Application Form To apply for a pole attachment or conduit occupancy license under this Agreement, Applicant shall submit to SWBT two signed copies of the appropriate application forms. SWBT represents that the forms specified in subsections (a)-(b) are forms in use prior to the effective date of this Agreement and that SWBT is in the process of revising such forms to conform to the provisions of this Agreement and to streamline the application process. The parties therefore agree that the forms specified in subsections (a) and (b) will be interim forms only. SWBT reserves the right to change the format and content of these forms upon 60 days written notice to Applicant.
(a) To apply for a pole attachment license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make- Ready Authorization”) together with completed Form SW-9433 (“Pole Attachments”). An application for a pole attachment license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9433 and SW-9434 are attached to this Agreement as parts of APPENDIX III.
(b) To apply for a conduit occupancy license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make-Ready Authorization”) together with completed Form SW-9435 (“Conduit Occupancy”). An application for a conduit occupancy license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9434 and SW-9435 are attached to this Agreement as parts of APPENDIX III.
(c) Each application for a license under this Agreement shall include, at a minimum, the following information:
(1) the poles, ducts, and conduits (including all manholes) along Applicant’s proposed route to or within which Applicant desires to attach or place its facilities;
(2) a description of the facilities to be attached to SWBT’s poles and a description of the facilities to be placed within each component of SWBT’s conduit system (including but not limited to ducts, conduits, manholes, and handholes) along the proposed route;
(3) for poles, the proposed points of attachment;
(4) for building entrance or building distribution ducts or conduits or other space within a building, a conspicuous statement, as required by Section 5.06 of this Agreement, that the application pertains to a building entrance or building distribution duct or conduit or other space within a building;
(5) if applicable, a conspicuous notation that the space requested is not to be assigned (or billed) to Applicant until SWBT has received Applicant’s written instruction to make such assignment or issued a license authorizing Applicant to occupy the space requested; and
(6) if applicable, a conspicuous statement that Applicant intends to occupy the space before the issuance of a license, as provided in Section 8.03 of this Agreement.
(d) Facilities descriptions which apply to multiple pole attachments or conduit occupancies need only be described once on any form. Facilities descriptions shall include, at a minimum, the following information:
(1) the number and types of cables, including the physical size (diameter) and weight (weight per foot);
(2) the number and types of strands, if any, which will be used to support the cables, including the rated holding capacity expressed in thousand pound increments (e.g., 2.2M) of such strands; and
(3) sufficient information to identify and describe the physical characteristics (size, dimensions, and weight) of apparatus enclosures and other facilities to be attached to SWBT’s poles or placed in SWBT’s conduit system.
(e) When it appears to Applicant that facilities modification, capacity expansion, or make-ready work may be required to accommodate Applicant’s access requests, Applicant shall describe the facilities modification, capacity expansion, or make-ready work which Applicant proposes. Applicant shall also describe its plans, if any, to use any infrequent construction technique or connectivity solution authorized under Section 6.03 to avoid high or unusual expenditures and state its reasons for the use of such technique or solution.
(f) Applicant acknowledges that the poles along a particular pole line or route may include poles owned by firms (such as electric utilities) other than SWBT, that it may be necessary for SWBT to rearrange its facilities or perform other make-ready work on poles other than poles it owns or controls in order to accommodate Applicant’s request for access to SWBT’s poles and that, at the time an application is submitted, it may be difficult for Applicant to determine with certainty whether a particular pole is owned or controlled by SWBT or by another entity. Accordingly, the application shall, to the extent feasible, identify all poles utilized by SWBT (without regard to ownership) along Applicant’s proposed route.
(g) Each application for a license under this Agreement shall be accompanied by a construction schedule showing Applicant’s projected dates for beginning and completing construction at the sites specified in the application. Information on this schedule may be used by SWBT’s engineering and outside plant construction personnel in scheduling work required to process Applicant’s applications and scheduling such capacity expansions, make- ready work, and facilities modifications, if any, as may be necessary to accommodate Applicant’s facilities.
