Asbestos and Other Hazardous Materials Certification. 1. Contractor shall execute and submit an “Asbestos and Other Hazardous Materials Certification.” This form is attached hereto as Exhibit “I” and must be signed under penalty of perjury and dated prior to commencing work on the Project.
Asbestos and Other Hazardous Materials Certification. Architect shall certify to District, in writing and under penalty of perjury, that, to the best of Architect’s knowledge, information, and belief, no asbestos-containing material or any other material deemed to be hazardous by the state or federal government was specified as a building material in the Contract Documents that Architect prepared for the Projects or used in the construction of the Projects. Architect shall also assist the District in ensuring that contractors provide District with a certification, in writing and under penalty of perjury, that, to the best of the contractors’ knowledge, information, and belief, no asbestos-containing material or any other material deemed to be hazardous by the state or federal government was furnished, installed, or incorporated into the Projects.
Asbestos and Other Hazardous Materials Certification. Contractor shall execute and submit an “Asbestos and Other Hazardous Materials Certification.” This form is attached hereto as Exhibit “H” and must be signed under penalty of perjury and dated prior to commencing work on the Project. Contractor, further, is aware that should asbestos-containing materials be installed by Contractor in violation of this certification, or if removal of asbestos-containing-materials is part of the Project, decontamination and removal will be performed in accordance with the requirements of all applicable laws and will meet the following criteria: Decontamination and removal of work found to contain asbestos or work installed with asbestos- containing equipment shall be done only under the supervision of a qualified consultant, knowledgeable in the field of asbestos abatement and accredited by the Environmental Protection Agency (“EPA”). The asbestos removal contractor shall be an EPA accredited contractor qualified in the removal of asbestos and shall be chosen and approved by the asbestos consultant who shall have sole discretion and final determination in this matter. The asbestos consultant shall be chosen and approved by District which shall have sole discretion and final determination in this matter. The work will not be accepted until asbestos contamination is reduced to levels deemed acceptable by the asbestos consultant. If removal of asbestos-containing materials is part of the Project, the cost of all asbestos removal, including, but not necessarily limited to, the cost of the asbestos removal contractor, the cost of the asbestos consultant, analytical and laboratory fees, time delays, and additional costs that may be incurred by District shall be borne entirely by Contractor. Hold Harmless: Interface of work for the Project with work containing asbestos shall be executed by Contractor at its risk and at its discretion with full knowledge of the currently accepted standards, hazards, risks, and liabilities associated with asbestos work and asbestos-containing products. By execution of the Construction Services Agreement, Contractor acknowledges the above and agrees to the fullest extent permitted by law to hold harmless District, its Board, and each member of the Board, its officers, employees, agents, representatives, including its Architect and assigns, for all asbestos liability which may be associated with this work. Contractor further agrees to instruct its employees with respect to the above-mentioned standards...
