Additional quantity - other Sample Clauses

Additional quantity - other. (a) Subject to Clauses 2.5 and 4.2(d)(ii), if, at any time after 31 December 2009: (i) Gunns has purchased no less than 90 per cent of the quantity of Pulpwood to which it is entitled under this Contract in each of the preceding two Planning Years; and (ii) either or both: (A) Forestry Tasmania has identified for any reasonable period a quantity of Xxxxxx Log from the Stumpage Zone and Gunns is at that time operating a rotary peeled veneer mill; and (B) Forestry Tasmania has identified for any reasonable period a quantity of Pulpwood from the Stumpage Zone; and (iii) subject to Clause 2.6(b), that additional quantity is not required to meet any of Forestry Tasmania’s contractual obligations or other commitments to Gunns or to any third party, then: (iv) the quantity or quantities to which Clause 4.3(a)(ii) refers will be expressed as a quantity per Planning Year for a defined number of Planning Years commencing on a defined date and referred to in the remainder of this Clause 4.3 as “that additional quantity”; and (v) Forestry Tasmania must offer that additional quantity to Gunns by notice in writing. (b) Subject to Clause 4.3(d), if Gunns notifies Forestry Tasmania in writing within 90 days of the receipt of a notice to which Clause 4.3(a) refers that it will accept that additional quantity, then: (i) the Base Distribution of Pulpwood for the Stumpage Supply Zones will be increased by the relevant amount from the relevant date and for the relevant period; and (ii) in any written notice to which Clause 4.3(a) refers, Forestry Tasmania may inform Gunns of an amount by which the Base Distribution of Pulpwood from the Milldoor Supply Zones will be reduced for each relevant Planning Year, being no more than the amount of that additional quantity for each such Planning Year, and: (A) the Base Distribution of Pulpwood for the Milldoor Supply Zones will be decreased by the relevant amount, if any, from the relevant date and for the relevant period; and (B) the Base Quantity will be increased by the relevant amount, if any, from the relevant date and for the relevant period. (c) For the avoidance of doubt, the Parties acknowledge that the circumstances anticipated by Clause 4.3(a)(ii) may arise: (i) as a result of the cessation of the operation of a mill or xxxxx in Tasmania that is or are operating at the date of this Contract; or (ii) as a result of a reduction in the quantity of logs supplied by Forestry Tasmania to a mill or xxxxx in Tasmania, relative to the ...
AutoNDA by SimpleDocs

Related to Additional quantity - other

  • ESTIMATED / SPECIFIC QUANTITY CONTRACTS Estimated quantity contracts, also referred to as indefinite delivery / indefinite quantity contracts, are expressly agreed and understood to be made for only the quantities, if any, actually ordered during the Contract term. No guarantee of any quantity is implied or given. With respect to any specific quantity stated in the contract, the Commissioner reserves the right after award to order up to 20% more or less (rounded to the next highest whole number) than the specific quantities called for in the Contract. Notwithstanding the foregoing, the Commissioner may purchase greater or lesser percentages of Contract quantities should the Commissioner and Contractor so agree. Such agreement may include an equitable price adjustment.

  • QUANTITY BASIS OF CONTRACT – NO GUARANTEED QUANTITIES The contract established has no guarantee of any specific quantity and the State is obligated only to buy that quantity which is needed by its agencies.

  • Contract Quantity The Contract Quantity during each Contract Year is the amount set forth in the applicable Contract Year in Section D of the Cover Sheet (“Delivery Term Contract Quantity Schedule”), which amount is inclusive of outages.

  • VARIATION IN QUANTITY The state assumes no liability for commodities produced, processed or shipped in excess of the amount specified herein.

  • MINIMUM ORDER QUANTITY The State makes no commitment to purchase any minimum or maximum quantity, or dollar volume of products from the selected suppliers. Utilization of this agreement will be on an as needed basis by State Agencies and/or Cooperative Participants, Cities, Counties, Schools K-12, Colleges and Universities. The State will award to multiple suppliers; however, the State reserves the right to purchase like and similar products from other suppliers as necessary to meet operational requirements.

