Contract Period Not Affected If the State suspends a work authorization, the contract period as determined in Article 2 of the contract (Contract Period) is not affected and the contract and the work authorization will terminate on the date specified unless the contract or work authorization is amended to authorize additional time.
Regular Work Week The regular work week shall be any five (5) consecutive days, Sunday through Saturday, for a total regular work week of forty (40) working hours, subject to the applicable premiums where provided for in this Agreement. Notwithstanding the above, employees may volunteer to work schedules that fall outside of the regular work week of Sunday through Saturday and may do so, upon approval by the Company, and with no penalty cost to the Company, but with applicable premiums as provided for in this Agreement.
Regular Work Day A regular work day shall consist of six and one-half (6½) hours between the hours of 8:00 a.m. and 5:00 p.m.
Questions About Review The Asset Representations Reviewer will make appropriate personnel available to respond in writing to written questions or requests for clarification of any Review Report from the Indenture Trustee or the Servicer until the earlier of (i) the payment in full of the Notes and (ii) one year after the delivery of the Review Report. The Asset Representations Reviewer will not be obligated to respond to questions or requests for clarification from a Noteholder or any other Person and will direct such Persons to submit written questions or requests to the Indenture Trustee.
COVERED NOT COVERED All components and parts of well pump utilized as a source of water to the home. Above or underground piping, cable or electrical lines leading to or from the well pump, including those that are located within the well casing, well casings, pressure switches not located on the pump, holding, storage or pressure tanks, booster pumps, re-drilling of xxxxx, well pump and all well pump components for geothermal and/or water source heat pumps.
Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.
Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract. a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract. b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.
Contract Work Contract work means capital project work within existing plant facilities, major maintenance and/or revamp work, plant modifications and/or shutdown work, minor maintenance and/or repair work, breakdown maintenance.
Regular Work Schedules The regular work schedule for overtime-eligible employees will not be more than forty (40) hours in a workweek, with two (2) consecutive calendar days off and starting and ending times as determined by the requirements of the position and the Employer. The Employer may adjust the regular work schedule with prior notice to the employee.
Other Methods of Procurement of Consultants’ Services The following table specifies the methods of procurement, other than Quality and Cost-based Selection, which may be used for consultants’ services. The Procurement Plan shall specify the circumstances under which such methods may be used. (a) Quality-based Selection (b) Selection under a Fixed Budget
