Test point definition

Test point. , for a meter, means the numerical equivalent of the accuracy variance from norm, with 1 test point equal to a 1% variance (for example, a meter which is between 104.15 and 105.0%) or between 95.0% and 95.9% accurate on test would have 3 test points).
Sample 1Sample 2Sample 3
Test point for a meter, means the numerical equivalent of the accuracy variance from norm, with 1 test point equal to a 1% variance. For example, a meter that
Sample 1

Examples of Test point in a sentence

  • Test point used for test point analysis (TPA), to estimate test effort for system and acceptance tests [15].

  • Test point 2 was to be a two person equivalent load, but due to a software issue over a weekend, the load could only be increased to 17.2 liters per day or a 20% increase in loading.

  • Test point Table (4.6)The number and rates of standard & non standard chlorine sample of Um Al Nasser network during summer season .

  • Test point 17 was taken with the engine off but with support systems (such as the oil pump, etc.) running for a background-noise assessment.

  • Test point 1 in table 2, below, represents a rime icing condition that is typically encountered on transport category airplanes.

  • The report will include the following:• UVOST-CPT and Direct Push Sampling• Test point installation: installation methods, field observations and results of lab testing• Surfactant bench testing• Both pilot test phases including information on LNAPL presence, mobility, and recovery rates under the various test conditions in the saturated zone and dewatered smeared zone• WDR Compliance• Data Evaluation, Conclusions and• Recommendations.

  • The University of Memphis hosted two, one week, GenCyber summer camps for middle and high school students in 2017.

  • Pre-Connection Inspection Before a pre connection inspection takes place, all temporary exchange line connections should be removed at the Network Terminating and Test point.

  • Test point locations The Figures provided in this Annex are intended for information only.

  • The required inputs to run the simulation are: - D-JET model geometry (actual loft) with flow through inlet- D-JET mass, centre of gravity and full inertia tensor at the test point time- Test point airspeed, air density, temperature and dynamic viscosity- Flight controls deflections corresponding to the test point, slightly reduced by a factor determined from static wind tunnel data validation where applicable.

Related to Test point

  • Measurement Point means the emission source for which continuous emission measurement systems (CEMS) are used for emission measurement, or the cross-section of a pipeline system for which the CO2 flow is determined using continuous measurement systems;

  • Meet Point A point, designated by the Parties, at which one Party’s responsibility for service begins and the other Party’s responsibility ends.

  • INTER-CONNECTION POINT/ DELIVERY/ METERING POINT means a single point at 220kV or above, where the power from the Project(s) is injected into the identified ISTS Substation (including the dedicated transmission line connecting the Projects with the substation system) as specified in the RfS document. Metering shall be done at this interconnection point where the power is injected into. For interconnection with grid and metering, the WPDs shall abide by the relevant CERC/ SERC Regulations, Grid Code and Central Electricity Authority (Installation and Operation of Meters) Regulations, 2006 as amended and revised from time to time.

  • Meet-Point Billing (MPB) refers to the billing associated with interconnection of facilities between two or more LECs for the routing of traffic to and from an IXC with which one of the LECs does not have a direct connection. In a multi-bill environment, each Party bills the appropriate tariffed rate for its portion of a jointly provided Switched Exchange Access Service.

  • Meet-Point Billing (MPB means the billing associated with interconnection of facilities between two (2) or more LECs for the routing of traffic to and from an IXC with which one of the LECs does not have a direct connection. In a multi-bill environment, each Party bills the appropriate tariffed rate for its portion of a jointly provided Switched Exchange Access Service.

  • Capacity Storage Resource means any Energy Storage Resource that participates in the Reliability Pricing Model or is otherwise treated as capacity in PJM’s markets such as through a Fixed Resource Requirement Capacity Plan.

  • Interconnection Point means the point(s) of connection(s) at which the project is connected to the grid i.e. it shall be at 11 / 22 kV bus bar level of substation of MSEDCL.

  • Generation Interconnection Customer means an entity that submits an Interconnection Request to interconnect a new generation facility or to increase the capacity of an existing generation facility interconnected with the Transmission System in the PJM Region.

  • Ultra Low Sulfur Diesel Fuel means diesel fuel that has a sulfur content of no more than fifteen parts per million.

  • generating plant means the generating facility described in Schedule 1 as amended from time to time;

  • Connection Point means an exit point or an entry point or a bidirectional point identified or to be identified as such in an access contract.

  • Net metering customer means a customer of the electric distribution company

  • Base Load Generation Resource means a Generation Capacity Resource that operates at least 90 percent of the hours that it is available to operate, as determined by the Office of the Interconnection in accordance with the PJM Manuals.

  • Ethanol blended gasoline means the same as defined in section 214A.1.

  • Generating Facility means the Generating Unit(s) comprising Seller’s power plant, as more particularly described in Section 1.02 and Exhibit B, including all other materials, equipment, systems, structures, features and improvements necessary to produce electric energy and thermal energy, excluding the Site, land rights and interests in land.

  • Metering Point means, for meters that do not use instrument transformers, the point at which the billing meter is connected. For meters that use instrument transformers, the point at which the instrument transformers are connected.

  • Throughput means the measure of production, or factor related to production, used to determine the relationship between the amount of energy used by the target unit and the levels of activity of the target unit, as set out in Schedule 6 to an underlying agreement; “the Tribunal” means the First-tier Tribunal established under the Xxxxxxxx Xxxxxx xxx Xxxxxxxxxxx Xxx 00000;

  • Generation Interconnection Feasibility Study means a study conducted by the Transmission Provider (in coordination with the affected Transmission Owner(s)) in accordance with Tariff, Part IV, section 36.

  • CO2 means carbon dioxide.

  • Gathering System means that portion of Gatherer’s pipeline system, including all appurtenances thereto, related to the provision of gathering and transportation services provided by Gatherer pursuant to this tariff.

  • Surplus Interconnection Customer means either an Interconnection Customer whose Generating Facility is already interconnected to the PJM Transmission System or one of its affiliates, or an unaffiliated entity that submits a Surplus Interconnection Request to utilize Surplus Interconnection Service within the Transmission System in the PJM Region. A Surplus Interconnection Customer is not a New Service Customer.

  • Basic gas supply service means gas supply service that is

  • Tank means an enclosed space which is formed by the permanent structure of a ship and which is designed for the carriage of liquid in bulk.

  • Rechargeable Electrical Energy Storage System (REESS) means the rechargeable energy storage system that provides electric energy for electrical propulsion.

  • Pipelines has the meaning set forth in the Recitals.

  • Attachment point means a point on the network at which network assets are connected to assets owned by another person.