Tensile test Sample Clauses

Tensile test. 2.1.2.2.1. Tensile test on parent metal
Sample 1Sample 2Sample 3See All (7)
AutoNDA by SimpleDocs
Tensile test. The tensile properties of welded steel in the inner vessel shall be tested in accordance with EN 895:1995 and EN 6892-1:2009.
Sample 1Sample 2Sample 3See All (5)
Tensile test. The tensile strength, yield strength and percentage elongation of steel shall be determined from standard test pieces cut either lengthwise or crosswise from plates. The tests shall be carried out on the standard test piece prepared in accordance with test edition of IS 1608 or its international equivalent standard. The tensile strength, yield strength and percentage elongation of steel should not be less than the specified values in Table 4-5. Only proportional test piece complying with the requirement Lo = 5.65√So should be used for the tensile test, where Lo is the gauge length and So is the cross-sectional area of the test piece. Number of Tensile Tests - For every 500 tons of finished steel, one tensile test shall be conducted.
Sample 1Sample 2
Tensile test. The finished stay sets when subject to tensile test shall comply with the requirement of the tensile strength as per the table given below: X.Xx. Diameter of rods Breaking load
Sample 1

Related to Tensile test

  • Test The outer surface of the lamp lenses shall be subjected once or more than once to the action of the sand jet produced as described above. The jet shall be sprayed almost perpendicular to the surface to be tested. The deterioration shall be checked by means of one or more samples of glass placed as a reference near the lenses to be tested. The mixture shall be sprayed until the variation in the diffusion of light on the sample or samples measured by the method described in Appendix 2, is such that: Δ d = (T5 - T4) / T2 ≤ 0.0250 ± 0.0025 Several reference samples may be used to check that the whole surface to be tested has deteriorated homogeneously. Annex 6 - Appendix 4

  • Drug Testing (A) The state and the PBA agree to drug testing of employees in accordance with section 112.0455, F.S., the Drug-Free Workplace Act.

  • Laboratory Testing All laboratories selected by UPS Freight for analyzing Controlled Substances Testing will be HHS certified.

  • ACCEPTANCE TESTS 11.1 If the Contract provides acceptance tests for Goods and/or the result of Services after their completion and/or delivery to the Purchaser, the acceptance shall only be considered as definitive when such tests have demonstrated the compliance of the Goods and/or the result of the Services to the requirements in the Contract.

  • Meter Testing Company shall provide at least twenty-four (24) hours' notice to Seller prior to any test it may perform on the revenue meters or metering equipment. Seller shall have the right to have a representative present during each such test. Seller may request, and Company shall perform, if requested, tests in addition to the every fifth-year test and Seller shall pay the cost of such tests. Company may, in its sole discretion, perform tests in addition to the fifth year test and Company shall pay the cost of such tests. If any of the revenue meters or metering equipment is found to be inaccurate at any time, as determined by testing in accordance with this Section 10.2 (Meter Testing), Company shall promptly cause such equipment to be made accurate, and the period of inaccuracy, as well as an estimate for correct meter readings, shall be determined in accordance with Section 10.3 (Corrections).

Time is Money Join Law Insider Premium to draft better contracts faster.