Fast Food Allowance As of 1 October 2020 the Employer shall pay an allowance of $2.75 per hour on all fast food construction, and on refurbishments with a building permit value in excess of $470,000. These allowances will be adjusted annually in accordance with CPI (All Groups, Melbourne) movements measured in the twelve month period ending the previous December quarter effective as of 1 March 2021, rounded to the nearest 5 cents. On any Project where the applicable site allowance in Appendix C is higher, then that site allowance will apply.
RETURNED CHECKS (NON-SUFFICIENT FUNDS) If the Tenant pays the Rent with a check that bounces due to insufficient funds: (check one) ☐ - The Tenant will be required to pay a fee of $ per incident. ☐ - The Tenant will NOT be required to pay a fee.
Leave Loading 10.2 The employer and the individual employee must have genuinely made the agreement without coercion or duress.
Returned Check Charge A Customer whose payment by check is returned for insufficient funds, or is otherwise not processed for payment, will be subject to a returned check charge. Such charge will be applicable on each occasion when a check is returned or not processed. If the returned check was for a combined interstate and international balance, only a single returned check charge will apply. Per Occasion $25.00
Returned Check For any returned or bounced checks, Landlord may charge Tenant the cost of the returned check fee, as well as an additional reasonable fee, together with Rent late fees, as applicable.
Returned Check Fee Checks returned by the payer’s bank (for insufficient funds, closed account, stop payments, etc.) must be redeemed in cash, money order or cashier’s check for the full amount plus $30.00 service fee.
Returned Checks In the event that any check or other order for the payment of money is returned unpaid for any reason, Transfer Agent or its agent will: (i) give prompt notice of such return to the relevant Fund or its designee; (ii) place a stop transfer order against all Shares issued as a result of such check or order; and (iii) take such actions as Transfer Agent may from time to time deem appropriate.
REPAIRED OR REPLACED PARTS / COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including Warranties, as set forth in the Additional Warranties Clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturer’s installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.
Increasing Seat Belt Use in the United States Pursuant to Executive Order 13043, 62 FR 19217 (Apr. 18, 1997), Recipient should encourage its contractors to adopt and enforce on-the- job seat belt policies and programs for their employees when operating company-owned, rented or personally owned vehicles.
REMANUFACTURED, RECYCLED, RECYCLABLE OR RECOVERED MATERIALS Upon the conditions specified in the Bid Specifications and in accordance with the laws of the State of New York, Contractors are encouraged to use recycled, recyclable or recovered materials in the manufacture of Products and packaging to the maximum extent practicable without jeopardizing the performance or intended end use of the Product or packaging unless such use is precluded due to health, welfare, safety requirements or in the Bid Specifications. Contractors are further encouraged to offer remanufactured Products to the maximum extent practicable without jeopardizing the performance or intended end use of the Product and unless such use is precluded due to health, welfare, safety requirements or by the Bid Specifications. Where such use is not practical, suitable, or permitted by the Bid Specifications, Contractor shall deliver new materials in accordance with the “Warranties" set forth below. Items with recycled, recyclable, recovered, refurbished or remanufactured content must be identified in the Bid or Bidder will be deemed to be offering new Product.