  • Quantities The estimated quantities provided by the City are not guaranteed. These quantities are listed for informational purposes only. Quantities vary depending on the demands of the City. Any variations from the estimated quantities shall not entitle the bidder to an adjustment in the unit price or any additional compensation.

  • ESTIMATED QUANTITIES 1.1 The quantities set forth in the line items and specification document are approximate and represent the estimated requirements for the contract period. 1.2 Items listed may or may not be an inclusive requirements for this category. 1.3 Category items not listed, but distributed by bidder are to be referred to as kindred items. Kindred items shall receive the same percentage of discount or pricing structure as items listed in the specification document. 1.4 The unit prices and the extended total prices shall be used as a basis for the evaluation of bids. The actual quantity of materials necessary may be more or less than the estimates listed in the specification document, but the City/County shall be neither obligated nor limited to any specified amount. If possible, the Owners will restrict increases/decreases to 20% of the estimated quantities listed in the specification document.

  • Project Specific Milestones In addition to the milestones stated in Section 212.5 of the Tariff, as applicable, during the term of this ISA, Interconnection Customer shall ensure that it meets each of the following development milestones: 6.1 Substantial Site work completed. On or before December 31, 2020 Interconnection Customer must demonstrate completion of at least 20% of project site construction. At this time, Interconnection Customer must submit to Interconnected Transmission Owner and Transmission Provider initial drawings, certified by a professional engineer, of the Customer Interconnection Facilities. 6.2 Delivery of major electrical equipment. On or before December 31, 2021, Interconnection Customer must demonstrate that all generating units have been delivered to Interconnection Customer’s project site.

  • Bidder Supplied Samples The Commissioner reserves the right to request from the Bidder/Contractor a representative sample(s) of the Product offered at any time prior to or after award of a contract. Unless otherwise instructed, samples shall be furnished within the time specified in the request. Untimely submission of a sample may constitute grounds for rejection of Bid or cancellation of the Contract. Samples must be submitted free of charge and be accompanied by the Bidder’s name and address, any descriptive literature relating to the Product and a statement indicating how and where the sample is to be returned. Where applicable, samples must be properly labeled with the appropriate Bid or Contract reference. A sample may be held by the Commissioner during the entire term of the Contract and for a reasonable period thereafter for comparison with deliveries. At the conclusion of the holding period the sample, where feasible, will be returned as instructed by the Bidder, at the Bidder’s expense and risk. Where the Bidder has failed to fully instruct the Commissioner as to the return of the sample (i.e., mode and place of return, etc.) or refuses to bear the cost of its return, the sample shall become the sole property of the receiving entity at the conclusion of the holding period.

  • TRUNK FORECASTING 57.1. CLEC shall provide forecasts for traffic utilization over trunk groups. Orders for trunks that exceed forecasted quantities for forecasted locations will be accommodated as facilities and/or equipment are available. Sprint shall make all reasonable efforts and cooperate in good faith to develop alternative solutions to accommodate orders when facilities are not available. Company forecast information must be provided by CLEC to Sprint twice a year. The initial trunk forecast meeting should take place soon after the first implementation meeting. A forecast should be provided at or prior to the first implementation meeting. The semi-annual forecasts shall project trunk gain/loss on a monthly basis for the forecast period, and shall include: 57.1.1. Semi-annual forecasted trunk quantities (which include baseline data that reflect actual Tandem and end office Local Interconnection and meet point trunks and Tandem-subtending Local Interconnection end office equivalent trunk requirements) for no more than two years (current plus one year); 57.1.2. The use of Common Language Location Identifier (CLLI-MSG), which are described in Telcordia documents BR 000-000-000 and BR 000-000-000; 57.1.3. Description of major network projects that affect the other Party will be provided in the semi-annual forecasts. Major network projects include but are not limited to trunking or network rearrangements, shifts in anticipated traffic patterns, or other activities by CLEC that are reflected by a significant increase or decrease in trunking demand for the following forecasting period. 57.1.4. Parties shall meet to review and reconcile the forecasts if forecasts vary significantly.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!