(h) Applicant may include multiple cables in a single license application and may provide multiple services (e.g., CATV and non-CATV services) under the same cable sheath or jacket. When both CATV and non-CATV services are provided under the same cable sheath or jacket, or CATV and non-CATV services are provided using different cables attached or lashed to the same strand or otherwise occupying the same space on a pole or the same duct or inner duct within a conduit, Applicant will so advise SWBT and SWBT shall, if permitted by law, adjust its charges to enable SWBT to charge Applicant the rate applicable to telecommunications carriers rather than the rate applicable to cable television systems solely to provide cable service.
Termination of Review If a Review is in process and the Notes will be paid in full on the next Payment Date, the Servicer will notify the Asset Representations Reviewer and the Indenture Trustee no less than ten days before that Payment Date. On receipt of notice, the Asset Representations Reviewer will terminate the Review immediately and will not be obligated to deliver a Review Report.
No Beneficiary Designation If the Executive dies without a valid beneficiary designation, or if all designated Beneficiaries predecease the Executive, then the Executive’s spouse shall be the designated Beneficiary. If the Executive has no surviving spouse, the benefits shall be made to the personal representative of the Executive’s estate.
Beneficiary Designations The Executive shall designate a beneficiary by filing a written designation with the Company. The Executive may revoke or modify the designation at any time by filing a new designation. However, designations will only be effective if signed by the Executive and accepted by the Company during the Executive's lifetime. The Executive's beneficiary designation shall be deemed automatically revoked if the beneficiary predeceases the Executive, or if the Executive names a spouse as beneficiary and the marriage is subsequently dissolved. If the Executive dies without a valid beneficiary designation, all payments shall be made to the Executive's estate.
Beneficiary Designation The Participant may, from time to time, name any beneficiary or beneficiaries (who may be named contingently or successively) to whom any benefit under this Agreement is to be paid in case of his or her death before he or she receives any or all of such benefit. Each such designation shall revoke all prior designations by the Participant, shall be in a form prescribed by the Company, and will be effective only when filed by the Participant in writing with the Director of Human Resources of the Company during the Participant’s lifetime. In the absence of any such designation, benefits remaining unpaid at the Participant’s death shall be paid to the Participant’s estate.
Plan Design The flexible benefits plan is a cafeteria-style benefits program wherein the County makes a contribution toward the Flexible Benefits Plan for each eligible employee to be allocated during the employee's active employment. The County contribution is distributed by the employee among the menu of benefit options listed below, the specific details and administration of which are set forth in the plan brochures: • Health insurance • County basic life and AD&D insurance • Dental insurance • Vision insurance • Supplemental life insurance • Supplemental accidental death and dismemberment insurance (AD&D) • Flexible spending accounts for pre-tax reimbursement of qualified medical and/or dependent day care expenses. Account credits must be used during the plan year in which they are earned for expenses incurred during the same plan year. • The plan may be modified upon written notice by the County. This plan includes for eligible employees pre-tax contributions for all monies paid toward health, dental, vision and/or voluntary AD&D plans.
Designation of Beneficiary The depositor may designate a beneficiary or beneficiaries to receive benefits from the custodial account in the event of the depositor’s death. In the event the depositor has not designated a beneficiary, or if all beneficiaries shall predecease the depositor, the following persons shall take in the order named:
a. The spouse of the depositor;
b. If the spouse shall predecease the depositor or if the depositor does not have a spouse, then to the depositor’s estate.
Application for Benefits Requests for short-term leaves shall be in writing, upon the appropriate form prescribed and provided by the District, and shall be filed with the unit member's supervisor and the appropriate manager five (5) days in advance of the intended leave (except in emergency situations), unless otherwise stated by the provisions of the specific leave.
Term of Plan This Plan shall remain in effect until the earlier of (i) termination by the Board, (ii) the distribution of all assets of the Trust, or (iii) 21 years from the Effective Date. Termination of the Plan shall not effect any Plan Share Awards previously granted, and such Plan Share Awards shall remain valid and in effect until they have been earned and paid, or by their terms expire or are forfeited.
Termination of Plan The Sponsor may terminate the Plan and the Trust with respect to all Employers by executing and delivering to the Committee and the Trustee, a notice of termination, specifying the date of termination.
