Redundant Power definition

Redundant Power means [**] MW of power sufficient to provide [**] to any single pair of UPS units in the event of their failure, as follows: [**]750 kilowatt (kW) UPS units ([**] sets of [**]), each functioning at no greater than [**]% capacity, will allow any pair of UPS units to provide redundancy to any failed pair of UPS units. In other words, so long as no UPS pair operates at more than [**]% capacity, UPS [**] backs up [**] & [**] UPS [**] backs up [**] & [**]; and UPS [**] backs up [**] & [**]. Therefore, notwithstanding the [**] MW of Redundant Power, each pair of UPS units functioning as a source of both [**] and [**] power at no greater than a [**]% load will ensure [**] redundancy to the [**] MW of [**] power.
Redundant Power. The proposed VIPER system’s core components are deployed in pairs and utilize separate 120VAC power rails to feed the paired equipment. Furthermore, core components and all call handling workstations are each connected to separate LAN switches on separate power rails to prevent failure of a LAN switch from compromising these components. (Without redundant LAN connectivity for the call handling workstations, a LAN switch failure would impact all call handling workstations connected to it). The Power Station itself has redundant power supplies.
Redundant Power. System: Fire detection and prevention system: Waste: Physical Security:

Examples of Redundant Power in a sentence

  • Servers without Redundant Power Supply (RPS) would carry 99% Uptime SLA.

  • Type- 2U Rack Mountable with Sliding Ready Rails, CPU- 1x Intel Xeon E5503 2 GHz, 4M Cache, 2C, Memory-12GB, Hard Disk- 4x300GB 10K RPM, 6 Gbps SAS 2.5" Hot Plug Hard Drive, Ethernet Card - Four embedded Gigabit Ethernet NIC with failover, Hot swappable Redundant Power Supply, Backup device and Backup Software, DVD/CD Combo Drive/Blue Ray Disc Drive.

  • The Community spokesman was H.E. Mr. Anastasios GIANNITSIS, Alternate Minister of Foreign Affairs of Greece, President of the Council of the European Union.

  • IPv6 ReadyIPv6:OSPFv3 and static router sipv6 Routing IPv6 Multicast IPv6 QoS IPv6VPN over MPLS or GRE Redundant Power SupplyInternal Redundant Power Supply fully loaded day 1 Redundant FANRedundant FAN fully loaded from day 1 General Note : Bidder shall supply required quantity of fiber patch chords (Single mode/ Multimode), up to 50 meters per patch chord as per site requirements.

  • Most of the studies did not consider this aspect, namely that supplementary therapies might influence a decision in favor of a specific treatment.

  • For example, consider a cylindrical container with no discernible demarcations.

  • IPv6ReadyIPv6:OSPFv3and static router sipv6 Routing IPv6 Multicast IPv6 QoS IPv6 VPN over MPLS/ GRE Redundant Power SupplyInternal Redundant Power Supply fully loaded day 1 Redundant FANRedundant/Multiple FAN fully loaded from day 1 General Note : Bidder shall supply required quantity of fiber patch chords(Single mode/ Multimode), up to 50 meters per patch chord as per site requirements.

  • IPv6 ReadyIPv6:OSPFv3 and static routers ipv6 Routing IPv6 Multicast IPv6QoS IPv6VPN over MPLS/ GRE Redundant Power SupplyInternal Redundant Power Supply fully loaded day 1 Redundant FANRedundant FAN fully loaded from day 1 General Note : Bidder shall supply required quantity of fiber patch chords (Single mode/ Multimode), up to 50 meters per patch chord as per site requirements.

  • Hardware Installation 12Drive Installation 12Expansion Unit Installation 16Hot-swapping Redundant Power Supply Units 18Installing Expansion Cards 20Rail Kits.

  • For each power circuit and Redundant Power Circuit Pair (as defined below), Customer will not consume more than the lesser of (i) the power rating for such power circuit stated in the associated Order (80% of the rated capacity) or (ii) the rated capacity pursuant to the applicable local codes.


More Definitions of Redundant Power

Redundant Power. Each rack is installed with redundant power ("A" and "B") which is provided by two separate and independent sources (different UPS and generator). Before installing any equipment, Client must verify the power installed is correct. If necessary, n+2 will assist with the verification/test. Equipment Installation: Client is responsible for properly installing and connecting equipment on the racks. Power: In order to take advantage of the power redundancy, the equipment must be correctly connected to both PDUs ("A" and "B"); phases must be balanced, and the power used cannot exceed 40% of the maximum amperage (per phase) of each PDU.
Redundant Power. Includes: Redundant power supply and associated components, [*] Supply for DC-powered VOICETEK License for redundant DC power software option. MRS/Rack Prompt Manager Includes: License for VOICETEK Prompt Management software. [*] Software Audio Interface Unit Includes: Audio interface unit. [*] OTHER PRODUCT DESCRIPTION PRICE ----- ------------------- ----- Rack Cabinet Includes: Rack cabinet, one set of Rack Cabinet Rails. [*]
Redundant Power. The Building shall have redundant power systems, provided by Landlord for Tenant’s use that consists of the existing UPS system and backup power generation. “Rentable Area (or “RA”) of the Premises”: Approximately 29,343 rentable square feet.
Redundant Power. Building K is equipped with redundant power systems, provided by Landlord for Tenant’s use that consists of the existing UPS system and backup power generation. Tenant, at no additional charge to Tenant, shall have the right to use their proportionate share (based on rentable square feet leased in the Building) of the redundant backup power systems in the Building.

