UMB ATM Network Transactions Sample Clauses

UMB ATM Network Transactions. You may request that the Bank issue and activate a card which you can use to access the checking and savings (optional) accounts you have with us and to initiate electronic fund transfers (“UMB ATM Network transactions”) to and from such accounts at UMB ATMs, other selected network ATMs, and POS terminals. All references to “Card” in these Regulatory Disclosures and the UMB ATM Network Agreement will refer to the UMB ATM Card or UMB Debit Card issued to you (or that you have requested but not yet received). If you already requested or we have issued and activated a Card that may be used to engage in UMB ATM Network transactions, then upon our issuance and activation, the important information and disclosures and the terms and conditions of the UMB ATM Network Agreement below will be applicable to the Card and to UMB ATM Network transactions engaged in through the use of the Card. A broad range of UMB ATM Network transactions described below can be initiated to or from any of your accounts at ATMs and POS terminals using a Card properly issued and validated pursuant to a request by you. UMB ATM Network transactions are governed by the provisions of the UMB ATM Network Agreement below.
Sample 1Sample 2Sample 3
AutoNDA by SimpleDocs
UMB ATM Network Transactions. You may request that the Bank issue and validate a card which you can use to access the checking and savings (optional) accounts you have with us and to initiate electronic fund transfers (“UMB ATM Network transactions”) to and from such accounts at our UMB automated teller machines (ATMs), at other regional UMB ATMs and at other selected network ATMs and POS terminals. Depending upon your specific request, the card to be issued and validated for you is in one of two formats: • If you already have (or have requested but not yet received) a UMB VISA card issued by UMB Bank, n.a. and have requested that we also issue and validate that card so that you may use it to engage in UMB ATM Network transactions, then upon our issuance and validation: (a) the Important Information and Disclosures and the terms and conditions of the UMB ATM Network Agreement below will be applicable to the card and to UMB ATM Network transactions engaged in through the use of the card, and (b) all references to “Card” in the Important Information and Disclosures and the UMB ATM Network Agreement will refer to that UMB VISA card. • If you have requested a separate UMB ATM card or UMB Visa Debit Card, then: (a) the Card will be issued and validated,
Sample 1Sample 2

Related to UMB ATM Network Transactions

  • Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.

  • Unbundled Network Terminating Wire (UNTW) 2.8.3.1 UNTW is unshielded twisted copper wiring that is used to extend circuits from an intra-building network cable terminal or from a building entrance terminal to an individual End User’s point of demarcation. It is the final portion of the Loop that in multi-subscriber configurations represents the point at which the network branches out to serve individual subscribers. 2.8.3.2 This element will be provided in MDUs and/or Multi-Tenants Units (MTUs) where either Party owns wiring all the way to the End User’s premises. Neither Party will provide this element in locations where the property owner provides its own wiring to the End User’s premises, where a third party owns the wiring to the End User’s premises.

  • Unbundled Network Element Combinations 5.1. Unbundled Network Element Combinations shall include: 1) Enhanced Extended Links (EELs); 2) UNE Loops/Special Access Combinations; 3) Loop/Port Combinations; and 4)

  • Signaling Link Transport 9.2.1 Signaling Link Transport is a set of two or four dedicated 56 kbps transmission paths between Global Connection-designated Signaling Points of Interconnection that provide appropriate physical diversity.

  • Processing Transactions 2 2.1 Timely Pricing and Orders.................................... 2 2.2

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.

  • NETWORK INTERCONNECTION METHODS 3.1 The Interconnection provided herein may not be used solely for the purpose of originating a Party’s own interexchange traffic.

  • Originating Switched Access Detail Usage Data A category 1101XX record as defined in the EMI Telcordia Practice BR-010-200- 010.

  • Fund/SERV Transactions If the parties choose to use the National Securities Clearing Corporation’s Mutual Fund Settlement, Entry and Registration Verification (“Fund/SERV”) or any other NSCC service, the following provisions shall apply: The Company and the Fund or its designee will each be bound by the rules of the National Securities Clearing Corporation (“NSCC”) and the terms of any NSCC agreement filed by it or its designee with the NSCC. Without limiting the generality of the following provisions of this section, the Company and the Fund or its designee will each perform any and all duties, functions, procedures and responsibilities assigned to it and as otherwise established by the NSCC applicable to Fund/SERV, the Mutual Fund Profile Service, the Networking Matrix Level utilized and any other relevant NSCC service or system (collectively, the “NSCC Systems”). Any information transmitted through the NSCC Systems by any party or its designee to the other or its designee and pursuant to this Agreement will be accurate, complete, and in the format prescribed by the NSCC. Each party or its designee will adopt, implement and maintain procedures reasonably designed to ensure the accuracy of all transmissions through the NSCC Systems and to limit the access to, and the inputting of data into, the NSCC Systems to persons specifically authorized by such party. On each day on which the New York Stock Exchange is open for trading and on which the Fund calculates its net asset value pursuant to the rules of the SEC (“Business Day”), the Company shall aggregate and calculate the net purchase and redemption orders for each Account received by the Company by the close of the New York Stock Exchange (generally, 4:00 p.m. Eastern Time) (the “Close of Trading”) on the Business Day. The Company shall communicate to the Fund or its designee for that Business Day, by Fund/SERV, the net aggregate purchase or redemption orders (if any) for each Account received by the Close of Trading on such Business Day (the “Trade Date”) no later than 7:00 a.m. Eastern Time (or such other time as may be agreed by the parties from time to time) (the “Fund/SERV Transactions Deadline”) on the Business Day following the Trade Date. All such aggregated orders communicated to the Fund or its designee by the Fund/SERV Transactions Deadline on the Business Day following the Trade Date shall be treated by the Fund or its designee as if received prior to the Close of Trading on the Trade Date. All orders received by the Company after the Close of Trading on a Business Day shall not be aggregated with Orders received by the Company prior to the Close of Trading on such Business Day and shall be communicated to BRIL or its designee as part of an aggregated order no sooner than after the FUND/SERV Transactions Deadline or such other time as may be agreed by the parties from time to time) the following Business Day. Cash settlement shall be transmitted pursuant to the normal NSCC settlement process. In the case of delayed settlement, the Fund or its designee shall make arrangements for the settlement of redemptions by wire no later than the time permitted for settlement of redemption orders by the 1940 Act. Unless otherwise informed in writing, such redemption wires should be sent to an account specified by the Company and agreed to by Fund Parties.

  • Wire Unbundled DS1 Digital Loop This is a designed 4-wire Loop that is provisioned according to industry standards for DS1 or Primary Rate ISDN services and will come standard with a test point, OC, and a DLR. A DS1 Loop may be provisioned over a variety of loop transmission technologies including copper, HDSL-based technology or fiber optic transport systems. It will include a 4-Wire DS1 Network Interface at the End User’s location.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!