Facial Coverings definition

Facial Coverings. All Contractor employees working on institution grounds are required to wear an approved facial covering at all times. Contractors are advised that mask requirements at each institution or facility may vary, such as N95 masks being required and provided at certain locations) and as such, the requirements for that institution must be followed. Additionally, institutions or facilities may update their requirements in which case the Contractor’s employees must adhere to such updated requirements.
Sample 1Sample 2Sample 3

Examples of Facial Coverings in a sentence

  • When activated to increase safety and mitigate the risk of exposure, policy 8450.01 Protective Facial Coverings During Pandemic/Epidemic Events will require face coverings of students unless they are unable to do so for health or developmental reasons.

  • To hold the reading and emergency approval, per Board Policy 0131, of the following Board Policies5200 Attendance8450.01 Protective Facial Coverings During Pandemic/Epidemic EventsYEA: CORNMAN, EVANS, CARR, CLARK, WINTER, and NICCUMThe President advised the motion carried 20:033 Mr. Matthew Clark moved and Mr. Tim Carr seconded the approval of the Treasurer/CFO’s Recommendations A.

  • Daarbij ging het veelal om laboratoriumsituaties, zodat voorzichtigheid past bij het trekken van conclusies.

  • When activated to increase safety and mitigate the risk of exposure, policy 8450.01 Protective Facial Coverings During Pandemic/Epidemic Events will require face coverings of all students unless they are unable to do so for health or developmental reasons.

  • They also cause more pollution due to burning more fuel oil and fuel gas streams.

  • Section 3.A. Facial Coverings RequiredFacial coverings are required in many instances, as detailed below.

  • Use of Facial Coverings (Minimum coverage of Nose and Mouth) within FBO / Terminal facilities and on ramp if social distancing cannot be maintained.

  • Guests must wear facial coverings in check-in areas, elevators, and all other common spaces and as otherwise required by Chapter 3 of this CEO, Facial Coverings.

  • Facial Coverings In accordance with state mandates and federal guidelines, the University is requiring all students, faculty, staff and visitors to wear a face covering over the nose and mouth inside all University buildings and in any situation where social distancing is difficult.

  • Use of Facial Coverings: All individuals engaging in outdoor activities must wear a cloth face covering, as described in Paragraph 5(ii), whenever contact with others, who are non-household members, occurs or is likely to occur , except children under the age of 2 and those individuals engaging in water activities and certain sports specified in Los Angeles County Department of Public Health Protocols (such as tennis, pickleball and solo horseback riding) are not required to wear a face covering.

Related to Facial Coverings

  • facial image means digital images of the face;

  • Fluoroscopic imaging assembly means a subsystem in which X-ray photons produce a visual image. It includes the image receptor(s) such as the image intensifier and spot-film device, electrical interlocks, if any, and structural material providing linkage between the image receptor and diagnostic source assembly.

  • Structural components means liners, leachate collection systems, final covers, run-on/run-off systems, and any other component used in the construction and operation of the MSWLF that is necessary for protection of human health and the environment.

  • Standard Amendment Coversheet refers to the form used by the Judicial Council to amend agreements with other parties. Several originally signed, fully executed versions of a Standard Amendment, together with the integrated Contract Documents, shall each represent an Amendment as an individual contract counterpart.

  • building line means a rear space, side space or street front space;

  • Specific Conditions means the conditions in addition or in variation to the general conditions which the Commission may lay down specifically for a distribution licensee;

  • As-built drawings, as used in this clause, means drawings submitted by the Contractor or subcontractor at any tier to show the construction of a particular structure or work as actually completed under the contract. “As-built drawings” shall be synonymous with “Record

  • Building, structure, facility, or installation means all of the pollutant-emitting activities which belong to the same industrial grouping, are located on one or more contiguous or adjacent properties, and are under the control of the same person (or persons under common control) except the activities of any vessel. Pollutant-emitting activities shall be considered as part of the same industrial grouping if they belong to the same major group (i.e., which have the same two-digit code) as described in the Standard Industrial Classification Manual, 1972, as amended by the 1977 Supplement (U.S. Government Printing Office stock numbers 4101-0066 and 003-005-00176-0, respectively).

