System Safety Engineering Principles. The Contractor shall follow system safety engineering best-practices and established design standards during the development of the system/subsystem and prototypes.
System Safety Engineering Principles Sample Clauses
Related to System Safety Engineering Principles
Operating Principles The operations of the Bank shall be conducted in accordance with the principles set out below.
Technical Standards The Generation System shall be installed and operated by the Interconnection Customer consistent with the requirements of this Agreement; the Technical Requirements; the applicable requirements located in the National Electrical Code (NEC); the applicable standards published by the American National Standards Institute (ANSI) and the Institute of Electrical and Electronic Engineers (IEEE); and local building and other applicable ordinances in effect at the time of the installation of the Generation System.
Guiding Principles This Agreement shall create a liberal, facilitative, transparent and competitive investment environment in ASEAN by adhering to the following principles:
Cost Principles The Subrecipient shall administer its program in conformance with 2 CFR Part 200, et al; (and if Subrecipient is a governmental or quasi-governmental agency, the applicable sections of 24 CFR 85, “Uniform Administrative Requirements for Grants and Cooperative Agreements to State and Local Governments,”) as applicable. These principles shall be applied for all costs incurred whether charged on a direct or indirect basis.
Technical Standards Applicable to a Wind Generating Plant i. Low Voltage Ride-Through (LVRT) Capability A wind generating plant shall be able to remain online during voltage disturbances up to the time periods and associated voltage levels set forth in the standard below. The LVRT standard provides for a transition period standard and a post-transition period standard.
Environmental Standards If the contract amount set forth in this Contract is in excess of $100,000, the Contractor shall comply with all applicable standards, orders, or requirements issued under section 306 of the Clean Air Act (42 U.S.C. § 7606), section 508 of the Clean Water Act (33 U.S.C. § 1368), Executive Order 11738, and Environmental Protection Agency regulations (2 C.F.R. Part 1532), which prohibit the use under non-exempt Federal contracts of facilities included on the EPA List of Violating Facilities. The Contractor shall report any violations of this paragraph to the State of Indiana and to the United States Environmental Protection Agency Assistant Administrator for Enforcement.
Applicable Technical Standards The Applicable Technical Requirements and Standards that apply to the Customer Facility and the Interconnection Facilities are identified in Schedule D to this ISA.
CONTRACT WORK HOURS AND SAFETY STANDARDS As per the Contract Work Hours and Safety Standards Act (40 U.S.C. 3701-3708), where applicable, all Customer Purchase Orders in excess of ,000 that involve the employment of mechanics or laborers must include a provision for compliance with 40 U.S.C. 3702 and 3704, as supplemented by Department of Labor regulations (29 CFR Part 5). Under 40 U.S.C. 3702 of the Act, each contractor must be required to compute the wages of every mechanic and laborer on the basis of a standard work week of 40 hours. Work in excess of the standard work week is permissible provided that the worker is compensated at a rate of not less than one and a half times the basic rate of pay for all hours worked in excess of 40 hours in the work week. The requirements of 40 U.S.C. 3704 are applicable to construction work and provide that no laborer or mechanic must be required to work in surroundings or under working conditions which are unsanitary, hazardous or dangerous. These requirements do not apply to the purchases of supplies or materials or articles ordinarily available on the open market, or contracts for transportation or transmission of intelligence.
Contractor Work Hours and Safety Standards Contractor shall ensure compliance with all safety and hourly requirements for employees, in accordance with federal, state, and County safety and health regulations and laws.
COVID-19 Protocols Contractor will abide by all applicable COVID-19 protocols set forth in the District’s Reopening and COVID-19 Mitigation Plan and the safety guidelines for COVID-19 prevention established by the California Department of Public Health and the Ventura County Department of Public Health.
