Examples of Test Schedule in a sentence
Incrementally load and unload the micropile as shown in the following table: Proof Load Test Schedule NOTES:AL = alignment load, 0.10SL SL = service loadFTL = factored test loadaMaximum test load 2.
Monitor/Assess/Analyze & Measure the following sub-tier schedules within the IMS: (Material/Equipment procurement, Drawing Release Schedule in support of production, Module Assemble Schedule, Module Erection, Tank Close-Outs, Integrated Shipboard Test Schedule.
The pilots or flight crew shall be appropriately licensed for the particular type of aircraft concerned and competent to conduct the test laid down in the Airworthiness Flight Test Schedule.
The two- year average value is then multiplied by 9.6. This is the factor associated with capital- izing a 15 year value stream at the current real weighted cost of capital of 6.2 percent.Applicants must use a separate schedule to calculate the horizon value for the Rate of Return Test and the Interim Controls Test (Schedule C.5 and D.7, respectively).
The undocumented deviation was from section 5.6, Test Schedule, and stated “to avoid bias in testing of the first analyzers through the sequence, Battelle’s personnel will first conduct the entire test sequence using an analyzer already on hand at Battelle.
The Alternative Continuous Highway Test Schedule may be substituted for the Continuous Highway Test Schedule if the test facility is unable to perform the Continuous Highway Test Schedule.
An Acceptance Test Schedule is a list of Communications Distribution System features and functions, which are to be tested, and descriptions of the tests appropriate to determining the particular characteristic’s acceptability.
The Alternative Continuous Urban Test Schedule may be substituted for the Continuous Urban Test Schedule if the test facility is unable to perform the Continuous Urban Test Schedule.
Incrementally load and unload the micropile as shown in the following table: Verification Load Test Schedule NOTES:AL = alignment load, 0.10SL SL = service loadFTL =factored test loadaMaximum test load 2.
Incrementally load and unload the micropile as shown in the following table: Verification Load Test Schedule NOTES:AL = alignment load, 0.10SL SL = service loadFTL = factored test loadaMaximum test load 2.