local operating rules of the ITO(s) shall govern the connection and disconnection of generation with NTO transmission facilities. Safe Operations include the application and enforcement of rules, procedures and protocols that are intended to ensure the safety of personnel operating or performing work or tests on transmission facilities.
GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site. Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer. Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations. Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage. Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer. Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized. Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel. Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations. Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job. Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours. Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement. Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
Unsafe Working Conditions Employees shall be recognized by the Employer to have the competence to determine what constitutes unsafe working conditions within their discipline. No employee shall be disciplined for refusal to work in a situation which is deemed unsafe beyond the reasonable requirements of the employee's job.
Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.
Safe Working Conditions The Employer undertakes to maintain office furniture, equipment, etc., in a practical and safe condition in order to avoid injury to employees or damage to their attire. Employees, for their part and in their own interest, are expected to advise the Employer of any such potentially injurious equipment.
HOURS OF WORK AND OVERTIME A. The normal work week shall be from Monday to Friday both inclusive and shall comprise five (5) days of eight (8) hours each. B. All hours worked in excess of eight (8) hours in any day shall be paid at the rate of 1 ½ times the regular hourly rate. C. Any work performed on Saturday shall be considered overtime and shall be paid at the rate of 1 ½ times the hourly rate of pay except as provided in “E” or except for the Tuesday/Saturday shift at the high school and middle schools. D. All hours worked on a Sunday, shall be considered overtime, and shall be paid a rate of two (2) times the normal rate of pay, except as provided in “E” below. E. Part-time employees must satisfy the forty (40) hour week require- ment prior to receiving overtime pay for Saturdays or Sundays. F. Employees called to work prior to the start of their normal shift shall be paid overtime for any such time worked, but such overtime pay- ment shall not apply to any of the hours of the normal shift. G. Whenever possible, the Board shall notify the employees of any Sat- urday or Sunday work not later than the end of the shift on Thursday of that week only if such Saturday or Sunday work is scheduled prior to the end of the shift on Thursday of that week, except in cases of emergency. Nothing contained in this paragraph shall be construed to be a guarantee of overtime if such is scheduled nor shall the right of the Board to cancel such scheduled overtime be limited. Employees who are required to work on a Saturday or a Sunday shall be xxxxxx- xxxx a minimum of four hours of work at the overtime rates provided in B and C above. H. Overtime shall be distributed equally as practical by building and/or department among the employees qualified and capable of performing the work available. Individuals declining overtime will be required to sign off acknowledging refusal. During emergencies or when a re- placement is unavailable, working overtime may be mandatory. I. In the event an employee is called back to work after the conclusion of a normal work shift, the employee will be entitled to a minimum of four (4) hours pay at the overtime rate and the Board reserves the right to assign four (4) hours of work in such situations. If the call- back is for an open window or door, the payment shall be two (2) hours at the overtime rate. Failure of an employee to properly secure his/her area of responsibility shall result in disciplinary action. J. Except in case of emergency, or in the event of performance on an assigned job, or during July and August, no seasonal or substitute employees shall perform in excess of forty (40) hours per week the duties of employees in the bargaining unit, nor shall seasonal or sub- stitute employees be hired or retained if regular permanent employees are on a temporary lay-off due to a reduction in force. K. Employees shall be granted no more than a fifteen (15) minute coffee break in the morning. L. When an employee is required to work in excess of ten (10) hours or more, said employee shall be granted a second one-half (1/2) hour lunch period at no loss of pay for such lunch period, and shall be granted an additional one-half (1/2) hour lunch period for each five
