TROUBLE CALL RESPONSE TIME Sample Clauses

TROUBLE CALL RESPONSE TIME. The Response Time for trouble calls are defined for both critical and non-critical failures. For all critical failures the contractor shall respond within two (2) operational hours of notification by a DHS official. All Non-critical failures require the contractor to respond within eight (8) operational hours of notification by a DHS official. Where feasible non-critical failures shall be repaired during non peak, or off hours so the impact on the operation of the port of entry is minimized.
AutoNDA by SimpleDocs
TROUBLE CALL RESPONSE TIME. Within (6) Hours of the trouble call a technician shall return the call to Client for symptom review.

Related to TROUBLE CALL RESPONSE TIME

  • Response Times Qubit bases its response times and the actions it takes to resolve problems on an assessment of the impact of the reported technical issue. The more serious the impact, the higher the assigned priority. For all support issues relating to Customer, Qubit will respond in accordance with Table 1: P1 1 hour 4 hours P2 1 hour 8 hours P3 4 hours 72 hours P4 1 business day Next or a later major release **The Priority Levels are defined in Section II(2) below.

  • Timely and Sustained Response Interconnection Customer shall ensure that the Small Generating Facility’s real power response to sustained frequency deviations outside of the deadband setting is automatically provided and shall begin immediately after frequency deviates outside of the deadband, and to the extent the Small Generating Facility has operating capability in the direction needed to correct the frequency deviation. Interconnection Customer shall not block or otherwise inhibit the ability of the governor or equivalent controls to respond and shall ensure that the response is not inhibited, except under certain operational constraints including, but not limited to, ambient temperature limitations, physical energy limitations, outages of mechanical equipment, or regulatory requirements. The Small Generating Facility shall sustain the real power response at least until system frequency returns to a value within the deadband setting of the governor or equivalent controls. An Applicable Reliability Standard with equivalent or more stringent requirements shall supersede the above requirements.

  • Company’s Response Upon receipt by the Company of a copy of a Conversion Notice, the Company shall as soon as practicable, but in no event later than one (1) Business Day after receipt of such Conversion Notice, send, via email, facsimile or overnight courier, a confirmation of receipt of such Conversion Notice to such Holder indicating that the Company will process such Conversion Notice in accordance with the terms herein. Within two (2) Business Days after the date of the Conversion Confirmation, the Company shall have issued and electronically transferred the shares to the Broker indicated in the Conversion Notice; should the Company be unable to transfer the shares electronically, it shall, within two (2) Business Days after the date of the Conversion Confirmation, have surrendered to FedEx for delivery the next day to the address as specified in the Conversion Notice, a certificate, registered in the name of the Holder, for the number of shares of Common Stock to which the Holder shall be entitled.

  • Response Time PROVIDING PARTY shall respond to and resolve any problems in connection with the Corporate Services for RECEIVING PARTY within a commercially reasonable period of time, using response and proposed resolution times consistent with its response and resolution of such problems for itself.

  • Incident Response Operator shall have a written incident response plan that reflects best practices and is consistent with industry standards and federal and state law for responding to a data breach, breach of security, privacy incident or unauthorized acquisition or use of any portion of Data, including PII, and agrees to provide LEA, upon request, an executive summary of the written incident response plan.

  • Primary Frequency Response Developer shall ensure the primary frequency response capability of its Large Generating Facility by installing, maintaining, and operating a functioning governor or equivalent controls. The term “functioning governor or equivalent controls” as used herein shall mean the required hardware and/or software that provides frequency responsive real power control with the ability to sense changes in system frequency and autonomously adjust the Large Generating Facility’s real power output in accordance with the droop and deadband parameters and in the direction needed to correct frequency deviations. Developer is required to install a governor or equivalent controls with the capability of operating: (1) with a maximum 5 percent droop ± 0.036 Hz deadband; or (2) in accordance with the relevant droop, deadband, and timely and sustained response settings from an approved Applicable Reliability Standard providing for equivalent or more stringent parameters. The droop characteristic shall be: (1) based on the nameplate capacity of the Large Generating Facility, and shall be linear in the range of frequencies between 59 and 61 Hz that are outside of the deadband parameter; or (2) based on an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. The deadband parameter shall be: the range of frequencies above and below nominal (60 Hz) in which the governor or equivalent controls is not expected to adjust the Large Generating Facility’s real power output in response to frequency deviations. The deadband shall be implemented: (1) without a step to the droop curve, that is, once the frequency deviation exceeds the deadband parameter, the expected change in the Large Generating Facility’s real power output in response to frequency deviations shall start from zero and then increase (for under-frequency deviations) or decrease (for over-frequency deviations) linearly in proportion to the magnitude of the frequency deviation; or (2) in accordance with an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. Developer shall notify NYISO that the primary frequency response capability of the Large Generating Facility has been tested and confirmed during commissioning. Once Developer has synchronized the Large Generating Facility with the New York State Transmission System, Developer shall operate the Large Generating Facility consistent with the provisions specified in Articles 9.5.5.1 and 9.5.5.2 of this Agreement. The primary frequency response requirements contained herein shall apply to both synchronous and non-synchronous Large Generating Facilities.