  • Base Building shall include the structural portions of the Building, the public restrooms and the Building mechanical, electrical and plumbing systems and equipment located in the internal core of the Building on the floor or floors on which the Premises are located. Tenant shall promptly provide Landlord with copies of any notices it receives regarding an alleged violation of Law. Tenant shall comply with the rules and regulations of the Building attached as Exhibit E and such other reasonable rules and regulations adopted by Landlord from time to time, including rules and regulations for the performance of Alterations (defined in Section 9).

  • Standard Specifications means a compilation in book form of specifica- tions approved for general application and repetitive use;

  • MSAA Indicator Technical Specifications document means, as the context requires, either or both of the document entitled “Multi-Sector Service Accountability Agreement (MSAA) 2019-20 Indicator Technical Specifications November 5, 2018 Version 1.3” and the document entitled “Multi-Sector Service Accountability Agreement (MSAA) 2019-20 Target and Corridor-Setting Guidelines” as they may be amended or replaced from time to time;

  • Shop Drawings means drawings, submitted to the PHA by the Contractor, subcontractor, or any lower tier subcontractor, showing in detail (1) the proposed fabrication and assembly of structural elements and (2) the installation (i.e., form, fit, and attachment details) of materials of equipment. It includes drawings, diagrams, layouts, schematics, descriptive literature, illustrations, schedules, performance and test data, and similar materials furnished by the Contractor to explain in detail specific portions of the work required by the contract. The PHA may duplicate, use, and disclose in any manner and for any purpose shop drawings delivered under this contract.

  • Facial cleaner or soap means a cleaner or soap designed primarily to clean the face. “Facial Cleaner or Soap” includes, but is not limited to, facial cleansing creams, semisolids, liquids, lotions, and substrate-impregnated forms. “Facial Cleaner or Soap” does not include prescription drug products, “Antimicrobial Hand or Body Cleaner or Soap,” “Astringent/Toner,” “General-use Hand or Body Cleaner or Soap,” “Medicated Astringent/Medicated Toner,” or “Rubbing Alcohol.”

  • Slug loading means any pollutant, including oxygen demanding pollutants, released in a discharge at a flow rate and/or pollutant concentration as to cause interference in the POTW.

  • Repair facility Means any licensed automotive REPAIR FACILITY capable of performing repair services to a COVERED PART, approved by the ADMINISTRATOR, and at which YOU seek to acquire service under this CONTRACT.

  • Erection, construction, remodeling, repairing means all types of work done on a particular building or work at the site thereof in the construction or development of the project, including without limitation, erecting, construction, remodeling, repairing, altering, painting, and decorating, the transporting of materials and supplies to or from the building or work done by the employees of the Contractor, Subcontractor, or Agent thereof, and the manufacturing or furnishing of

  • Certified components means components of X-ray systems which are subject to regulations promulgated under Public Law 90-602, the “Radiation Control for Health and Safety Act of 1968,” the Food and Drug Administration.

  • Structural component means a component that supports non-variable forces or weights (dead loads) and variable forces or weights (live loads).

  • Base Building Work means the base building work for the Building as described in this Manual.

  • Building construction means any physical activity on the site involved in the erection of a structure, cladding, external finish, formwork, fixture, fitting of service installation and the unloading of plant, machinery, materials or the like.

  • System Availability means, with respect to any particular calendar month, the ratio obtained by subtracting Unscheduled Downtime during such month from the Total Monthly Time, and thereafter dividing the difference so obtained by the Total Monthly Time. Represented algebraically, System Availability for any particular calendar month is determined as follows:

  • Maintenance Margin means the minimum amount of money required in your Trading Account as specified on the Trading Platform in order to keep a Transaction open on the Trading Platform.

  • Network Availability means the capability of the equipment to resume functions after a remotely initiated trigger has been detected by a network port;

  • Definite quantity contract means a fixed price contract that provides for a

  • Contractor’s Equipment means all apparatus, machinery, vehicles and other things required for the execution and completion of the Works and the remedying of any defects. However, Contractor’s Equipment excludes Temporary Works, Employer’s Equipment (if any), Plant, Materials and any other things intended to form or forming part of the Equipment.

  • Laundry prewash means a product that is designed for application to a fabric prior to laundering and that supplements and contributes to the effectiveness of laundry detergents and/or provides specialized performance.