Related to Redundant Power

  • relevant power means any power, whether exercisable by voting or otherwise and whether excisable alone or in association with others-

  • redundant means being no longer required by an employer to continue doing a job because, for a reason that is not a usual reason for change in the employer's work-force, the employer has decided that the job will not be done by any person.

  • Market power means the ability to impose on customers a sustained price for a product or service above the price that would prevail in a competitive market.

  • net power means the power obtained on a test bench at the end of the crankshaft or its equivalent at the corresponding engine speed with the auxiliaries and equipment listed in Table 1 of Annex 4 to this Regulation, determined under reference atmospheric conditions;

  • low voltage means the set of nominal voltage levels that are used for the distribution of electricity and whose upper limit is generally accepted to be an a.c. voltage of 1000V ( or a d.c. voltage of 1500 V). [SANS 1019]

  • High voltage bus means the electrical circuit, including the coupling system for charging the REESS, that operates on a high voltage.

  • Generator means a device that produces electricity.

  • Transit Passenger means a passenger who arrives at the airport in an aircraft and departs from the airport in the same aircraft, where such an aircraft is operating a through flight transiting the airport, and includes a passenger in transit through the airport who has to depart in a substituted aircraft because the aircraft on which the passenger arrived has been declared unserviceable.

  • high voltage means the classification of an electric component or circuit, if its working voltage is > 60 V and ≤ 1500 V DC or > 30 V and ≤ 1000 V AC root mean square (rms).

  • Power boiler means a boiler in which steam or other vapor is generated at a pressure of more than 15 psig for use external to itself or a boiler in which water is heated and intended for operation at pressures in excess of 160 psig and/or temperatures in excess of 250 degrees F by the direct application of energy from the combustion of fuels or from electricity, solar or nuclear energy.

  • Combustion turbine means an enclosed fossil or other fuel-fired device that is comprised of a compressor, a combustor, and a turbine, and in which the flue gas resulting from the combustion of fuel in the combustor passes through the turbine, rotating the turbine.

  • Fuel means any solid, liquid or gaseous combustible material;

  • Electric power generator means an entity that proposes to

  • voltage means the root-mean-square value of electrical potential between two conductors.

  • Potential electrical output capacity means, with regard to a unit, 33 per- cent of the maximum design heat input of the unit.

  • Station Power means energy used for operating the electric equipment on the site of a generation facility located in the PJM Region or for the heating, lighting, air-conditioning and office equipment needs of buildings on the site of such a generation facility that are used in the operation, maintenance, or repair of the facility. Station Power does not include any energy (i) used to power synchronous condensers; (ii) used for pumping at a pumped storage facility; (iii) used in association with restoration or black start service; or (iv) that is Direct Charging Energy.

  • Capacity Interconnection Rights means the rights to input generation as a Generation Capacity Resource into the Transmission System at the Point of Interconnection where the generating facilities connect to the Transmission System.

  • Repower means to replace an existing engine with a newer, cleaner engine or power source that is certified by EPA and, if applicable, CARB, to meet a more stringent set of engine emission standards. Repower includes, but is not limited to, diesel engine replacement with an engine certified for use with diesel or a clean alternate fuel, diesel engine replacement with an electric power source (e.g., grid, battery), diesel engine replacement with a fuel cell, diesel engine replacement with an electric generator(s) (genset), diesel engine upgrades in Ferries/Tugs with an EPA Certified Remanufacture System, and/or diesel engine upgrades in Ferries/Tugs with an EPA Verified Engine Upgrade. All-Electric and fuel cell Repowers do not require EPA or CARB certification.

  • Electrical Fitter means an employee who is mainly employed in the workshops manufacturing, fitting, and repairing electrical instruments, machines, and apparatus. Electrical fitting in this definition shall include armature and transformer winding, and people solely engaged in making and repairing instruments. The legitimate possession of a certificate of competency in this particular class of work issued by the Electrical Licensing Board under the Electricity Act 1994 shall be recognised as proof of efficiency.

  • Generator Forced Outage means an immediate reduction in output or capacity or removal from service, in whole or in part, of a generating unit by reason of an Emergency or threatened Emergency, unanticipated failure, or other cause beyond the control of the owner or operator of the facility, as specified in the relevant portions of the PJM Manuals. A reduction in output or removal from service of a generating unit in response to changes in market conditions shall not constitute a Generator Forced Outage.

  • Local Interconnection Trunks/Trunk Groups means the trunks that are used for the termination of Local Exchange Traffic, pursuant to iconectiv Technical Reference GR 317-CORE.

  • Generator Maintenance Outage means the scheduled removal from service, in whole or in part, of a generating unit in order to perform necessary repairs on specific components of the facility, if removal of the facility meets the guidelines specified in the PJM Manuals.

  • Fixed wing turbine powered aircraft means an aircraft that:

  • Reactive Power means the power component which does not produce work but is necessary to allow some equipment to operate, and is measured in kiloVolt Amperes Reactive (kVAR);

  • Life-of-the-unit, firm power contractual arrangement means a unit participation power sales agreement under which a utility or industrial customer reserves, or is entitled to receive, a specified amount or percentage of nameplate capacity and associated energy from any specified unit and pays its proportional amount of such unit's total costs, pursuant to a contract:

  • Combined sewer system means a system for conveying both sanitary sewage and storm water runoff.