  • Workplace Violence Prevention and Crisis Response (applicable to any Party and any subcontractors and sub-grantees whose employees or other service providers deliver social or mental health services directly to individual recipients of such services): Party shall establish a written workplace violence prevention and crisis response policy meeting the requirements of Act 109 (2016), 33 VSA §8201(b), for the benefit of employees delivering direct social or mental health services. Party shall, in preparing its policy, consult with the guidelines promulgated by the U.S. Occupational Safety and Health Administration for Preventing Workplace Violence for Healthcare and Social Services Workers, as those guidelines may from time to time be amended. Party, through its violence protection and crisis response committee, shall evaluate the efficacy of its policy, and update the policy as appropriate, at least annually. The policy and any written evaluations thereof shall be provided to employees delivering direct social or mental health services. Party will ensure that any subcontractor and sub-grantee who hires employees (or contracts with service providers) who deliver social or mental health services directly to individual recipients of such services, complies with all requirements of this Section.

  • Emergency Response Partners must develop, maintain, and carry out a response plan for public water system emergencies, including disease outbreaks, spills, operational failures, and water system contamination. Partners must notify DWS in a timely manner of emergencies that may affect drinking water supplies.

  • Reactive Power and Primary Frequency Response 9.6.1 Power Factor Design Criteria

  • Line Item Question Response 46 Do your warranties cover all products, parts, and labor? Warranties are those supplied by the equipment manufacturers. Generally cover parts and labor. * 47 Do your warranties impose usage restrictions or other limitations that adversely affect coverage? Warranty will not cover abuse or lack of maintenance. * 48 Do your warranties cover the expense of technicians' travel time and mileage to perform warranty repairs? Yes * 49 Are there any geographic regions of the United States or Canada (as applicable) for which you cannot provide a certified technician to perform warranty repairs? How will Sourcewell participating entities in these regions be provided service for warranty repair? We have coverage in the United States. * 50 Will you cover warranty service for items made by other manufacturers that are part of your proposal, or are these warranties issues typically passed on to the original equipment manufacturer? We warranty any work we preform. The equipment is covered by the original equipment manufacturer. * 51 What are your proposed exchange and return programs and policies? Special order items are not returnable and will not be exchanged. If a manufacture will take back an item they consider returnable, the return must have an RMA and be returned within 90 days in the original carton. All freight, restocking, damage plus a service fee will be deducted form the credit for equipment. * 52 Describe any service contract options for the items included in your proposal. We offer preventative maintenance contracts for refrigeration equipment in Texas. DFW, Houston, Beaumont and Austin. * 53 Describe your payment terms and accepted payment methods. Standard payment terms are Net 30 days. To be considered for an open account, all new customers will be required to complete a New Customer Application and provide tax exemption certification if applicable. All applicants are subject to Strategic's Credit Terms and Policies and must meet criteria specified therein. Finance charges of 1/5% per month (18% APR) or the maximum rate that an applicant may lawfully contract to pay, whichever is less, on any payment Seller considers past due until collected. Accepted payment methods include check, ACH, wire transfer, credit card * 54 Describe any leasing or financing options available for use by educational or governmental entities. TriMark Strategic has developed business relationships with several reputable third-party leasing companies and can provide Sourcewell customers with information regarding this option upon request. * 55 Describe any standard transaction documents that you propose to use in connection with an awarded contract (order forms, terms and conditions, service level agreements, etc.). Upload a sample of each (as applicable) in the document upload section of your response. Strategic will require a valid Purchase Order from Sourcewell customers. Upon acceptance, Strategic will agree to the terms and conditions set forth in the Purchase Order. All quotes submitted by Strategic to Sourcewell customers will be on a standard Quotation Form and will have this statement regarding the Terms of Sale: "This Quote shall be subject to Trimark's Terms of Sale http//xxx.xxxxxxxxxx.xxx/XxxxXxxxx/XxxxXxxxxxxxx/Xxxx/XxxXxxx-Xxxxx- and-Conditions-of-Sale.pdf, which are incorporated herein by reference. The customer's Purchase Order terms and conditions shall govern. *

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!