Introduction Primjeri odredbi

Introduction. When the boiler reaches the set temperature of the water in it, or the air in the room, where the room thermostat, turns into a resting phase keeping the flame or, originally said „Standby phase“. best example for this type of boiler is its operation at night. The main objective of this phase is to maintain the flame or live coals in the firebox during several hours of standby. It is achieved through periodic turning of both the pellet conveyor and fan in certain periods of time. - At the time when the boiler has reached the set temperature it enters the phase of flame maintenance. After a certain period of time, as determined by the parameter T04 (in minutes) the conveyor starts and fans are activated. During this period it comes to activating of the boiler until it receives the command to start due to the achieved temperature. - The duration of the process of conveyor and fan operations is determined by the parameter t05 (in seconds). - During the process of the start of conveyor operation, its work is determined by period as determined by the parameter CL09 (in seconds) - During the process of maintaining the flames the fanfor primary combustion is switched on with the power which determined by the parameter Uc09. Possible mistakes in the work related to the maintenance phase of the flame: ⮚ Boiler operation, beside the functioning of the phase of flame maintenance, does not have enough pellets for the start and work in normal mode. ⮚ Eliminating the cause of mistake:

Introduction. 1.1 We refer to a Facility Agreement dated 10 December 2021 creating a EUR 400,000,000 term loan facility and made between, amongst others, the Borrower, the Agent and the Original Lenders, ("the Facility Agreement"). 1.2 This Agreement is supplemental to the Facility Agreement, and the Facility Agreement and this Agreement are to be read and construed as a single Agreement. 1.3 In this Agreement, terms used but not otherwise defined herein shall have the meanings ascribed to them in the Facility Agreement.

Introduction. Under this SUPPORT CONTRACT, the SELLER agrees to sell to the BUYER the following PRODUCTS (except equipment fitted by the OEM in SFRY from its own decision):  Supply of PRODUCTS (parts for O and I level of maintenance and technical publication ) which will be required by the BUYER for the Maintenance of the HELICOPTERS.  Supply and repair of engines and their related parts is not covered by this  Supply of INGREDIENTS is not covered by this SUPPORT CONTRACT  Repair & overhaul of PRODUCTS already fitted on the HELICOPTERS or manufactured by SFRY even if the manufacturing license mentioned here above was valid  Training  Technical Assistance The maximum value of purchase orders against this Contract is 400,000.00 EUR per year. This contractual value is not binding upon the BUYER and may be adjusted according to actual requirements and needs. All requests for quotation and purchase orders shall be issued by the BUYER to the SELLER as follows. 3.1. ROUTINE ORDER AS PER SELLER'S PRICE LIST