axle spacing definition

axle spacing means the measurement between the centers of the axles as measured from center-to-center of wheel hubs.
Sample 1Sample 2Sample 3
axle spacing means the distance between two consecutive axles; for centre axle trailers, semi-trailers and rigid drawbar trailers, the first axle spacing is the horizontal distance between the vertical axis of the front coupling and the centre of the first axle;]
Sample 1Sample 2
axle spacing means the distance between two consecutive axles referred to in point 6.4 of Standard ISO 612:1978 in the case of vehicles with more than two axles; where the vehicle is fitted with two axles only, or in the case of a semi-trailer, a drawbar trailer or a rigid drawbar trailer, the axle spacing referred to in point 6.4.2 of Standard ISO
Sample 1Sample 2

Examples of axle spacing in a sentence

  • Axle Spacing Testing.Conduct the test runs concurrently with the weight testing.

  • Gear Ratio: 3.91 SUSPENSION, REAR, TANDEM {Hendrickson HMX-400-54} Walking Beam Type 54" Axle Spacing; 40,000-lb Capacity, With Rubber End Bushings, Transverse Torque Rods, Less Shock Absorbers SUSPENSION/REAR-AXLE IDENTITY for Meritor Tandem Rear Axles With Bar-Pin Beam Attachment Type Suspensions DIFF.

  • SUSPENSION, REAR, TANDEM {Hendrickson HMX-400-52} Walking Beam, 40,000-lb Capacity, 52" Axle Spacing.

  • Adoption of corporate training at corporate level is of no choice for firms’ only if they want to remain relevant before their customers and other organizations.

  • The cost data are usually assumed to follow a gamma dis- tribution (potentially highly skewed) and the model is fitted by a method called max- imum likelihood rather than ordinary least squares.

  • Suspension, rear, tandem:Walking Beam Type 54" Axle Spacing; 46,000-lb Capacity With BronzeCenter Bushings 11.

  • Velocity and axle spacing were calculated using the data shown in Figure 3.10: Velocity = ∆Distance / ∆Time 1-2 = (7 ft) / (0.491 sec – 0.404 sec) = 80.5 ft/sec = 55mph Axle Spacing = Velocity * ∆Time 1-1 = (80.5 ft/sec) * (0.404 sec – 0.370 sec) = 2.74 ft The temperature sensor was installed to monitor variations in pavement temperature for future sensor calibration needs.

  • WIM accuracy on all vehicles loaded above 60,000 pounds and traveling between the speeds of 5 to 85 miles per hour shall be as follows: Axle Weights: + 15% (95% of trucks) Tandem Weights: + 10% (95% of trucks) Gross Weights: + 6% (95% of trucks) Axle Spacing: + 6 inches or 5% (68% of axles), whichever is greater F.

  • SUSPENSION, REAR, TANDEM:{Hendrickson HMX-460-54} Walking Beam Type 54" Axle Spacing; 46,000 lb Capacity Minimum with Rubber End Bushings,yesnoTransverse Torque Rods, and Less Shock Absorbers.CAB PAINT: yes noSchool Bus Yellow.

  • For overweight loads, WSDOT Axle Spacing Report or completed Overweight Only section of WSDOT Overweight Vehicle Permit Application must be provided.


More Definitions of axle spacing

axle spacing means the distance between two consecutive axles; for centre axle trailers, semi-trailers and rigid drawbar trailers, the first axle
Sample 1
axle spacing means the measurement between the centers of the axles as measured from center-to-center of wheel hubs. RULE NOS.: RULE TITLES: 14-26.00411 Procedure for Issuance of Permits (4) “Escort Vehicle” means a vehicle independent of the 14-26.008 Schedule of Fees permitted vehicle, equipped with a working, amber warning 14-26.009 Exemptions from Fee Requirement light located on top of the escort vehicle, and operated by a 14-26.010 Weight Limitations qualified escort, law enforcement escort, or any combination shown in Rule 14-26.012, F.A.C. 14-26.0041 Definitions and Terms
Sample 1

Related to axle spacing

  • Project site, where applicable, means the place indicated in bidding documents.

  • ILUA Area means the geographical area in relation to which the Framework ILUA applies, as specified in Schedule 2 of the Framework ILUA;

  • Built-Up Area and/or “Covered Area” in relation to a Flat shall mean the floor area of that Flat including the area of balconies and terraces, if any attached thereto, and also the thickness of the walls (external or internal) and the columns and pillars therein Provided That if any wall, column or pillar be common between two Flats, then one-half of the area under such wall column or pillar shall be included in the built-up area of each such Flat.

  • The Project Site, where applicable, means the place or places named in the SCC.

  • Garage shall have the meaning ascribed to it in Recital H;

  • Excavation work means the making of any man-made cavity, trench, pit or depression formed by cutting, digging or scooping;

  • Carpet Area means the net usable floor, area of an Flat/Apartment, excluding the area covered by the external walls, areas under services shafts, excluding balcony or verandah area and exclusive open terrace, but includes the area covered by the internal partition walls of the flat/apartment;

  • Work area means a room or defined space in a workplace where hazardous chemicals are produced or used, and where employees are present.

  • Excavation means the mechanical removal of earth material.